Ferrimagnetic Behavior and Magnetoresistance of Fe/Gd Double Structured Multilayer Films

1991 ◽  
Vol 231 ◽  
Author(s):  
H. Fujimori ◽  
Y. Kamiguchi ◽  
Y. Hayakawa ◽  
K. Takanashi
Keyword(s):  
Magnetic Fields ◽  
Electric Current ◽  
Room Temperature ◽  
Multilayer Films ◽  
The Other ◽  
Compensation Temperature ◽  
Minimum Value ◽  
Layer Magnetization

AbstractWe prepared Fe/Gd double structured multilayer films (DSMLF's). The Fe/Gd DSMLF has a longer period λl, and it is composed of alternate stacking of two types of Fe/Gd submultilayers with a shorter period λs. One type of Fe/Gd submultilayers has dominant Fe layer magnetization, and the other, dominant Gd layer magnetization. λs was varied in the range from 12 to 100Å, keeping λl to about 250Å. The magnetization of Fe/Gd DSMLF's with λs≦36Å shows a spin-flop in magnetic fields lower than 1k0e at room temperature. The compensation temperature Tcomp was found to decrease with increasing λs. Tcomp crosses room temperature at λs=24Å, and then the spinflop field Hsf at room temperature takes a minimum value of the order of a few tens oersteds. Thus, we show that Hsf at room temperature can easily be tuned to a desired value by varying λs. Longitudinal (pl) and transverse (pt) magnetoresistances show a crossover, depending on the angle between directions of the electric current and of the Fe layer magnetization.

Electron microscope studies of the plastic deformation of ternary alloys based on GaAs

1990 ◽  
Vol 48 (4) ◽  
pp. 1120-1120
Author(s):  
R. Haswell ◽  
U. Bangert ◽  
P. Charsley
Keyword(s):  
Plastic Deformation ◽  
Electron Microscope ◽  
Room Temperature ◽  
Stacking Faults ◽  
The Other ◽  
Ternary Alloys ◽  
Dislocation Mobility ◽  
Semiconducting Materials ◽  
Micro Indentation

A knowledge of the behaviour of dislocations in semiconducting materials is essential to the understanding of devices which use them . This work is concerned with dislocations in alloys related to the semiconductor GaAs . Previous work on GaAs has shown that microtwinning occurs on one of the <110> rosette arms after indentation in preference to the other . We have shown that the effect of replacing some of the Ga atoms by Al results in microtwinning in both of the rosette arms.In the work to be reported dislocations in specimens of different compositions of Gax Al(1-x) As and Gax In(1-x) As have been studied by using micro indentation on a (001) face at room temperature . A range of electron microscope techniques have been used to investigate the type of dislocations and stacking faults/microtwins in the rosette arms , which are parallel to the [110] and [10] , as a function of composition for both alloys . Under certain conditions microtwinning occurs in both directions . This will be discussed in terms of the dislocation mobility.

HAYNES STELLITE ALLOY No. 98M2

Alloy Digest ◽  
1960 ◽  
Vol 9 (7) ◽  
Keyword(s):  
Fracture Toughness ◽  
Compressive Strength ◽  
Physical Properties ◽  
Room Temperature ◽  
Base Alloy ◽  
Heat Treating ◽  
The Other ◽  
Stellite Alloy ◽  
Cobalt Base Alloy ◽  
Cobalt Base

Abstract HAYNES STELLITE 98M2 Alloy is a cobalt-base alloy having higher compressive strength and higher hardness than all the other cobalt-base alloys at room temperature and in the red heat range. This datasheet provides information on composition, physical properties, hardness, elasticity, tensile properties, and compressive strength as well as fracture toughness. It also includes information on heat treating, machining, and joining. Filing Code: Co-22. Producer or source: Haynes Stellite Company.

The Reactivity of Different Active Forms of Sodium Carbonate with Respect to Sulfur Dioxide

1992 ◽  
Vol 57 (11) ◽  
pp. 2302-2308
Author(s):  
Karel Mocek ◽  
Erich Lippert ◽  
Emerich Erdös
Keyword(s):  
Thermal Decomposition ◽  
Liquid Phase ◽  
Sulfur Dioxide ◽  
Specific Surface ◽  
Surface Area ◽  
Sodium Carbonate ◽  
Room Temperature ◽  
Active Form ◽  
The Other ◽  
Kinetics Of

The kinetics of the reaction of solid sodium carbonate with sulfur dioxide depends on the microstructure of the solid, which in turn is affected by the way and conditions of its preparation. The active form, analogous to that obtained by thermal decomposition of NaHCO3, emerges from the dehydration of Na2CO3 . 10 H2O in a vacuum or its weathering in air at room temperature. The two active forms are porous and have approximately the same specific surface area. Partial hydration of the active Na2CO3 in air at room temperature followed by thermal dehydration does not bring about a significant decrease in reactivity. On the other hand, if the preparation of anhydrous Na2CO3 involves, partly or completely, the liquid phase, the reactivity of the product is substantially lower.

scholarly journals Synthesis of spiro[dihydropyridine-oxindoles] via three-component reaction of arylamine, isatin and cyclopentane-1,3-dione

2013 ◽  
Vol 9 ◽  
pp. 8-14 ◽  
Author(s):  
Yan Sun ◽  
Jing Sun ◽  
Chao-Guo Yan
Keyword(s):  
Acetic Acid ◽  
Reaction Mechanism ◽  
Room Temperature ◽  
The Other ◽  
Other Hand ◽  
Three Component Reaction ◽  
High Yields

A fast and convenient protocol for the synthesis of novel spiro[dihydropyridine-oxindole] derivatives in satisfactory yields was developed by the three-component reactions of arylamine, isatin and cyclopentane-1,3-dione in acetic acid at room temperature. On the other hand the condensation of isatin with two equivalents of cyclopentane-1,3-dione gave 3,3-bis(2-hydroxy-5-oxo-cyclopent-1-enyl)oxindole in high yields. The reaction mechanism and substrate scope of this novel reaction is briefly discussed.

On the Chemistry of Tetrabenzyl Thiuram Disulfide and Tetramethyl Thiuram Disulfide with Bis (Triethoxysilylpropyl) Tetrasulfide in Silica Compounds

2003 ◽  
Vol 76 (4) ◽  
pp. 876-891 ◽  
Author(s):  
R. N. Datta ◽  
A. G. Talma ◽  
S. Datta ◽  
P. G. J. Nieuwenhuis ◽  
W. J. Nijenhuis ◽  
...  
Keyword(s):  
High Performance ◽  
Room Temperature ◽  
Succinic Anhydride ◽  
Dynamic Properties ◽  
The Other ◽  
Resonance Spectroscopy ◽  
Reaction Products ◽  
Negative Effect ◽  
Higher Temperature ◽  
Analytical Tools

Abstract The use of thiurams such as Tetramethyl thiuram disulfide (TMTD) or Tetrabenzyl thiuram disulfide (TBzTD) has been explored to achieve higher cure efficiency. The studies suggest that a clear difference exists between the effect of TMTD versus TBzTD. TMTD reacts with Bis (triethoxysilylpropyl) tetrasulfide (TESPT) and this reaction can take place even at room temperature. On the other hand, the reaction of TBzTD with TESPT is slow and takes place only at higher temperature. High Performance Liquid Chromatography (HPLC) with mass (MS) detection, Nuclear Magnetic Resonance Spectroscopy (NMR) and other analytical tools have been used to understand the differences between the reaction of TMTD and TESPT versus TBzTD and TESPT. The reaction products originating from these reactions are also identified. These studies indicate that unlike TMTD, TBzTD improves the cure efficiency allowing faster cure without significant effect on processing characteristics as well as dynamic properties. The loading of TESPT is reduced in a typical Green tire compound and the negative effect on viscosity is repaired by addition of anhydrides, such as succinic anhydride, maleic anhydride, etc.

scholarly journals Recent Observations on the Mechanical Properties of Polymer Networks

1971 ◽  
Vol 44 (5) ◽  
pp. 1256-1272 ◽  
Author(s):  
P. Thirion ◽  
R. Chasset
Keyword(s):  
Crosslink Density ◽  
Room Temperature ◽  
Dynamic Properties ◽  
Polymer Networks ◽  
The Other ◽  
Dilution Ratio ◽  
Chain Entanglement ◽  
Influence Of Temperature ◽  
Terminal Zone ◽  
Crosslinking Agents

Abstract The influence of temperature, elongation, swelling or dilution ratio, crosslink density, nature of the polymers, and crosslinking agents on the dynamic properties, creep and relaxation of polymer networks is surveyed in the terminal region of the spectrum. Whereas the deformation does not change the relaxation kinetics in large ranges of extension, the crosslink density acts as a reduced variable apparently accelerating uniformly the viscoelastic processes beyond the glass transition. The other possible reductions ‘time-temperature’ and ‘time—swelling’ do not necessarily seem related to the variations of free volume. From the viewpoint of the explanation of the relaxation mechanisms in the terminal zone, the fact that the equilibrium of loosely crosslinked elastomers would only virtually be reached after several years at room temperature seem in better agreement with chain entanglement effects, either trapped or not by the permanent network, than with the dissociation of secondary linkages.

Study on Schottky Diode Characteristics Improving by X-Ray Irradiation

2013 ◽  
Vol 717 ◽  
pp. 113-116
Author(s):  
Sani Klinsanit ◽  
Itsara Srithanachai ◽  
Surada Ueamanapong ◽  
Sunya Khunkhao ◽  
Budsara Nararug ◽  
...  
Keyword(s):  
Leakage Current ◽  
Schottky Diode ◽  
Room Temperature ◽  
The Other ◽  
Low Power Consumption ◽  
Initial Value ◽  
X Ray ◽  
Forward Current ◽  
Current Voltage ◽  
Current Voltage Characteristics

The effect of soft X-ray irradiation to the Schottky diode properties was analyzed in this paper. The built-in voltage, leakage current, and work function of Schottky diode were investigated. The current-voltage characteristics of the Schottky diode are measured at room temperature. After irradiation at 70 keV for 55 seconds the forward current and leakage current are increase slightly. On the other hand, the built-in voltage is decrease from the initial value about 0.12 V. Consequently, this method can cause the Schottky diode has low power consumption. The results show that soft X-ray can improve the characteristics of Schottky diode.

Diversification of α–Ketoamides via Transamidation Reactions with Alkyl and Benzyl Amines at Room Temperature

2021 ◽  
Author(s):  
Shweta Singh ◽  
Sureshbabu Popuri ◽  
Qazi Mohammad Junaid ◽  
Sabiah Shahul Hameed ◽  
Jeyakumar Kandasamy
Keyword(s):  
Room Temperature ◽  
The Other ◽  
Alkyl Amines ◽  
Other Hand ◽  
Wide Range

A wide range of N-tosyl α–ketoamides underwent transamidation with various alkyl amines in the absence of catalyst, base, or additives. On the other hand, transamidation in N-Boc α–ketoamides is achieved...

Newly Developed Heat Resistant Magnesium Alloy by Thixomolding®

2005 ◽  
Vol 488-489 ◽  
pp. 287-290 ◽  
Author(s):  
Tadayoshi Tsukeda ◽  
Ken Saito ◽  
Mayumi Suzuki ◽  
Junichi Koike ◽  
Kouichi Maruyama
Keyword(s):  
Aluminum Alloy ◽  
Magnesium Alloy ◽  
Magnesium Alloys ◽  
Room Temperature ◽  
Elevated Temperatures ◽  
Die Casting ◽  
The Other ◽  
Heat Resistant ◽  
Higher Temperature ◽  
Better Than

We compared the newly developed heat resistant magnesium alloy with conventional ones by Thixomolding® and aluminum alloy by die casting. Tensile properties at elevated temperatures of AXEJ6310 were equal to those of ADC12. In particular, elongation tendency of AXEJ6310 at higher temperature was better than those of the other alloys. Creep resistance of AXEJ6310 was larger than that of AE42 by almost 3 orders and smaller than that of ADC12 by almost 2 orders of magnitude. Fatigue limits at room temperature and 423K of AXEJ6310 was superior among conventional magnesium alloys.

Resistive transition broadening in two-phase polycrystalline YBaCuO

1993 ◽  
Vol 8 (5) ◽  
pp. 957-961 ◽  
Author(s):  
J.C. Abele ◽  
R.L. Bristol ◽  
T.C. Nguyen ◽  
M.W. Ohmer ◽  
L.S. Wood
Keyword(s):  
Magnetic Fields ◽  
Computer Models ◽  
Structured Data ◽  
The Other ◽  
Critical Ratio ◽  
Resistive Transition ◽  
Two Phase ◽  
Two Phases

A model proposed by Tinkham1to explain the resistance versus temperature broadening found in highTcsuperconductors in applied magnetic fields is extended to “foot and knee”-structured data taken on polycrystalline YBa2Cu3O6+δ. The proposed extension involves a series combination of two types of superconductors. For this series combination to result, a critical ratio of the two types of superconductors must be met—a result common to both percolation and randomized cellular autonoma theory. This critical ratio is investigated via statistical computer models of a polycrystalline superconductor having two phases of crystallites—one with substantially lowerJcthan the other.

Sign in / Sign up

Export Citation Format

Share Document