Mechanical and structural characterization of uniaxially cold-pressed Fe2Mo powders

2002 ◽  
Vol 17 (8) ◽  
pp. 1954-1959 ◽  
Author(s):  
R. Morales ◽  
S. Seetharaman ◽  
V. Agarwala
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Bragg Peak ◽  
X Ray Diffraction ◽  
Vickers Hardness Number ◽  
X Ray ◽  
Transmission Electron ◽  
Cold Pressed ◽  
Logarithmic Relation

In this work, Fe2Mo intermetallic powder, produced by H2 gas reduction of Fe2MoO4 was characterized by techniques like x-ray diffraction (XRD) and transmission electron microscopy (TEM). The TEM studies confirmed the presence of nano- and microcrystalline grains of Fe2Mo. The above powders when compressed uniaxially showed a logarithmic relation with “relative density”, δr, of the compacts. The multiple compaction mechanisms were analyzed by Kawakita's and Balshin's models. Vickers hardness number, VHN, was found to increase linearly with δr of the compacts. The hardness of Fe2Mo intermetallic when δr = 1 was estimated as 343 VHN. Using Tabor's analysis, the yield strength of Fe2Mo was found to be about 1100 MPa. This value was further confirmed from the details of relative broadening (112) Bragg peak of Fe2Mo obtained from XRD analyses of Fe2Mo at different compaction pressures.

Detonation Synthesis of Nano-Size Materials

1995 ◽  
Vol 418 ◽  
Author(s):  
J. Forbes ◽  
J. Davis ◽  
C. Wong
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Nucleation And Growth ◽  
Detonation Synthesis ◽  
X Ray Diffraction ◽  
Crystalline Materials ◽  
X Ray ◽  
Transmission Electron ◽  
Nano Size

AbstractThe detonation of explosives typically creates 100's of kbar pressures and 1000's K temperatures. These pressures and temperatures last for only a fraction of a microsecond as the products expand. Nucleation and growth of crystalline materials can occur under these conditions. Recovery of these materials is difficult but can occur in some circumstances. This paper describes the detonation synthesis facility, recovery of nano-size diamond, and plans to synthesize other nano-size materials by modifying the chemical composition of explosive compounds. The characterization of nano-size diamonds by transmission electron microscopy and electron diffraction, X-ray diffraction and Raman spectroscopy will also be reported.

Hydrothermal Synthesis and Characterization of BiFeO3 Polyhedral Crystallites

2012 ◽  
Vol 174-177 ◽  
pp. 508-511
Author(s):  
Lin Lin Yang ◽  
Yong Gang Wang ◽  
Yu Jiang Wang ◽  
Xiao Feng Wang
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Synthesis And Characterization ◽  
X Ray Diffraction ◽  
Xrd Pattern ◽  
X Ray ◽  
Transmission Electron ◽  
Scanning Electron

BiFeO3 polyhedrons had been successfully synthesized via a hydrothermal method. The as-prepared products were characterized by power X-ray diffraction (XRD) pattern, scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The possible mechanisms for the formation of BiFeO3 polyhedrons were discussed. Though comparison experiments, it was found that the kind of precursor played a key role on the morphology control of BiFeO3 crystals.

Growth and Characterization of Misostructural Zinc Oxide Tubes

2005 ◽  
Vol 23 ◽  
pp. 293-296
Author(s):  
X.W. Sun ◽  
C.X. Xu ◽  
B.J. Chen ◽  
Y. Yang
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Zinc Oxide ◽  
Growth Process ◽  
Hexagonal Structure ◽  
Metallic Zinc ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron

Zinc oxide (ZnO) microtube has been fabricated by heating the mixture of ZnO and graphite powders in the atmosphere. The ZnO microtubes showed perfect hexagonal profiles with bell-mouth or normal hexagonal tops. Both X-ray diffraction (XRD) and high-resolution transmission electron microscopy (TEM) demonstrated that the product was composed of ZnO with typical hexagonal structure grown predominantly along (002) direction. The growth process was interpreted by means of vaporliquid-solid mechanism combining with the evaporation of metallic zinc.

Preparation and characterization of CuInS2 nanorods and nanotubes from an elemental solvothermal reaction

2001 ◽  
Vol 16 (10) ◽  
pp. 2805-2809 ◽  
Author(s):  
Yang Jiang ◽  
Yue Wu ◽  
Shengwen Yuan ◽  
Bo Xie ◽  
Shuyuan Zhang ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Photoelectron Spectroscopy ◽  
Electron Transfer Reaction ◽  
Solvothermal Reaction ◽  
X Ray Diffraction ◽  
Spectroscopy Analysis ◽  
X Ray ◽  
Transmission Electron

A simple and convenient solvothermal reaction has been developed to produce CuInS2 nanorods and nanotubes from the elements in ethylenediamine at 280 °C. The products were characterized by x-ray diffraction, transmission electron microscopy, high-resolution transmission electron microscopy, scanning electron microscopy, and x-ray photoelectron spectroscopy. Analysis shows that the coordinating ability of ethylenediamine and the existence of liquid In may play important roles in the growth of one-dimension nanocrystallites and the electron-transfer reaction. In addition, spherical CuInS2 micrometer particles were obtained at 350 °C.

Sign in / Sign up

Export Citation Format

Share Document