Celery Electronics

MRS Advances ◽  
2020 ◽  
Vol 5 (16) ◽  
pp. 847-853
Author(s):  
Rhiannon Morris ◽  
Holly Warren ◽  
Marc in het Panhuis

ABSTRACTPlants produce energy in a sustainable way, they are very effective in converting light energy into a useable form. Utilising certain parts of plants in technology could become an efficient way to enhance energy production and improve sustainability. Integrating plants with technology would offer a ‘green’ way of producing elements for electronic circuits and reduce heavy metal waste. In this paper, we demonstrate that conducting polymers can be incorporated into living system such as celery. Electrical impedance analysis was used to establish the conductivity of celery with a conducting polymer (PEDOT:PSS) into its vascular system. It was demonstrated that electronic celery exhibited conductivity values of up to 0.55 ± 0.03 S/cm. This conductivity value was sufficient to demonstrate the potential of celery electronics where celery stalks are used as electrodes in simple circuits.

2006 ◽  
Vol 153 (7) ◽  
pp. C455 ◽  
Author(s):  
A. Arnau ◽  
Y. Jimenez ◽  
R. Fernández ◽  
R. Torres ◽  
M. Otero ◽  
...  

2017 ◽  
Vol 46 (5) ◽  
pp. 1510-1525 ◽  
Author(s):  
Christina O. Baker ◽  
Xinwei Huang ◽  
Wyatt Nelson ◽  
Richard B. Kaner

Nanostructured polyaniline is the key to greater success of this unique conducting polymer.


2019 ◽  
Vol 17 (3) ◽  
pp. 288-294
Author(s):  
Md Akhter Hossain Chowdhury ◽  
Tanzin Chowdhury ◽  
Md Arifur Rahman

Heavy metal accumulation in environmental compartments is a potential risk to the living system because of their uptake by plants and subsequent introduction into the food chain. A study was carried out to investigate the heavy metal contents in industrially contaminated soils collected from six different locations of Dhaka and Mymensingh districts and their effects on two important vegetables namely tomato and cabbage. Pot experiment was conducted using contaminated soils at the net house of Bangladesh Institute of Nuclear Agriculture (BINA), Mymensingh following completely randomized design (CRD) with three replicates. The higher level of heavy metal contents was found in the soil samples of Hajaribag and Dhaka Export Processing Zone (DEPZ). The highest Ni, Cd, Cr, Cu and Fe contents were 59.45, 18.79, 67.57, 40.81 and 1619.61 µg g−1 which were much above the recommended level except Cu contents. The highest yield of vegetables was obtained grown in Maskanda soil of Mymensingh district and the lowest from DEPZ soil of Dhaka. The highest Ni, Cr and Fe contents were 8.91, 7.22, 419.65 µg g−1, respectively in tomato fruits grown in the soil of Hajaribag whereas the highest Cu content (3.38 µg g−1) was obtained from Seedstore soil, Mymensingh and highest Cd content (2.88 µg g−1) was from Mitford ghat soil, Dhaka. In cabbage, the highest Ni (17.52 µg g−1) and Fe (411.25 µg g−1) contents were found in the soils of DEPZ whereas the highest Cr (9.17 µg g−1), Cd (3.52 µg g−1) and Cu (8.51 µg g−1) were obtained in the plants grown in the soils of Hajaribag, Mitford ghat and Maskanda, respectively. Concentrations of all the tested heavy metals except Cu in both vegetables were above the maximum allowable limit prescribed by the World Health Organization. Among the metals, the accumulation of Ni was found as higher amount (0.39 and 0.71 for tomato and cabbage, respectively) based on plant concentration factor or transfer factor. The results showed a positive correlation between concentration of the metals present in soils and in vegetables and the highest correlation was found with Cr in tomato and Fe in cabbage. However, both the soils and grown vegetables were consistently observed to pose a risk to human health. So, it can be recommended that government should take necessary action so that heavy metals used in the industries cannot come into the nearby agricultural field to ensure food safety as well as food security. J Bangladesh Agril Univ 17(3): 288–294, 2019


2015 ◽  
Vol 3 (25) ◽  
pp. 5058-5069 ◽  
Author(s):  
J. A. Goding ◽  
A. D. Gilmour ◽  
P. J. Martens ◽  
L. A. Poole-Warren ◽  
R. A. Green

Scanning electron microscope image of surface morphology of conducting polymer PEDOT doped with bioactive molecules.


2013 ◽  
Vol 448-453 ◽  
pp. 188-191
Author(s):  
Kai Li Zhang ◽  
Li Wei Xie ◽  
Li Hong Huang ◽  
Zong Qiang Zhu ◽  
Liang Liang Tan

Compared with the treatment of heavy metal waste water by bamboo charcoal and modified bamboo charcoal. The mainly types and methods of modified bamboo charcoal adsorption of pollution water is introduced. some important factors that effecting the bamboo charcoal and modified bamboo charcoal adsorption of heavy metal pollution were described in detail, summarizes the desorption method of the specific adsorbent and adsorption mechanism.


RSC Advances ◽  
2016 ◽  
Vol 6 (4) ◽  
pp. 2951-2957 ◽  
Author(s):  
Lu Mao ◽  
Meng Li ◽  
Junmin Xue ◽  
John Wang

Bendable freestanding films composed of reduced graphene oxide and one dimensional conducting polymers exhibit superior capacitive performance in terms of gravimetric capacitance and volumetric capacitance.


Sign in / Sign up

Export Citation Format

Share Document