scholarly journals EFFECT OF THE PILOT CHARGE INJECTION ADVANCE ANGLE ON THE OPERATING PARAMETERS OF A DUAL-FUEL COMPRESSION-IGNITION ENGINE FUELLED WITH BIOGAS

2014 ◽  
Vol 46 (1) ◽  
pp. 125-134
Author(s):  
Sławomir Wierzbicki ◽  
Michał Śmieja ◽  
Andrzej Piętak
Keyword(s):  
Energy Balance ◽  
Engine Speed ◽  
Charge Injection ◽  
Dual Fuel ◽  
Operating Parameters ◽  
Combustion Engines ◽  
Compression Ignition ◽  
Compression Ignition Engine ◽  
Engine Torque ◽  
Gaseous Fuels

One of the ways of increasing the share of renewable fuels in the overall energy balance is to develop effective methods for using low calorific gaseous fuels, including biogas, to fuel combustion engines. This paper presents the results of research on the effect of changing the diesel fuel pilot charge injection advance angle on the operating parameters of a dual-fuel compression-ignition engine. The obtained results confirm the significant effect of the pilot charge injection advance angle on the engine torque value at a constant engine speed.

Effect of Fuel Pilot Dose Parameters on Efficiency of Dual-Fuel Compression Ignition Engines Fuelled with Biogas

2016 ◽  
Vol 817 ◽  
pp. 19-26 ◽  
Author(s):  
Sławomir Wierzbicki ◽  
Michał Śmieja ◽  
Maciej Mikulski
Keyword(s):  
Carbon Dioxide ◽  
Global Warming ◽  
Energy Balance ◽  
Diesel Fuel ◽  
Electrical Energy ◽  
Dual Fuel ◽  
Compression Ignition ◽  
Compression Ignition Engine ◽  
Gaseous Fuels ◽  
Compression Ignition Engines

Increasing the share of renewable electrical energy in the overall energy balance is one of the major challenges of humanity. It is primarily connected with global warming and increasing environmental pollution. One of the ways to counteract this problem is to promote the importance of renewable fuels, including gaseous fuels which are relatively low in carbon.This paper presents the effects of selected parameters of a pilot dose of diesel fuel on the efficiency of a dual-fuel compression ignition engine. The dose of gaseous fuel powering the engine was a mixture of methane and carbon dioxide in varying proportions.

scholarly journals Effect of CO2 content in CNG on the combustion process in a dual-fuel compression ignition engine

2015 ◽  
Vol 162 (3) ◽  
pp. 91-101
Author(s):  
Sławomir WIERZBICKI ◽  
Maciej MIKULSKI ◽  
Michał ŚMIEJA
Keyword(s):  
Combustion Process ◽  
Gaseous Fuel ◽  
Dual Fuel ◽  
Combustion Engines ◽  
Compression Ignition ◽  
Compression Ignition Engine ◽  
Toxic Compounds ◽  
Alternative Sources ◽  
Effective Use ◽  
And Control

Seeking alternative sources of energy for its more effective use, reducing emissions of toxic pollutants to the atmosphere and counteracting global warming are nowadays the major areas of development in the power industry, including the design of combustion engines. Currently, the research into the use of new fuels, which may be effective sources of energy, is performed by many scientific centres. The use of biogas for production of energy in cogeneration systems is one of the ways for improvement of energy balance. In the research described herein, a dual-fuel compression ignition engine was fuelled with gaseous fuel with variable CNG and CO2 ratios. The tests were performed for engine fuelling controlled by both an original controller with the software optimised for single-fuel operation and for the injection of a pilot dose of diesel controlled by a dedicated controller enabling the adjustment and control of the injection and dose parameters. This paper presents the effect of carbon dioxide content in gaseous fuel on the combustion process and emission of toxic compounds in the engine examined.

Characteristics of Particulate Emissions of Compression Ignition Engine Fueled With Biodiesel Derived From Soybean

2007 ◽  
Author(s):  
Myung Yoon Kim ◽  
Seung Hyun Yoon ◽  
Jin Woo Hwang ◽  
Chang Sik Lee
Keyword(s):  
Carbon Monoxide ◽  
Size Distribution ◽  
Diesel Fuel ◽  
Engine Speed ◽  
Particle Mass ◽  
Biodiesel Fuel ◽  
Operating Parameters ◽  
Exhaust Gas ◽  
Compression Ignition ◽  
Compression Ignition Engine

An experimental investigation was performed on the effect of engine speed and EGR (exhaust gas recirculation) on the particle size distribution and exhaust gas emissions in a compression ignition engine fueled with biodiesel derived from soybean. The results obtained by biodiesel fuel were compared to those obtained by petroleum diesel fuel with sulfur contents of 16.3 ppm. The scanning mobility particle sizer (SMPS) was used for size distribution analysis and it measured mobility equivalent particle diameter in the range of 10.4 to 392.4 nm. In addition to the size distribution of the particles, exhaust emissions such as oxides of nitrogen (NOx), hydrocarbon (HC), and carbon monoxide (CO) emissions and combustion characteristics under different engine operating parameters were investigated. The engine operating parameters in terms of engine speed, EGR, injection pressure, and intake pressure were varied to investigate the individual impact of the operating parameters. As the engine speed was increased for the both fuels, the larger size particles which dominantly contributes particle mass was increased, however total numbers of particle were reduced. Comparing to petroleum diesel fuel, the combustion of biodiesel fuel in the engine reduced particle concentration of relatively larger size where most of the particle mass is found. Moreover, dramatically lower hydrocarbon and carbon monoxide emissions were found at the biodiesel fueled engine. However, the NOx emission of biodiesel fueled diesel engine shows slightly higher concentration compared to diesel fuel at the same injection timing.

Analysis of temperature and altitude effects on the Global Energy Balance during WLTC

2021 ◽  
pp. 146808742110342
Author(s):  
Francisco Payri ◽  
Jaime Martín ◽  
Francisco José Arnau ◽  
Sushma Artham
Keyword(s):  
Energy Balance ◽  
Ambient Temperature ◽  
Fuel Consumption ◽  
Experimental Measurements ◽  
Compression Ignition ◽  
Oil Viscosity ◽  
Compression Ignition Engine ◽  
Global Energy ◽  
Global Energy Balance ◽  
L Compression

In this work, the Global Energy Balance (GEB) of a 1.6 L compression ignition engine is analyzed during WLTC using a combination of experimental measurements and simulations, by means of a Virtual Engine. The energy split considers all the relevant energy terms at two starting temperatures (20°C and 7°C) and two altitudes (0 and 1000 m). It is shown that reducing ambient temperature from 20°C to −7°C decreases brake efficiency by 1% and increases fuel consumption by 4%, mainly because of the higher friction due to the higher oil viscosity, while the effect of increasing altitude 1000 m decreases brake efficiency by 0.8% and increases fuel consumption by 2.5% in the WLTC mainly due to the change in pumping. In addition, GEB shows that ambient temperature is affecting exhaust enthalpy by 4.5%, heat rejection to coolant by 2%, and heat accumulated in the block by 2.5%, while altitude does not show any remarkable variations other than pumping and break power.

Mapping the combustion modes of a dual-fuel compression ignition engine

2021 ◽  
pp. 146808742110183
Author(s):  
Jonathan Martin ◽  
André Boehman
Keyword(s):  
Direct Injection ◽  
Fuel Combustion ◽  
Dual Fuel ◽  
Compression Ignition ◽  
Compression Ignition Engine ◽  
Combustion Modes ◽  
Si Engines ◽  
Dual Fuel Combustion ◽  
Soot Emissions ◽  
Ci Engines

Compression-ignition (CI) engines can produce higher thermal efficiency (TE) and thus lower carbon dioxide (CO2) emissions than spark-ignition (SI) engines. Unfortunately, the overall fuel economy of CI engine vehicles is limited by their emissions of nitrogen oxides (NOx) and soot, which must be mitigated with costly, resource- and energy-intensive aftertreatment. NOx and soot could also be mitigated by adding premixed gasoline to complement the conventional, non-premixed direct injection (DI) of diesel fuel in CI engines. Several such “dual-fuel” combustion modes have been introduced in recent years, but these modes are usually studied individually at discrete conditions. This paper introduces a mapping system for dual-fuel CI modes that links together several previously studied modes across a continuous two-dimensional diagram. This system includes the conventional diesel combustion (CDC) and conventional dual-fuel (CDF) modes; the well-explored advanced combustion modes of HCCI, RCCI, PCCI, and PPCI; and a previously discovered but relatively unexplored combustion mode that is herein titled “Piston-split Dual-Fuel Combustion” or PDFC. Tests show that dual-fuel CI engines can simultaneously increase TE and lower NOx and/or soot emissions at high loads through the use of Partial HCCI (PHCCI). At low loads, PHCCI is not possible, but either PDFC or RCCI can be used to further improve NOx and/or soot emissions, albeit at slightly lower TE. These results lead to a “partial dual-fuel” multi-mode strategy of PHCCI at high loads and CDC at low loads, linked together by PDFC. Drive cycle simulations show that this strategy, when tuned to balance NOx and soot reductions, can reduce engine-out CO2 emissions by about 1% while reducing NOx and soot by about 20% each with respect to CDC. This increases emissions of unburnt hydrocarbons (UHC), still in a treatable range (2.0 g/kWh) but five times as high as CDC, requiring changes in aftertreatment strategy.

Sign in / Sign up

Export Citation Format

Share Document