scholarly journals The best one-sided approximation of classes $W^r H^{\omega}$ with regard to point location on the interval

2021 ◽  
Vol 17 ◽  
pp. 99
Author(s):  
A.M. Pasko
Keyword(s):  
Pointwise Approximation ◽  
Point Location ◽  
Better Than

The estimation of the best one-sided pointwise approximation to the classes $W^r H^{\omega}$ with the remainder better than one of the previous estimation is obtained.

Time and Latitude in South Africa

1972 ◽  
Vol 1 ◽  
pp. 27-38
Author(s):  
J. Hers
Keyword(s):  
South Africa ◽  
Cape Town ◽  
Astronomical Observations ◽  
Royal Observatory ◽  
The Republic ◽  
Astronomical Determination ◽  
Limited Accuracy ◽  
Better Than

In South Africa the modern outlook towards time may be said to have started in 1948. Both the two major observatories, The Royal Observatory in Cape Town and the Union Observatory (now known as the Republic Observatory) in Johannesburg had, of course, been involved in the astronomical determination of time almost from their inception, and the Johannesburg Observatory has been responsible for the official time of South Africa since 1908. However the pendulum clocks then in use could not be relied on to provide an accuracy better than about 1/10 second, which was of the same order as that of the astronomical observations. It is doubtful if much use was made of even this limited accuracy outside the two observatories, and although there may – occasionally have been a demand for more accurate time, it was certainly not voiced.

Localization of immunolabels by electron microscopy and image averaging

1983 ◽  
Vol 41 ◽  
pp. 282-283
Author(s):  
J. Frank ◽  
P.-Y. Sizaret ◽  
A. Verschoor ◽  
J. Lamy
Keyword(s):  
Electron Microscopy ◽  
Single Particle ◽  
Attachment Site ◽  
Uranyl Acetate ◽  
Limulus Polyphemus ◽  
Resolution Limit ◽  
Electron Microscopic ◽  
Image Averaging ◽  
Top View ◽  
Better Than

The accuracy with which the attachment site of immunolabels bound to macromolecules may be localized in electron microscopic images can be considerably improved by using single particle averaging. The example studied in this work showed that the accuracy may be better than the resolution limit imposed by negative staining (∽2nm).The structure used for this demonstration was a halfmolecule of Limulus polyphemus (LP) hemocyanin, consisting of 24 subunits grouped into four hexamers. The top view of this structure was previously studied by image averaging and correspondence analysis. It was found to vary according to the flip or flop position of the molecule, and to the stain imbalance between diagonally opposed hexamers (“rocking effect”). These findings have recently been incorporated into a model of the full 8 × 6 molecule.LP hemocyanin contains eight different polypeptides, and antibodies specific for one, LP II, were used. Uranyl acetate was used as stain. A total of 58 molecule images (29 unlabelled, 29 labelled with antl-LPII Fab) showing the top view were digitized in the microdensitometer with a sampling distance of 50μ corresponding to 6.25nm.

Closing the GAP—A 5Å Scanning Microscope

1969 ◽  
Vol 27 ◽  
pp. 6-7
Author(s):  
A. V. Crewe
Keyword(s):  
Normal Form ◽  
The Other ◽  
Resolving Power ◽  
Scanning Microscope ◽  
Conventional Microscope ◽  
Other Hand ◽  
Closing The Gap ◽  
Thermal Sources ◽  
Better Than ◽  
Transmission Microscope

We have become accustomed to differentiating between the scanning microscope and the conventional transmission microscope according to the resolving power which the two instruments offer. The conventional microscope is capable of a point resolution of a few angstroms and line resolutions of periodic objects of about 1Å. On the other hand, the scanning microscope, in its normal form, is not ordinarily capable of a point resolution better than 100Å. Upon examining reasons for the 100Å limitation, it becomes clear that this is based more on tradition than reason, and in particular, it is a condition imposed upon the microscope by adherence to thermal sources of electrons.

Electron Microscopic Observation of the Longitudinal Organization of Poly (p-Phenylene Terephthalamide) Fibers

1982 ◽  
Vol 40 ◽  
pp. 680-681
Author(s):  
Li Li-Sheng ◽  
L.F. Allard ◽  
W.C. Bigelow
Keyword(s):  
Electron Microscopy ◽  
Mechanical Properties ◽  
Scanning Electron Microscopy ◽  
Microscopic Observation ◽  
Electron Microscopic Observation ◽  
Electron Microscopic ◽  
Aromatic Polyamides ◽  
Radial Arrangement ◽  
Scanning Electron ◽  
Better Than

The aromatic polyamides form a class of fibers having mechanical properties which are much better than those of aliphatic polyamides. Currently, the accepted morphology of these fibers as proposed by M.G. Dobb, et al. is a radial arrangement of pleated sheets, with the plane of the pleats parallel to the axis of the fiber. We have recently obtained evidence which supports a different morphology of this type of fiber, using ultramicrotomy and ion-thinning techniques to prepare specimens for transmission and scanning electron microscopy.

A High Angle, Double Tilting Cold Stage for the AEI EM7

1974 ◽  
Vol 32 ◽  
pp. 450-451
Author(s):  
P.R. Swann ◽  
A.E. Lloyd
Keyword(s):  
Habit Plane ◽  
Temperature Control ◽  
Tilt Angle ◽  
Cooling System ◽  
Thermal Drift ◽  
High Angle ◽  
Cold Stage ◽  
High Degree ◽  
Better Than

Figure 1 shows the design of a specimen stage used for the in situ observation of phase transformations in the temperature range between ambient and −160°C. The design has the following features a high degree of specimen stability during tilting linear tilt actuation about two orthogonal axes for accurate control of tilt angle read-out high angle tilt range for stereo work and habit plane determination simple, robust construction temperature control of better than ±0.5°C minimum thermal drift and transmission of vibration from the cooling system.

Thermal Considerations in Lens Regulator Systems

1970 ◽  
Vol 28 ◽  
pp. 358-359
Author(s):  
K.C. Newton
Keyword(s):  
Electron Microscope ◽  
Thermal Effects ◽  
Environmental Control ◽  
Reference Networks ◽  
Better Than

Thermal effects in lens regulator systems have become a major problem with the extension of electron microscope resolution capabilities below 5 Angstrom units. Larger columns with immersion lenses and increased accelerating potentials have made solutions more difficult by increasing the power being handled. Environmental control, component choice, and wiring design provide answers, however. Figure 1 indicates with broken lines where thermal problems develop in regulator systemsExtensive environmental control is required in the sampling and reference networks. In each case, stability better than I ppm/min. is required. Components with thermal coefficients satisfactory for these applications without environmental control are either not available or priced prohibitively.

Finding the Right Problems: Some HREM Applications to Interfaces

1984 ◽  
Vol 42 ◽  
pp. 376-379
Author(s):  
D. Cherns
Keyword(s):  
Grain Boundaries ◽  
High Resolution Electron Microscopy ◽  
Boundary Structure ◽  
Atomic Structures ◽  
Grain Boundary Structure ◽  
Resolution Electron ◽  
Point To Point ◽  
The Right ◽  
New Generation ◽  
Better Than

The use of high resolution electron microscopy (HREM) to determine the atomic structure of grain boundaries and interfaces is a topic of great current interest. Grain boundary structure has been considered for many years as central to an understanding of the mechanical and transport properties of materials. Some more recent attention has focussed on the atomic structures of metalsemiconductor interfaces which are believed to control electrical properties of contacts. The atomic structures of interfaces in semiconductor or metal multilayers is an area of growing interest for understanding the unusual electrical or mechanical properties which these new materials possess. However, although the point-to-point resolutions of currently available HREMs, ∼2-3Å, appear sufficient to solve many of these problems, few atomic models of grain boundaries and interfaces have been derived. Moreover, with a new generation of 300-400kV instruments promising resolutions in the 1.6-2.0 Å range, and resolutions better than 1.5Å expected from specialist instruments, it is an appropriate time to consider the usefulness of HREM for interface studies.

Reconstruction of Two-Dimensional Projections of GP 32*I

1981 ◽  
Vol 39 ◽  
pp. 38-39
Author(s):  
H.A. Cohen ◽  
W. Chiu ◽  
J. Hosoda
Keyword(s):  
Electron Microscopy ◽  
Molecular Weight ◽  
Uranyl Acetate ◽  
Distilled Water ◽  
Acetate Solution ◽  
Two Dimensional ◽  
Parent Molecule ◽  
T4 Bacteriophage ◽  
Electron Imaging ◽  
Better Than

GP 32 (molecular weight 35000) is a T4 bacteriophage protein that destabilizes the DNA helix. The fragment GP32*I (77% of the total weight), which destabilizes helices better than does the parent molecule, crystallizes as platelets thin enough for electron diffraction and electron imaging. In this paper we discuss the structure of this protein as revealed in images reconstructed from stained and unstained crystals.Crystals were prepared as previously described. Crystals for electron microscopy were pelleted from the buffer suspension, washed in distilled water, and resuspended in 1% glucose. Two lambda droplets were placed on grids over freshly evaporated carbon, allowed to sit for five minutes, and then were drained. Stained crystals were prepared the same way, except that prior to draining the droplet, two lambda of aqueous 1% uranyl acetate solution were applied for 20 seconds. Micrographs were produced using less than 2 e/Å2 for unstained crystals or less than 8 e/Å2 for stained crystals.

A Newly Designed 650kv Electron Microscope

1968 ◽  
Vol 26 ◽  
pp. 304-305
Author(s):  
K. Shiraishi ◽  
T. Katsuta ◽  
S. Ozasa ◽  
H. Todokoro
Keyword(s):  
Electron Microscope ◽  
High Voltage ◽  
Bright Field Image ◽  
Bright Field ◽  
Push Button ◽  
Condenser Lens ◽  
High Voltage Generator ◽  
Frequency Power ◽  
Better Than ◽  
Illuminating System

We have recently completed a newly designed 650KV electron microscope. An external view of this advanced instrument is shown in Figure 1. A symmetrical Cockcroft-Walton circuit has been adopted as the high voltage generator. The cathode is heated by high frequency power; a battery is not employed. The high voltage stability is better than 1 x 10-5/min.The sectional diagram of the column shown in Figure 2 is 420mm in diameter and 2750mm in height. The illuminating system consists of a double condenser lens and a magnetic alignment device. Dual deflector assemblies for dark and bright field images, selectable by push button, are built beneath the condenser lens. Two selectable stigmator power supplies are also provided for dark and bright field image operation.

Removal of inelastically scattered electrons substantially increases phase contrast on frozen-hydrated molecules

1987 ◽  
Vol 45 ◽  
pp. 652-653
Author(s):  
John P. Langmore ◽  
Brian D. Athey
Keyword(s):  
Electron Diffraction ◽  
Phase Contrast ◽  
Low Dose ◽  
Dark Field ◽  
Biological Structure ◽  
Bright Field ◽  
Low Contrast ◽  
Negative Stain ◽  
The Difference ◽  
Better Than

Although electron diffraction indicates better than 0.3nm preservation of biological structure in vitreous ice, the imaging of molecules in ice is limited by low contrast. Thus, low-dose images of frozen-hydrated molecules have significantly more noise than images of air-dried or negatively-stained molecules. We have addressed the question of the origins of this loss of contrast. One unavoidable effect is the reduction in scattering contrast between a molecule and the background. In effect, the difference in scattering power between a molecule and its background is 2-5 times less in a layer of ice than in vacuum or negative stain. A second, previously unrecognized, effect is the large, incoherent background of inelastic scattering from the ice. This background reduces both scattering and phase contrast by an additional factor of about 3, as shown in this paper. We have used energy filtration on the Zeiss EM902 in order to eliminate this second effect, and also increase scattering contrast in bright-field and dark-field.

Sign in / Sign up

Export Citation Format

Share Document