Possible Negative Value of the Gruneisen Coefficient of Hydrogen in the Pressure Range from 40 to 75 GPa and Temperature Range from 3500 to 7500 K

2018 ◽  
Keyword(s):  
Pressure Range ◽  
Temperature Range ◽  
Grüneisen Coefficient ◽  
Gruneisen Coefficient

Dynamic Viscosity of Compressed Water to 10 Kilobar and Steam to 1500°C

1969 ◽  
Vol 11 (2) ◽  
pp. 189-205 ◽  
Author(s):  
E. A. Bruges ◽  
M. R. Gibson
Keyword(s):  
Gaseous Phase ◽  
Dynamic Viscosity ◽  
Low Temperatures ◽  
Pressure Range ◽  
Low Pressure ◽  
Temperature Range ◽  
Inversion Temperature ◽  
Pressure Steam ◽  
Correlating Equations ◽  
First Time

Equations specifying the dynamic viscosity of compressed water and steam are presented. In the temperature range 0-100cC the location of the inversion locus (mu) is defined for the first time with some precision. The low pressure steam results are re-correlated and a higher inversion temperature is indicated than that previously accepted. From 100 to 600°C values of viscosity are derived up to 3·5 kilobar and between 600 and 1500°C up to 1 kilobar. All the original observations in the gaseous phase have been corrected to a consistent set of densities and deviation plots for all the new correlations are given. Although the equations give values within the tolerances of the International Skeleton Table it is clear that the range and tolerances of the latter could with some advantage be revised to give twice the existing temperature range and over 10 times the existing pressure range at low temperatures. A list of the observations used and their deviations from the correlating equations is available as a separate publication.

scholarly journals Conditions of ore formation of the Aunikskoye F-Be deposit (Western Transbaikal)

2019 ◽  
Vol 61 (1) ◽  
pp. 18-38
Author(s):  
L. B. Damdinova ◽  
B. B. Damdinov ◽  
M. O. Rampilov ◽  
S. V. Kanakin
Keyword(s):  
Pressure Range ◽  
Deposition Process ◽  
Isotopic Signature ◽  
Ore Deposits ◽  
Ore Formation ◽  
Ore Deposit ◽  
Temperature Range ◽  
Main Factors ◽  
Low Solubility

This study examines the compositions of the ore and the ore formation solutions, conditions of formation, and sources of Be mineralization using the Aunikskoye F-Be deposit, which is an integral part of the Western Transbaikal beryllium-bearing provinces, as a representative example. Further, the main factors responsible for the formation of beryllium mineralization were evaluated. The ore deposits are presented by the feldsparic–fluorspar–phenacite–bertrandite metasomatites formed in the carboniferous limestones during their metasomatic alternation with hydrothermal solutions by introducing F, Be, and other associated elements. The formation of early phenacite–fluorspar association occurred in high-fluorite СО2-containing solutions of elevated alkalinity with a salinity of ~10.5%–12% wt eq. NaCl in a temperature range of ~ 370–260 °С at pressures ranging from 1873 to 1248 bar. More recent fluorite and bertrandite deposits were formed by solutions with a salinity of 6.4%–7.7% wt eq. NaCl in a temperature range of ~156 °C–110 °C and a pressure range of 639–427 bar. The examination of the isotopic signature of the ore association minerals confirmed the apocarbonate nature of the main ore deposit and allowed the determination of the magmatogene nature of the ore-forming paleothermal springs, which are the source of subalkaline leucogranites. The primary factors that influenced the formation of the F-Be ore included the reduction of the F activity in solutions because of the binding of Ca and F in fluorite as well as because of the decrease in temperature during the ore deposition process. The elevated alkalinity of the ore-formation solutions resulted in the low solubility of the Be complexes, which caused a relatively low Be content in the ore and a relatively small amount of mineralization in the deposit.

THE COMPRESSIBILITY OF GASES AT HIGH TEMPERATURES: X. XENON IN THE TEMPERATURE RANGE 0° TO 700 °C. AND THE PRESSURE RANGE 8 TO 50 ATMOSPHERES

1955 ◽  
Vol 33 (4) ◽  
pp. 633-636 ◽  
Author(s):  
E. Whalley ◽  
Y. Lupien ◽  
W. G. Schneider
Keyword(s):  
High Temperatures ◽  
Pressure Range ◽  
Virial Coefficients ◽  
Temperature Range ◽  
Temperature And Pressure

The virial coefficients of xenon have been measured in the temperature and pressure range described. The results are compared with previous measurements.

Refractivity of gases and its use in calculating virial coefficients

1958 ◽  
Vol 245 (1242) ◽  
pp. 373-381 ◽  
Keyword(s):  
Refractive Index ◽  
Pressure Range ◽  
Virial Coefficients ◽  
Precision Measurements ◽  
Temperature Range

Precision measurements of the refractive index of ethylene and neo pentane over a pressure range 0 to 1 atm and a temperature range of 25 to 70 °C were made and used to calculate virial coefficients. Some measurements on air and n -hexane are also reported. Certain aspects of the use of the Rayleigh refractometer are discussed.

ON A PLATINUM–RHODIUM – OXYGEN ELECTRODE IN SILICATE MELTS

1965 ◽  
Vol 43 (10) ◽  
pp. 2879-2887 ◽  
Author(s):  
R. E. Ranford ◽  
S. N. Flengas
Keyword(s):  
Oxygen Pressure ◽  
Pressure Range ◽  
Oxygen Electrode ◽  
Silicate Melts ◽  
Cell Potential ◽  
Temperature Range ◽  
Oxide Concentration ◽  
Nickelous Oxide

The potential of the formation cell[Formula: see text]was studied in the temperature range 900 °C to 1 100 °C. The platinum–rhodium – oxygen electrode was found to behave reversibly in the pressure range 5 × 10−3 atm to 1 atm oxygen. The effects on the cell potential of oxygen pressure, nickelous oxide concentration, and temperature, were all found to follow an exact Nernst relationship.

Temperature dependence of saturated vapour pressures of methyl isobutyl ketone, diisobutyl ketone, 1,1-difluorotetrachloroethane, and 1,2-difluorotetrachloroethane

1989 ◽  
Vol 54 (11) ◽  
pp. 2868-2871 ◽  
Author(s):  
Václav Svoboda ◽  
Zdena Adamcová ◽  
Vladimír Kubeš
Keyword(s):  
Temperature Dependence ◽  
Pressure Range ◽  
Methyl Isobutyl Ketone ◽  
Static Method ◽  
Methyl Isobutyl ◽  
Isobutyl Ketone ◽  
Temperature Range ◽  
Saturated Vapour

Temperature dependence of saturated vapour pressures of methyl isobutyl ketone, diisobutyl ketone, 1,1-difluorotetrachloroethane, and 1,2-diflurotetrachloethane was measured. A static method was used, and the measurements were carried out in the temperature range of 261 to 353 K and in the pressure range of 0.5-49 kPa.

Sign in / Sign up

Export Citation Format

Share Document