Cyclic Stress-Strain Behavior of Inconel 718

2009 ◽  
pp. 269-269-15 ◽  
Author(s):  
TS Cook
Keyword(s):  
Inconel 718 ◽  
Cyclic Stress ◽  
Stress Strain ◽  
Strain Behavior

Effect of Rε on Cyclic Stress-Strain Behavior of Inconel 718

1985 ◽  
Vol 13 (6) ◽  
pp. 434 ◽  
Author(s):  
AS Kleinberg ◽  
B Grugan ◽  
K Greene ◽  
B Benzing ◽  
JR Schroeder ◽  
...  
Keyword(s):  
Inconel 718 ◽  
Cyclic Stress ◽  
Stress Strain ◽  
Strain Behavior

Stress-Strain Behavior of Inconel 718 During Low Cycle Fatigue

1982 ◽  
Vol 104 (3) ◽  
pp. 186-191 ◽  
Author(s):  
T. S. Cook
Keyword(s):  
Inconel 718 ◽  
Low Cycle Fatigue ◽  
Cyclic Stress ◽  
Fatigue Tests ◽  
Mean Stress ◽  
Cycle Fatigue ◽  
Stress Strain ◽  
Strain Behavior ◽  
Varied Temperature ◽  
The Mean

In the development of better methods of assessing damage accumulation, one of the requirements is an understanding of the cyclic constitutive behavior of the material. It is known that the cyclic stress-strain behavior is affected by temperature and possibly Rε ratio (εmin/εmax) and that the properties change as cycles are accumulated. This report presents some results, particularly the development of a mean stress in the material, obtained during low cycle fatigue tests of Inconel 718. The tests varied temperature and Rε ratio to determine their effects on the cyclic constitutive relation. Changes in the cyclic stress-strain behavior as a function of cycles were also examined. It was possible to relate the mean stress to either the total or plastic strain ranges for all temperatures. There was sufficient scatter in the data to prevent an unambiguous interpretation of the effect of Rε ratio on the mean stress, however.

Cyclic Stress-Strain Behavior of Reinforcing Steel Including Effect of Buckling

1999 ◽  
Vol 125 (6) ◽  
pp. 605-612 ◽  
Author(s):  
Mario E. Rodriguez ◽  
Juan C. Botero ◽  
Jaime Villa
Keyword(s):  
Cyclic Stress ◽  
Reinforcing Steel ◽  
Stress Strain ◽  
Strain Behavior

Cyclic stress–strain behavior and load sharing in duplex stainless steels: Aspects of modeling and experiments

2007 ◽  
Vol 55 (16) ◽  
pp. 5359-5368 ◽  
Author(s):  
R. Lillbacka ◽  
G. Chai ◽  
M. Ekh ◽  
P. Liu ◽  
E. Johnson ◽  
...  
Keyword(s):  
Stainless Steels ◽  
Load Sharing ◽  
Cyclic Stress ◽  
Duplex Stainless Steels ◽  
Stress Strain ◽  
Strain Behavior ◽  
Modeling And Experiments

Low-Cycle Fatigue Evaluation Using the Weld Master S-N Curve

2006 ◽  
Author(s):  
P. Dong ◽  
Z. Cao ◽  
J. K. Hong
Keyword(s):  
Test Data ◽  
Low Cycle Fatigue ◽  
Strain Curve ◽  
Cyclic Stress ◽  
Structural Stress ◽  
Stress Strain ◽  
Strain Behavior ◽  
Scale Test ◽  
Stress Estimation ◽  
Fatigue Evaluation

In the context of fatigue evaluation in the low-cycle regime, the use of the master S-N curve in conjunction with elastic FE-based structural stress calculations is presented. An elastic pseudo structural stress estimation is introduced by assuming that Neuber’s rule applies in relating structural stress and strain concentration at a weld to the material’s cyclic stress-strain behavior. With the pseudo structural stress procedure, recent sources of recent full scale test data on pipe and vessel welds were analyzed as a validation of the proposed procedure. The estimated fatigue lives versus actual test lives show a reasonable agreement. Finally, the feasibility of using monotonic stress-strain curves as a first approximation is also examined for applications when cyclic stress-strain curve may not be readily found. The analysis results indicate that the life estimations using monotonic stress-strain curves are reasonable, with the recent test data falling within mean ± 2σ, where σ represents the standard deviation of the master S-N curve.

Sign in / Sign up

Export Citation Format

Share Document