Development of Cuttability Abacuses in Abrasive Waterjet Cutting With Regard to Depth of Cut and Roughness of Cut Surfaces

2016 ◽  
Vol 45 (5) ◽  
pp. 20160366 ◽  
Author(s):  
Y. Ozcelik ◽  
İ. C. Engin
Keyword(s):  
Abrasive Waterjet ◽  
Depth Of Cut ◽  
Waterjet Cutting ◽  
Abrasive Waterjet Cutting

scholarly journals Investigation of the process of abrasive waterjet cutting of steels based on numerical simulation

2019 ◽  
Vol 298 ◽  
pp. 00103
Author(s):  
Anton Kurnenkov ◽  
Alexei Shurigin ◽  
Vladimir Glebov
Keyword(s):  
3D Modeling ◽  
Material Model ◽  
Stress Fields ◽  
Abrasive Waterjet ◽  
Depth Of Cut ◽  
Waterjet Cutting ◽  
Abrasive Waterjet Cutting ◽  
Cutting Zone ◽  
Jet Velocities ◽  
Structural Carbon

The paper presents the results of 3D modeling the process of abrasive waterjet cutting of structural carbon and stainless steel workpiece. The Johnson-Cook model is selected as a material model. Distributions of stress fields in the cutting zone are obtained, as well as the dependences of depth of cut on jet traverse rate at jet velocities of 400 ... 700 m / s and dependences of cutting force on jet velocity at jet traverse rates of 100 ... 400 mm / min.

A Focused Review on Enhancing the Abrasive Waterjet Cutting Performance by Using Controlled Nozzle Oscillation

2009 ◽  
Vol 404 ◽  
pp. 33-44 ◽  
Author(s):  
Jun Wang
Keyword(s):  
Process Parameters ◽  
Cutting Performance ◽  
Abrasive Waterjet ◽  
Depth Of Cut ◽  
Waterjet Cutting ◽  
Abrasive Waterjet Cutting ◽  
Engineering Materials ◽  
Awj Cutting ◽  
Cutting Modes ◽  
Selection Of

Increasing the performance of the abrasive waterjet (AWJ) cutting technology for engineering materials is the ultimate aim of research in this field. This paper presents a review on the studies using a controlled nozzle oscillation technique to increase the cutting performance of the AWJ cutting technology and the associated mechanisms primarily based on the work in the author’s laboratory. Primary attention is paid to the discussions of the depth of cut, the effect and selection of process parameters and the advantages by using this technique in both single- and multi-pass cutting modes.

Sign in / Sign up

Export Citation Format

Share Document