Rapid screening for bacterial contamination of blood products Schnellverfahren zum Nachweis bakterieller Kontaminationen bei Blutprodukten

2006 ◽  
Vol 30 (2) ◽  
pp. 91-100
Author(s):  
Isabelle Besson Faure
Author(s):  
Hendrik W. Reesink ◽  
Tamimount Mohammadi ◽  
Rubyn N.I. Pietersz ◽  
Paul H.M. Savelkoul

1971 ◽  
Vol 17 (7) ◽  
pp. 993-1000 ◽  
Author(s):  
A. E. Kelen ◽  
A. E. Hathaway ◽  
D. A. McLeod

A simple and practical method is presented for demonstrating the presence of the Australia/SH antigen and its corresponding antibody in serum specimens, both qualitatively and quantitatively. The method is based on the electronmicroscopic visualization of characteristic aggregates of antigen–antibody complexes formed in the mixture of a serum specimen and the appropriate Australia/SH detector reagent. It involves the use of a microtechnique requiring minute amounts of reagents and provides, as a result of diffusion and filtration through agar gel, partially purified and concentrated preparations, ready for electronmicroscopic examination in less than an hour. The method is highly specific and yields reproducible results. Its sensitivity was found to be greater than that of the crossover electrophoresis test and closely approximates that of the complement fixation test, with the added advantage of not being affected by the "prozone phenomenon." The method can be recommended for use in laboratories equipped with electronmicroscopic facilities to establish a differential diagnosis of viral hepatitis cases, perform rapid screening of blood samples (blood products) for the presence of Australia/SH antigen, and clarify equivocal results obtained by other methods. It is expected that the agar–diffusion–filtration technique will also prove useful, in general, for enhancing the chances of detecting virus particles in suspensions of relatively low virus concentrations.


2013 ◽  
Vol 03 (03) ◽  
pp. 205-209 ◽  
Author(s):  
G. B. Matte Aloysius ◽  
Bazira Joel ◽  
Richard Apecu ◽  
Boum Yap II ◽  
Frederick Byarugaba

1993 ◽  
Vol 21 (1) ◽  
pp. 20-23 ◽  
Author(s):  
T. Gottlieb

Post-transfusion bacterial sepsis is infrequent. It is, however, associated with a high mortality due to septic shock. This reflects the release of endotoxin from gram negative bacteria. Lesser transfusion reactions are usually under-reported. These are frequently caused by gram positive bacteria. Gram positive species such as staphylococci and other skin surface organisms may be cultured from platelets stored at room temperature. Typically, gram negative “psychrophyllic” species which survive storage at 4°C are cultured from stored refrigerated blood implicated in transfusion reactions. These include Yersinia enterocolitica, Pseudomonas fluorescens etc. Bacterial contamination of the blood supply can occur via an endogenous or an exogenous source. Endogenous donor bacteraemia due to Y.enterocolitica may be asymptomatic or may follow an episode of gastroenteritis. Exogenous infections occur through some defect in the usual collection practice. Transfusion-acquired syphilis is now extremely uncommon. In the third world, beside the need for effective screening for viral pathogens, infections with protozoa, in particular plasmodia, trypanosoma and leishmania remain a major obstacle to ensuring safe blood supplies. Prevention of transfusion reactions demands rigorous attention to details of collection, storage, reissuing and infusion of blood products, as well as prompt treatment, testing and reporting of suspected reactions.


Blood ◽  
2012 ◽  
Vol 120 (21) ◽  
pp. 1177-1177
Author(s):  
Moria Shimoni ◽  
Noel Axelrod ◽  
David Nuttman ◽  
Jerome Orlin ◽  
Bruria Shalev

Abstract Abstract 1177 Introduction: Allogeneic blood transfusion is a potential source of infection via a variety of known and unknown transmissible agents. Over the last three decades, pre-transfusion donor screening for viral agents has led to a dramatic reduction in the risk of virally transmitted diseases. Bacterial contamination, on the other hand, has proved more difficult to address and remains the most prevalent transfusion-associated infectious risk. This is especially true for platelet components whose storage conditions (22°C, for up to 5 days, with agitation) facilitate bacterial proliferation throughout the storage period. Reported here are the results of initial testing using a novel, noninvasive, real time, rapid screening device for the detection of bacterial contamination of platelet units. Methods and Results: This detection method is based on measuring absorption of an infrared beam that is transmitted through the gaseous atmosphere above the platelets. Living microorganisms produce metabolic gases such as carbon dioxide (CO2) during respiration. By means of infrared absorption the concentration of metabolic gases can be measured inside the platelet storage bag. The methodology consists of an apparatus which uses a tunable monochromatic mid-IR light source, IR detector and electronic signal processor. The light source emits light in frequency range overlapping at least with one absorption line of CO2gas. Use of the tunable light source allows the determination of metabolic gas concentration within the container without etalon use. In this method, the light from the light source is transmitted through the gaseous part of storage bag is measured by means of an IR detector. The concentration of CO2gas inside the platelet bag is determined by equilibrium conditions between the release rate and the rate of diffusion of the metabolic gases through the bag walls. Staphylococcus epidermidis obtained from the American Type Culture Collection (ATCC) were used to contaminate platelets bags. The bacterially inoculated apheresis platelets were agitated at 22°C and measurements were performed using a laser instrument. Each platelet unit was measured before and during bacterial contamination. Samples were taken from each contaminated platelet bag and a standard culture plate count was used for determining bacterial concentration in the platelet medium. Using this device we have succeeded to detect bacterial concentration of above 3*106 CFU/mL staphylococcus epidermidis (Figure 1). Conclusions: Although methods to detect platelet bacterial contamination have received much attention, bacterial contamination of platelet components remains a persistent problem. The methodology described in this report detects staphylococcus epidermidis in apheresis platelet bags. The method allows for testing in real time - at issue or during storage, and it provides immediate results. This device is expected to be successful in detecting most prevalent types of bacteria strains. The test is easy to perform and does not require pre-incubation of samples or handling of the bag's contents. The device is specific and sensitive, allowing bacteria screening, ensuring increased safety of platelet transfusions. The device is able to detect bacteria in platelets, and other blood constituents, through the storage bag, without contacting, harming, or handling the bag's contents. Since there is no direct interaction of the laser light beam with the platelet media and the laser power is low (approximately 10 mW) thermal effects are avoided. By allowing real-time, sensitive detection of bacterial contamination of platelet products, wastage can be reduced, platelet shortage can be alleviated and the adverse outcomes associated with platelet transfusion contamination can be prevented. Further studies are required to evaluate the sensitivity limits for the detection of other bacterial strains that have been reported to contaminate platelet products. Disclosures: No relevant conflicts of interest to declare.


2001 ◽  
Vol 16 (4) ◽  
pp. 192-201 ◽  
Author(s):  
N.D. Depcik-Smith ◽  
S.N. Hay ◽  
M.E. Brecher

2000 ◽  
Vol 23 (1) ◽  
pp. 17-19 ◽  
Author(s):  
Mindy Goldman ◽  
Graham Sher ◽  
Morris Blajchman

Sign in / Sign up

Export Citation Format

Share Document