scholarly journals Streamer propagation in a non-uniform electric field under lightning impulse in short gaps insulated with natural ester and mineral oil

2016 ◽  
Vol 64 (1) ◽  
pp. 171-179 ◽  
Author(s):  
P. Rozga

Abstract This article describes the comparative experimental studies on streamer propagation in natural ester and mineral oil under a high voltage lightning impulse. These studies were concentrated around the small electrode gaps and the point-plane electrode arrangement. The spatial shapes of the developing streamers, light emission and propagation velocity were analyzed and compared between the two different dielectric liquids. In both of them two streamer propagation modes were registered during the studies performed. Propagation of slow 2nd mode streamers took place below the so-called acceleration voltage while fast 3rd mode streamers developed at acceleration voltage and above. Comparing the streamer shapes corresponding to a given voltage polarity, no visible differences were observed between the liquids tested. Concerning the light emission, higher frequencies of light pulses were registered however in the case of natural ester. The significant differences between both liquids were noticed in the value of the acceleration voltage estimated. In the case of positive polarity streamers started to develop in natural ester as a 3rd mode at lower value of testing voltage than in the case of mineral oil. For negative polarity, within the applied testing voltages, 3rd mode streamers appeared only in natural ester. On this basis, the fundamental conclusion is that natural ester may have a lower ability of preventing the development of fast and energetic 3rd mode streamers, even at small electrode gaps.

Energies ◽  
2018 ◽  
Vol 11 (8) ◽  
pp. 1964 ◽  
Author(s):  
Stephanie Haegele ◽  
Farzaneh Vahidi ◽  
Stefan Tenbohlen ◽  
Kevin Rapp ◽  
Alan Sbravati

Due to the low biodegradability of mineral oil, intense research is conducted to define alternative liquids with comparable dielectric properties. Natural ester liquids are an alternative in focus; they are used increasingly as insulating liquid in distribution and power transformers. The main advantages of natural ester liquids compared to mineral oil are their good biodegradability and mainly high flash and fire points providing better fire safety. The dielectric strength of natural ester liquids is comparable to conventional mineral oil for homogeneous field arrangements. However, many studies showed a reduced dielectric strength for highly inhomogeneous field arrangements. This study investigates at which degree of inhomogeneity differences in breakdown voltage between the two insulating liquids occur. Investigations use lightning impulses with different electrode arrangements representing different field inhomogeneity factors and different gap distances. To ensure comparisons with existing transformer geometries, investigations are application-oriented using a transformer conductor model, which is compared to other studies. Results show significant differences in breakdown voltage from an inhomogeneity factor of 0.1 (highly inhomogeneous field) depending on the gap distance. Larger electrode gaps provide a larger inhomogeneity at which differences in breakdown voltages occur.


Energies ◽  
2021 ◽  
Vol 14 (4) ◽  
pp. 1061
Author(s):  
Huaqiang Li ◽  
Linfeng Xia ◽  
Shengwei Cai ◽  
Zhiqiang Huang ◽  
Jiaqi Li ◽  
...  

Ester liquids are environmentally friendly insulating oils, and they can be used as an alternative to mineral oil in transformers, even though in most countries spills of ester oils must be treated like spills of mineral oil. Furthermore, the breakdown characteristics of ester liquids are worse than those of mineral oils in heterogeneous electric fields. In this paper, we present a comprehensive experimental research on both positive and negative lightning impulse breakdown properties in point-plane geometries with gaps varying from 1 mm to 50 mm. The breakdown voltages and streamer velocities of five kinds of ester liquids, including natural ester, synthetic ester, and three kinds of single component esters have been measured. The results show that the double bonds have no effect on the breakdown voltage of ester liquids. The average streamer velocities of mono-esters are faster than that of other esters under positive polarity, and the breakdown voltages of all esters are close.


2021 ◽  
Vol 9 (9) ◽  
pp. 3052-3057
Author(s):  
Jerzy J. Langer ◽  
Ewelina Frąckowiak

H+LEDs are light emitting devices based on a protonic p–n junction; now with no organic polymers. The unique are non-linear optical effects: collimated light beams and stimulated Raman scattering (SRS), observed while generating intense light pulses.


Energies ◽  
2021 ◽  
Vol 14 (5) ◽  
pp. 1510
Author(s):  
Raymon Antony Raj ◽  
Ravi Samikannu ◽  
Abid Yahya ◽  
Modisa Mosalaosi

Increasing usage of petroleum-based insulating oils in electrical apparatus has led to increase in pollution and, at the same time, the oils adversely affect the life of electrical apparatus. This increases the demand of Mineral Oil (MO), which is on the verge of extinction and leads to conducting tests on natural esters. This work discusses dielectric endurance of Marula Oil (MRO), a natural ester modified using Conductive Nano Particle (CNP) to replace petroleum-based dielectric oils for power transformer applications. The Al2O3 is a CNP that has a melting point of 2072 °C and a low charge relaxation time that allows time to quench free electrons during electrical discharge. Al2O3 is blended with the MRO and Mineral Oil (MO) in different concentrations. The measured dielectric properties are transformed into mathematical equations using the Lagrange interpolation polynomial functions and compared with the predicted values either using Gaussian or Fourier distribution functions. Addition of Al2O3 indicates that 0.75 g/L in MRO has an 80% survival rate and 20% hazard rate compared to MO which has 50% survival rate and 50% hazard rate. Considering the measured or interpolated values and the predicted values, they are used to identify the MRO and MO’s optimum concentration produces better results. The test result confirms the enhancement of the breakdown voltage up to 64%, kinematic viscosity is lowered by up to 40% at 110 °C, and flash/fire points of MRO after Al2O3 treatment enhanced to 14% and 23%. Hence the endurance of Al2O3 in MRO proves to be effective against electrical, physical and thermal stress.


Sign in / Sign up

Export Citation Format

Share Document