scholarly journals Influence of incident angle, anisotropy, and floating distance on aerial imaging resolution

OSA Continuum ◽  
2021 ◽  
Vol 4 (3) ◽  
pp. 865
Author(s):  
Ryota Kakinuma ◽  
Norikazu Kawagishi ◽  
Masaki Yasugi ◽  
Hirotsugu Yamamoto
Keyword(s):  
Incident Angle ◽  
Aerial Imaging ◽  
Imaging Resolution

Contrast in Scanning Images of Thin Crystals

1972 ◽  
Vol 30 ◽  
pp. 520-521
Author(s):  
S. Kimoto ◽  
H. Hashimoto ◽  
S. Takashima ◽  
R. M. Stern ◽  
T. Ichinokawa
Keyword(s):  
Crystal Surface ◽  
Solid Angle ◽  
Incident Angle ◽  
Intensity Variation ◽  
Lattice Defects ◽  
Scanning Microscope ◽  
Electron Detector ◽  
Backscattered Electrons ◽  
Electron Image ◽  
Backscattered Electron

The most well known application of the scanning microscope to the crystals is known as Coates pattern. The contrast of this image depends on the variation of the incident angle of the beam to the crystal surface. The defect in the crystal surface causes to make contrast in normal scanning image with constant incident angle. The intensity variation of the backscattered electrons in the scanning microscopy was calculated for the defect in the crystals by Clarke and Howie. Clarke also observed the defect using a scanning microscope.This paper reports the observation of lattice defects appears in thin crystals through backscattered, secondary and transmitted electron image. As a backscattered electron detector, a p-n junction detector of 0.9 π solid angle has been prepared for JSM-50A. The gain of the detector itself is 1.2 x 104 at 50 kV and the gain of additional AC amplifier using band width 100 Hz ∼ 10 kHz is 106.

Multislice calculations of RHEED patterns from vicinal Si (001)

1993 ◽  
Vol 51 ◽  
pp. 1000-1001
Author(s):  
Scott Lordi
Keyword(s):  
Misorientation Angle ◽  
Incident Angle ◽  
Incident Beam ◽  
Experimental Results ◽  
Bragg Condition ◽  
Vicinal Surfaces ◽  
Kinematic Theory ◽  
Step Edges

Vicinal Si (001) surfaces are interesting because they are good substrates for the growth of III-V semiconductors. Spots in RHEED patterns from vicinal surfaces are split due to scattering from ordered step arrays and this splitting can be used to determine the misorientation angle, using kinematic arguments. Kinematic theory is generally regarded to be inadequate for the calculation of RHEED intensities; however, only a few dynamical RHEED simulations have been attempted for vicinal surfaces. The multislice formulation of Cowley and Moodie with a recently developed edge patching method was used to calculate RHEED patterns from vicinal Si (001) surfaces. The calculated patterns are qualitatively similar to published experimental results and the positions of the split spots quantitatively agree with kinematic calculations.RHEED patterns were calculated for unreconstructed (bulk terminated) Si (001) surfaces misoriented towards [110] ,with an energy of 15 keV, at an incident angle of 36.63 mrad ([004] bragg condition), and a beam azimuth of [110] (perpendicular to the step edges) and the incident beam pointed down the step staircase.

Propagation and Reflection of Plane Waves in a Rotating Magneto-Elastic Fibre-Reinforced Semi Space with Surface Stress

2020 ◽  
Vol 22 (4) ◽  
pp. 939-958
Author(s):  
Indrajit Roy ◽  
D. P. Acharya ◽  
Sourav Acharya
Keyword(s):  
Surface Stress ◽  
Incident Angle ◽  
Plane Waves ◽  
Three Dimensional ◽  
Elastic Fibre ◽  
Amplitude Ratios ◽  
Governing Equations ◽  
Rotation Surface ◽  
Wave Velocities ◽  
Magnetic Field Rotation

AbstractThe present paper investigates the propagation of quasi longitudinal (qLD) and quasi transverse (qTD) waves in a magneto elastic fibre-reinforced rotating semi-infinite medium. Reflections of waves from the flat boundary with surface stress have been studied in details. The governing equations have been used to obtain the polynomial characteristic equation from which qLD and qTD wave velocities are found. It is observed that both the wave velocities depend upon the incident angle. After imposing the appropriate boundary conditions including surface stress the resultant amplitude ratios for the total displacements have been obtained. Numerically simulated results have been depicted graphically by displaying two and three dimensional graphs to highlight the influence of magnetic field, rotation, surface stress and fibre-reinforcing nature of the material medium on the propagation and reflection of plane waves.

Solid Phase Excitation-Emission Matrix Spectroscopy for In-Situ Chemical Analysis of Combustion Aerosols

2020 ◽  
Author(s):  
Gaurav Mahamuni ◽  
Jiayang He ◽  
Jay Rutherford ◽  
Byron Ockerman ◽  
Edmund Seto ◽  
...  
Keyword(s):  
Chemical Analysis ◽  
Cigarette Smoke ◽  
Forest Fires ◽  
Solid Phase ◽  
Incident Angle ◽  
Personal Exposure ◽  
Traffic Emission ◽  
Excitation Emission Matrix ◽  
Internal Excitation

<p>Exposure to combustion generated aerosols such as PM from residential woodburning, forest fires, cigarette smoke, and traffic emission have been linked to adverse health outcomes. It is important to assess the chemical composition of PM to examine personal exposure. Excitation-emission matrix (EEM) spectroscopy has been shown as a sensitive and cost-effective technique for evaluation of combustion PM composition and as a source apportionment tool. However, EEM measurements are hindered by a solvent extraction step and a need for benchtop instrumentation. Here, we present a methodology that eliminates this labor-intensive sample preparation and allows to automate and miniaturize the detection platform. A miniature electrostatic collector deposits PM sample onto transparent polydimethylsiloxane (PDMS) coated substrate, where PAH components are extracted into solid-phase (SP) solvent and analyzed using EEM spectroscopy in-situ. We evaluated external and internal excitation schemes to optimized signal to noise ratio. Analysis of woodsmoke and cigarette smoke samples showed good agreement with liquid extraction EEM spectra. Internal excitation is hindered by fluorescent interference from PDMS at λ<250nm. The external excitation EEM spectra are dependent on the incident angle; ranges of 30-40⁰ and 55-65⁰ showed the best results. The proposed SP-EEM technique can be used for development of miniaturized sensors for chemical analysis of combustion generated PM. </p>

Scattering of Low-Energy (5-12 eV) C2D4•+ Ions from Room-Temperature Carbon Surfaces

2008 ◽  
Vol 73 (6-7) ◽  
pp. 755-770 ◽  
Author(s):  
Andriy Pysanenko ◽  
Ján Žabka ◽  
Zdeněk Herman
Keyword(s):  
Survival Probability ◽  
Room Temperature ◽  
Incident Angle ◽  
Pyrolytic Graphite ◽  
Carbon Surface ◽  
Translational Energy ◽  
Energy Distributions ◽  
Surface Mass ◽  
Fragment Ions ◽  
Product Ions

The scattering of the hydrocarbon radical cation C2D4•+ from room-temperature carbon (highly oriented pyrolytic graphite, HOPG) surface was investigated at low incident energies of 6-12 eV. Mass spectra, angular and translational energy distributions of product ions were measured. From these data, information on processes at surfaces, absolute ion survival probability, and kinematics of the collision was obtained. The projectile ion showed both inelastic, dissociative and reactive scattering, namely the occurrence of H-atom transfer reaction with hydrocarbons present on the room-temperature carbon surface. The absolute survival probability of the ions for the incident angle of 30° (with respect to the surface) decreased from about 1.0% (16 eV) towards zero at incident energies below 10 eV. Estimation of the effective surface mass involved in the collision process led to m(S)eff of about 57 a.m.u. for inelastic non-dissociative collisions of C2D4•+ and of about 115 a.m.u. for fragment ions (C2D3+, C2D2•+) and ions formed in reactive surface collisions (C2D4H+, C2D2H+, contributions to C2D3+ and C2D2•+). This suggested a rather complex interaction between the projectile ion and the hydrocarbon-covered surface during the collision.

scholarly journals Simple design of efficient broadband multifunctional polarization converter for X-band applications

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Thi Kim Thu Nguyen ◽  
Thi Minh Nguyen ◽  
Hong Quang Nguyen ◽  
Thanh Nghia Cao ◽  
Dac Tuyen Le ◽  
...  
Keyword(s):  
Circular Polarization ◽  
Incident Angle ◽  
Polarization Conversion ◽  
Simple Design ◽  
Cross Polarization ◽  
Polarization Converter ◽  
Frequency Bands ◽  
X Band ◽  
Cost Efficient ◽  
Patch Resonators

AbstractA simple design of a broadband multifunctional polarization converter using an anisotropic metasurface for X-band application is proposed. The proposed polarization converter consists of a periodic array of the two-corner-cut square patch resonators based on the FR-4 substrate that achieves both cross-polarization and linear-to-circular polarization conversions. The simulated results show that the polarization converter displays the linear cross-polarization conversion in the frequency range from 8 to 12 GHz with the polarization conversion efficiency above 90%. The efficiency is kept higher than 80% with wide incident angle up to 45°. Moreover, the proposed design achieves the linear-to-circular polarization conversion at two frequency bands of 7.42–7.6 GHz and 13–13.56 GHz. A prototype of the proposed polarization converter is fabricated and measured, showing a good agreement between the measured and simulated results. The proposed polarization converter exhibits excellent performances such as simple structure, multifunctional property, and large cost-efficient bandwidth and wide incident angle insensitivity in the linear cross polarization conversion, which can be useful for X-band applications. Furthermore, this structure can be extended to design broadband polarization converters in other frequency bands.

Visible Light-Driven Micromotor with Incident-Angle-Controlled Motion and Dynamic Collective Behavior

Langmuir ◽  
2021 ◽  
Author(s):  
Yunyu Sun ◽  
Jiwei Jiang ◽  
Guangju Zhang ◽  
Ningning Yuan ◽  
Hui Zhang ◽  
...  
Keyword(s):  
Visible Light ◽  
Collective Behavior ◽  
Incident Angle ◽  
Visible Light Driven ◽  
Controlled Motion

scholarly journals Extraordinary Optical Transmission by Hybrid Phonon–Plasmon Polaritons Using hBN Embedded in Plasmonic Nanoslits

Nanomaterials ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 1567
Author(s):  
Shinpei Ogawa ◽  
Shoichiro Fukushima ◽  
Masaaki Shimatani
Keyword(s):  
Optical Transmission ◽  
Hexagonal Boron Nitride ◽  
Incident Angle ◽  
Optical Filters ◽  
Extraordinary Optical Transmission ◽  
Light Manipulation ◽  
Rigorous Coupled Wave Analysis ◽  
Fabry Perot ◽  
Hyperbolic Dispersion ◽  
Rigorous Coupled Wave

Hexagonal boron nitride (hBN) exhibits natural hyperbolic dispersion in the infrared (IR) wavelength spectrum. In particular, the hybridization of its hyperbolic phonon polaritons (HPPs) and surface plasmon resonances (SPRs) induced by metallic nanostructures is expected to serve as a new platform for novel light manipulation. In this study, the transmission properties of embedded hBN in metallic one-dimensional (1D) nanoslits were theoretically investigated using a rigorous coupled wave analysis method. Extraordinary optical transmission (EOT) was observed in the type-II Reststrahlen band, which was attributed to the hybridization of HPPs in hBN and SPRs in 1D nanoslits. The calculated electric field distributions indicated that the unique Fabry–Pérot-like resonance was induced by the hybridization of HPPs and SPRs in an embedded hBN cavity. The trajectory of the confined light was a zigzag owing to the hyperbolicity of hBN, and its resonance number depended primarily on the aspect ratio of the 1D nanoslit. Such an EOT is also independent of the slit width and incident angle of light. These findings can not only assist in the development of improved strategies for the extreme confinement of IR light but may also be applied to ultrathin optical filters, advanced photodetectors, and optical devices.

Sign in / Sign up

Export Citation Format

Share Document