scholarly journals Measurement of the spectrally-resolved absolute phase difference between orthogonal optical modes using a nonlinear beat signal

2005 ◽  
Vol 13 (22) ◽  
pp. 8913 ◽  
Author(s):  
Anastassia Gosteva ◽  
Markus Haiml ◽  
Ursula Keller
Keyword(s):  
Phase Difference ◽  
Beat Signal ◽  
Absolute Phase ◽  
Optical Modes ◽  
Spectrally Resolved

scholarly journals Linear and nonlinear absolute phase effects in interactions of ulrashort laser pulses with a metal nano-layer or with a thin plasma layer

2007 ◽  
Vol 25 (3) ◽  
pp. 379-390 ◽  
Author(s):  
S. Varró
Keyword(s):  
Laser Pulse ◽  
Phase Difference ◽  
Plasma Layer ◽  
Thin Foil ◽  
Laser Pulses ◽  
Thomson Scattering ◽  
Carrier Envelope Phase ◽  
Absolute Phase ◽  
High Intensity Laser ◽  
Order Of Magnitude

It has been shown that in the scattered radiation, generated by an ultrashort laser pulse impinging on a metal nano-layer, non-oscillatory wakefields appears with a definite sign. The magnitude of these wakefields is proportional to the incoming field strength, and the definite sign of them is governed by the cosine of the carrier-envelope phase difference of the incoming pulse. When we let such a Wakefield excite the electrons of a secondary target (say an electron beam, a metal surface or a gas jet), we can obtain 100 percent modulation in the electron signal in a given direction. This scheme can serve as a basis for the construction of a robust linear carrier-envelope phase difference meter. At relativistic laser intensities, the target is considered as a plasma layer in vacuum produced from a thin foil by a prepulse, which is followed by the main high-intensity laser pulse. The nonlinearities stemming from the relativistic kinematics lead to the appearance of higher-order harmonics in the scattered spectra. In general, the harmonic peaks are downshifted due to the presence of an intensity-dependent factor. This phenomenon is analogous to the famous intensity-dependent frequency shift in the nonlinear Thomson scattering on a single electron. In our analysis, an attention has also been paid to the role of the carrier-envelope phase difference of the incoming few-cycle laser pulse. It is also shown that the spectrum has a long tail where the heights of the peaks vary practically within one order of magnitude forming a quasi-continuum. Fourier synthesizing the components from this plateau region attosecond pulses has obtained.

Design and Implementation of an FFT Phase Difference Measuring Method

2014 ◽  
Vol 530-531 ◽  
pp. 105-108
Author(s):  
Xiong Wei Zhu ◽  
Hui Min Chen
Keyword(s):  
Phase Difference ◽  
Measuring Method ◽  
Beat Signal ◽  
Test Results ◽  
Analog To Digital ◽  
Phase Discrimination ◽  
Analog To Digital Conversion ◽  
Signal Period ◽  
Spectrum Correction ◽  
Data Length

The conventional phase difference measuring methods in the phase shift laser range finder are usually implemented with complex hardware circuits and phase discrimination algorithm. In this paper an FFT phase difference measuring method is designed and implemented based on STM32F407VG microcontroller. This method takes the advantage of the pre-set and fixed frequency of the beat signal by setting the analog-to-digital conversion rate precisely and making the input data length of FFT integral multiples of the beat signal period. In this way spectrum correction is no need. The hardware circuits and phase discrimination algorithm is simplified. The test results show that the phase difference measuring accuracy of 1/12000 is achieved.

A Novel Coordinate Rotation Digital Computer Method for Energy and Latency Saving by Trigonometric Operations Spatial Locality Principle

2019 ◽  
Vol 15 (4) ◽  
pp. 338-350
Author(s):  
Giuseppe Visalli
Keyword(s):  
Total Energy ◽  
Phase Difference ◽  
Energy Budget ◽  
General Purpose ◽  
Vlsi Architectures ◽  
Spatial Locality ◽  
Cycle Simulation ◽  
Absolute Phase ◽  
Significant Area ◽  
Locality Principle

In this work, we propose an approximate and energy-efficient CORDIC method, based on a trigonometric function spatial locality principle derived from benchmarks profiling. Successive sine/cosine computation requests cover more than 50% when the absolute phase difference is at most ten degrees. Consequently, this property suggests an optimized circuit implementation, both iterative or a succession of microrotation modules, where the last CORDIC requires fewer iterations, reducing the latency and the total energy budget at the same precision of two separate and independent instances. Thus, this simple design strategy allows significant area and energy dissipation in general-purpose VLSI architectures, but it introduces also dramatically optimizations in applicationspecific embedded systems used in the area of signal processing and radio frequency communication. In this contribution, we introduce a method, the hardware overhead and the energy budget per single cycle. Simulation results show the total energy saving in considered benchmarks is 40% in pipelined and iterative general purposes CORDIC. Furthermore, our application-specific systems (fast Fourier transform and digital oscillators for radiofrequency down conversions) show remarkable cycle savings when the successive sine/cosine computation requests are more than 70%. Finally, in this work, we extend the proposed approach to whichever phase difference less than 26.56° , as a variable for the second CORDIC number of angle rotations.

An Absolute Phase Estimation Method for Interferometry Imagery

2019 ◽  
Vol 1 (2) ◽  
pp. 14-19
Author(s):  
Sui Ping Lee ◽  
Yee Kit Chan ◽  
Tien Sze Lim
Keyword(s):  
Noise Suppression ◽  
Estimation Method ◽  
Phase Image ◽  
Phase Estimation ◽  
Phase Reconstruction ◽  
Estimation Algorithms ◽  
Absolute Phase ◽  
Filtering Rate ◽  
Interferometric Phase ◽  
Image Performance

Accurate interpretation of interferometric image requires an extremely challenging task based on actual phase reconstruction for incomplete noise observation. In spite of the establishment of comprehensive solutions, until now, a guaranteed means of solution method is yet to exist. The initially observed interferometric image is formed by 2π-periodic phase image that wrapped within (-π, π]. Such inverse problem is further corrupted by noise distortion and leads to the degradation of interferometric image. In order to overcome this, an effective algorithm that enables noise suppression and absolute phase reconstruction of interferometric phase image is proposed. The proposed method incorporates an improved order statistical filter that is able to adjust or vary on its filtering rate by adapting to phase noise level of relevant interferometric image. Performance of proposed method is evaluated and compared with other existing phase estimation algorithms. The comparison is based on a series of computer simulated and real interferometric data images. The experiment results illustrate the effectiveness and competency of the proposed method.

Colloidal Plasmonic Nanostar Antennas with Wide Range Resonance Tunability

2019 ◽  
Author(s):  
Theodoros Tsoulos ◽  
Supriya Atta ◽  
Maureen Lagos ◽  
Michael Beetz ◽  
Philip Batson ◽  
...  
Keyword(s):  
Single Particle ◽  
Structural Complexity ◽  
Field Enhancement ◽  
Hot Electron ◽  
Structure Property ◽  
Plasmon Band ◽  
Gold Nanostars ◽  
Wide Range ◽  
Particle Level ◽  
Spectrally Resolved

<div>Gold nanostars display exceptional field enhancement properties and tunable resonant modes that can be leveraged to create effective imaging tags or phototherapeutic agents, or to design novel hot-electron based photocatalysts. From a fundamental standpoint, they represent important tunable platforms to study the dependence of hot carrier energy and dynamics on plasmon band intensity and position. Toward the realization of these platforms, holistic approaches taking into account both theory and experiments to study the fundamental behavior of these</div><div>particles are needed. Arguably, the intrinsic difficulties underlying this goal stem from the inability to rationally design and effectively synthesize nanoparticles that are sufficiently monodispersed to be employed for corroborations of the theoretical results without the need of single particle experiments. Herein, we report on our concerted computational and experimental effort to design, synthesize, and explain the origin and morphology-dependence of the plasmon modes of a novel gold nanostar system, with an approach that builds upon the well-known plasmon hybridization model. We have synthesized monodispersed samples of gold nanostars with finely tunable morphology employing seed-mediated colloidal protocols, and experimentally observed narrow and spectrally resolved harmonics of the primary surface plasmon resonance mode both at the single particle level (via electron energy loss spectroscopy) and in ensemble (by UV-Vis and ATR-FTIR spectroscopies). Computational results on complex anisotropic gold nanostructures are validated experimentally on samples prepared colloidally, underscoring their importance as ideal testbeds for the study of structure-property relationships in colloidal nanostructures of high structural complexity.</div>

Failure Analysis and Defect Inspection of Electronic Devices by High-Resolution Cathodoluminescence

2017 ◽  
Author(s):  
C. Monachon ◽  
M.S. Zielinski ◽  
D. Gachet ◽  
S. Sonderegger ◽  
S. Muckenhirn ◽  
...  
Keyword(s):  
Failure Analysis ◽  
Electronic Materials ◽  
Electronic Devices ◽  
Optical Emission ◽  
Large Field ◽  
Nanometer Scale ◽  
Defect Analysis ◽  
Defect Inspection ◽  
Spectrally Resolved ◽  
Non Destructive

Abstract Quantitative cathodoluminescence (CL) microscopy is a new optical spectroscopy technique that measures electron beam-induced optical emission over large field of view with a spatial resolution close to that of a scanning electron microscope (SEM). Correlation of surface morphology (SE contrast) with spectrally resolved and highly material composition sensitive CL emission opens a new pathway in non-destructive failure and defect analysis at the nanometer scale. Here we present application of a modern CL microscope in defect and homogeneity metrology, as well as failure analysis in semiconducting electronic materials

Photon Emission Spectral Signatures of AlGaN/GaN HEMT for Functional and Reliability Analysis

2008 ◽  
Author(s):  
Arkadiusz Glowacki ◽  
Christian Boit ◽  
Richard Lossy ◽  
Joachim Würfl
Keyword(s):  
Reliability Analysis ◽  
Gate Voltage ◽  
Near Infrared ◽  
Photon Emission ◽  
Electrical Characterization ◽  
Spectral Signatures ◽  
Operating Modes ◽  
Gan Hemt ◽  
Spectrally Resolved ◽  
Performance Variations

Abstract Non-degraded and degraded AlGaN/GaN HEMT devices have been characterized electrically and investigated in various operating modes using integral and spectrally resolved photon emission (PE). In degraded devices the PE dependence on the gate voltage differs from the non-degraded devices. Various types of dependencies on the gate voltage have been identified when investigating local degradation sites. PE spectroscopy was performed at various bias conditions. For both devices broad spectra have been obtained in a wavelength regime from visible to near-infrared, including local performance variations. Signatures of the degradation have been determined in the electrical characterization, in integral PE distribution and in the PE spectrum.

Sign in / Sign up

Export Citation Format

Share Document