scholarly journals Carrier-assisted differential detection with reduced guard band and high electrical spectral efficiency

2021 ◽  
Author(s):  
Jingchi Li ◽  
Shaohua An ◽  
Honglin Ji ◽  
Xingfeng Li ◽  
William Shieh ◽  
...  
Keyword(s):  
Spectral Efficiency ◽  
Differential Detection ◽  
Guard Band

Differential Detection of Single-Chain and Two-Chain Urokinase-Type Plasminogen Activator by a New Immunoadsorbent-Amidolytic Assay (IAA)

1986 ◽  
Vol 56 (03) ◽  
pp. 407-410 ◽  
Author(s):  
Angelo Corti ◽  
Maria Luisa Nolli ◽  
Giovanni Cassani
Keyword(s):  
Plasminogen Activator ◽  
Carcinoma Cell ◽  
Differential Detection ◽  
Single Chain ◽  
Response Curves ◽  
Type Plasminogen Activator ◽  
Urokinase Type Plasminogen Activator ◽  
Before And After ◽  
Culture Supernatants ◽  
Human Epidermoid Carcinoma

SummaryA new immunoadsorbent-amidolytic assay (IAA) for the specific differential detection of two-chain urokinase-type plasminogen activator (tcu-PA) and its single-chain precursor (scu-PA) in cell culture supernatants has been developed. The assay combines the selectivity of immunoassays with the specificity of enzyme activity assays exploiting both the antigenic and enzymatic properties of the two proteins. tcu-PA and scu-PA are selectively immunoadsorbed on the wells of a microtiterplate coated with the monoclonal antibody 5B4 and tested for enzymatic activity before and after activation by plasmin treatment. Both proteins are determined with similar efficiency since overlapping dose-response curves were obtained in the range between 12.5-200 ng/ml. The assay has been used to determine tcu-PA and scu-PA in A431 human epidermoid carcinoma cell supernatants. The analytical recoveries for tcu-PA and scu-PA added to A431 cell supernatants were 95.2% and 96.9% respectively. The intra- and inter-assay variations (CV) were 5.5% and 9.0% for tcu-PA and 9.7% and 9.8% for scu-PA respectively.

Optical data signals in fiber optic communication links with fading

2019 ◽  
pp. 94-104
Author(s):  
I. Juwiler ◽  
I. Bronfman ◽  
N. Blaunstein
Keyword(s):  
Spectral Efficiency ◽  
Fiber Optic ◽  
Fiber Optic Cable ◽  
Optical Signals ◽  
Dispersion Properties ◽  
Optical Cable ◽  
Time Dispersion ◽  
Communication Links ◽  
Fiber Optic Communication ◽  
Optic Communication

Introduction: This article is based on the recent research work in the field of two subjects: signal data parameters in fiber optic communication links, and dispersive properties of optical signals caused by non-homogeneous material phenomena and multimode propagation of optical signals in such kinds of wired links.Purpose: Studying multimode dispersion by analyzing the propagation of guiding optical waves along a fiber optic cable with various refractive index profiles of the inner optical cable (core) relative to the outer cladding, as well as dispersion properties of a fiber optic cable due to inhomogeneous nature of the cladding along the cable, for two types of signal code sequences transmitted via the cable: return-to-zero and non-return-to-zero ones.Methods: Dispersion properties of multimode propagation inside a fiber optic cable are analyzed with an advanced 3D model of optical wave propagation in a given guiding structure. The effects of multimodal dispersion and material dispersion causing the optical signal delay spread along the cable were investigated analytically and numerically.Results: Time dispersion properties were obtained and graphically illustrated for two kinds of fiber optic structures with different refractive index profiles. The dispersion was caused by multimode (e.g. multi-ray) propagation and by the inhomogeneous nature of the material along the cable. Their effect on the capacity and spectral efficiency of a data signal stream passing through such a guiding optical structure is illustrated for arbitrary refractive indices of the inner (core) and outer (cladding) elements of the optical cable. A new methodology is introduced for finding and evaluating the effects of time dispersion of optical signals propagating in fiber optic structures of various kinds. An algorithm is proposed for estimating the spectral efficiency loss measured in bits per second per Hertz per each kilometer along the cable, for arbitrary presentation of the code signals in the data stream, non-return-to zero or return-to-zero ones. All practical tests are illustrated by MATLAB utility.

Analysis of Optimum Precoding schemes in Millimeter Wave System

2020 ◽  
Vol 13 ◽  
Author(s):  
Divya Singh ◽  
Aasheesh Shukla
Keyword(s):  
Power Consumption ◽  
Millimeter Wave ◽  
Spectral Efficiency ◽  
Phase Shifter ◽  
Phase Shifters ◽  
Achievable Rate ◽  
Wave System ◽  
Digital To Analog Converter ◽  
Hybrid Precoding ◽  
Analog Converter

Background : Millimeter wave technology is the emerging technology in wireless communication due to increased demand for data traffic and its numerous advantages however it suffers from severe attenuation. To mitigate this attenuation, phased antenna arrays are used for unidirectional power distribution. An initial access is needed to make a connection between the base station and users in millimeter wave system. The high complexity and cost can be mitigated by the use of hybrid precoding schemes. Hybrid precoding techniques are developed to reduce the complexity, power consumption and cost by using phase shifters in place of converters. The use of phase shifters also increases the spectral efficiency. Objective: Analysis of Optimum Precoding schemes in Millimeter Wave System. Method: In this paper, the suitability of existing hybrid precoding solutions are explored on the basis of the different algorithms and the architecture to increase the average achievable rate. Previous work done in hybrid precoding is also compared on the basis of the resolution of the phase shifter and digital to analog converter. Results: A comparison of the previous work is done on the basis of different parameters like the resolution of phase shifters, digital to analog converter, amount of power consumption and spectral efficiency. Table 2 shows the average achievable rate of different algorithms at SNR= 0 dB and 5 dB. Table 3 also compares the performance achieved by the hybrid precoder in the fully connected structure with two existing approaches, dynamic subarray structure with and without switch and sub connected or partially connected structure. Table 4 gives the comparative analysis of hybrid precoding with the different resolutions of the phase shifter and DAC. Conclusion: In this paper, some available literature is reviewed and summarized about hybrid precoding in millimeter wave communication. Current solutions of hybrid precoding are also reviewed and compared in terms of their efficiency, power consumption, and effectiveness. The limitations of the existing hybrid precoding algorithms are the selection of group and resolution of phase shifters. The mm wave massive MIMO is only feasible due to hybrid precoding.

Tributary Mapping Multiplexing an Efficient Technique for High Speed Fiber Optic Communication

2018 ◽  
Vol 6 (2) ◽  
Author(s):  
Usman Illahi ◽  
Javed Iqbal ◽  
Muhammad Ismail Sulaiman ◽  
Muhammad Alam ◽  
Mazliham Mohd Su'ud
Keyword(s):  
Spectral Efficiency ◽  
High Speed ◽  
Fiber Optic ◽  
Single Channel ◽  
Efficient Technique ◽  
High Dispersion ◽  
Optical Filtering ◽  
Fiber Optic Communication ◽  
Optic Communication ◽  
Dispersion Tolerance

<p>A novel technique of multiplexing called Tributary Mapping Multiplexing (TMM) is<br />applied to a single channel wavelength division multiplexing system and performance is monitored on the basis of simulation results. To elaborate the performance of TMM in this paper, a 4-User TMM system over single wavelength channel is demonstrated. TMM showed significant tolerance against narrow optical filtering as compared to that of conventional TDM at the rate of 40 Gbit/s. The above calculations are made by optical filter bandwidth and dispersion tolerance that was allowed at minimum. The spectral efficiency achieved by this TMM was 1 b/s/Hz and it was executed by using transmitters and receivers of 10 Gbit/s without polarized multiplexing. The high spectral efficiency, high dispersion tolerance and tolerance against strong optical filtering makes TMM an efficient technique for High<br />Speed Fiber Optic Communication.</p>

scholarly journals Low-complexity beam-domain channel estimation and power allocation in hybrid architecture massive MIMO systems

2019 ◽  
Vol 2019 (1) ◽  
Author(s):  
Xiao Chen ◽  
Zaichen Zhang ◽  
Liang Wu ◽  
Jian Dang
Keyword(s):  
Channel Estimation ◽  
Power Allocation ◽  
Spectral Efficiency ◽  
Communication Systems ◽  
Mimo Systems ◽  
Beam Steering ◽  
Estimation Method ◽  
Low Complexity ◽  
Estimation Accuracy ◽  
Hybrid Architecture

Abstract In this journal, we investigate the beam-domain channel estimation and power allocation in hybrid architecture massive multiple-input and multiple-output (MIMO) communication systems. First, we propose a low-complexity channel estimation method, which utilizes the beam steering vectors achieved from the direction-of-arrival (DOA) estimation and beam gains estimated by low-overhead pilots. Based on the estimated beam information, a purely analog precoding strategy is also designed. Then, the optimal power allocation among multiple beams is derived to maximize spectral efficiency. Finally, simulation results show that the proposed schemes can achieve high channel estimation accuracy and spectral efficiency.

scholarly journals Quasi-Distributed Antenna Selection for Spectral Efficiency Maximization in Subarray Switching XL-MIMO Systems

2021 ◽  
pp. 1-1
Author(s):  
Joao Henrique Inacio De Souza ◽  
Abolfazl Amiri ◽  
Taufik Abrao ◽  
Elisabeth De Carvalho ◽  
Petar Popovski
Keyword(s):  
Spectral Efficiency ◽  
Mimo Systems ◽  
Antenna Selection ◽  
Distributed Antenna ◽  
Selection For
Sign in / Sign up

Export Citation Format

Share Document