scholarly journals Photonics-aided 2 × 2 MIMO wireless terahertz-wave signal transmission system with optical polarization multiplexing

2017 ◽  
Vol 25 (26) ◽  
pp. 33236 ◽  
Author(s):  
Xinying Li ◽  
Jianjun Yu ◽  
Kaihui Wang ◽  
Wen Zhou ◽  
Jiao Zhang
Keyword(s):  
Signal Transmission ◽  
Terahertz Wave ◽  
Transmission System ◽  
Optical Polarization ◽  
Wave Signal ◽  
Polarization Multiplexing

scholarly journals A Filterless Frequency 32-Tupling Photonic Scheme To Generate Sub-Terahertz Wave Signal Enabled By Optical Polarization Modulators

2021 ◽  
Author(s):  
Xinqiao Chen ◽  
Xiaorui Liu ◽  
Zhihan Li
Keyword(s):  
Theoretical Analysis ◽  
Radio Frequency ◽  
Suppression Ratio ◽  
Phase Shifter ◽  
Optical Signal ◽  
Terahertz Wave ◽  
Optical Polarization ◽  
Optical Carrier ◽  
Wave Signal ◽  
Thz Wave

Abstract A novel scheme based on polarization modulators to generate Sub-Terahertz wave (Sub-THz) signal with frequency 32-tupling is proposed. The system consists of two subsystems in cascade, and each subsystem consists of 4 paralleled polarization modulators. In this scheme, by properly controlling two subsystems, an optical signal with optical carrier and ±16th-order optical sidebands is achieved. Next, by adjusting the optical attenuator and optical phase shifter, the optical carrier can be canceled. Finally, the Sub-THz wave with frequency 32-tupling can be obtained after beaten in the photodetector. The results show the ±16th-order optical sideband suppression ratio (OSSR) is derived as 55.7 dB and the radio frequency sideband suppression ratio (RFSSR) of the 32-tupling Sub-THz wave is derived as 43.66 dB, which are consistent with the theoretical analysis very well. Meanwhile, the effects of phase offset, modulation index, and attenuator deviation on suppression ratio are analyzed.

scholarly journals Research and Analysis of Digital Baseband Transmission System Based on MATLAB

2018 ◽  
Vol 1 (1) ◽  
Author(s):  
Chai Jianwen
Keyword(s):  
Signal Transmission ◽  
Digital Signal ◽  
Transmission System ◽  
Simulation Software ◽  
Line Pattern ◽  
Matlab Simulation ◽  
Simulation Process ◽  
Transmission Process ◽  
Baseband Signal ◽  
Digital Baseband

This paper mainly studies the basic concept of baseband transmission of digital signal and the transmission processof digital signal baseband transmission and how to design digital baseband transmission system with MATLABsoftware simulation. This paper fi rst introduces the theoretical basis of this subject, including digital communication,the composition of digital baseband transmission system and digital baseband signal transmission process. Then thepaper introduced the characteristics of digital baseband transmission system, including digital PAM signal powerdensity and common line pattern, and by comparing choosing the fi nal bipolar zero return code. Then we introducedthe MATLAB simulation software. The conditions of the best reception of the digital baseband signal are describedand how the waveform of the baseband signal is observed by an oscilloscope. Finally, according to the basic stepsof simulation process, the simulation process of digital baseband transmission system is realized by MATLABsimulation tool, and the system is analyzed.

Design and Implementation of OFDM Baseband Transmission System Based on CORDIC Algorithm and Pipeline FFT

2012 ◽  
Vol 190-191 ◽  
pp. 962-967
Author(s):  
Jun Yang ◽  
Hong Wei Ding ◽  
Ga Zhao ◽  
Ping Ping Shu
Keyword(s):  
High Speed ◽  
Transmission Rate ◽  
Adaptive Modulation ◽  
Signal Transmission ◽  
Transmission System ◽  
Cordic Algorithm ◽  
Clock Frequency ◽  
Modulation Mode ◽  
Baseband Signal ◽  
High Flexibility

This paper designed an OFDM baseband signal transmission system, which adopted CORDIC algorithm, pipeline organization and high-speed floating-point butterfly unit to complete the customized FFT Processor, and the modulation of the signal was realized by enhancing modulation mode (64-QAM) in the adaptive modulation mode. Meanwhile, due to FPGA technology is reconfigurable and parallel, the signal has a higher transmission rate. The system used FPGA resources reasonably and integrated highly, simplifying the complexity of the system; eventually it was adapted to the EP2C35F672C6 chip of Altera, and can be normally operated in the clock frequency of 100 MHz; At the same time, this system the system has high flexibility and generality, simple structure, and good clutter suppression, so it has a certain application prospects.

Sign in / Sign up

Export Citation Format

Share Document