High-Energy Solid State Raman Laser based on Barium Nitrate crystal for near IR and visible spectral Range.

2001 ◽  
Author(s):  
Chris B. Rawle ◽  
Iain T. McKinnie ◽  
Valerii V. Ter-Mikirtychev ◽  
Weston J. Sandle
Keyword(s):  
Solid State ◽  
Spectral Range ◽  
Raman Laser ◽  
High Energy ◽  
Visible Spectral Range ◽  
Barium Nitrate ◽  
Near Ir

Solid-state barium nitrate Raman laser in the visible region

1997 ◽  
Vol 135 (4-6) ◽  
pp. 273-278 ◽  
Author(s):  
Chuan He ◽  
Thomas H. Chyba
Keyword(s):  
Solid State ◽  
Visible Region ◽  
Raman Laser ◽  
Barium Nitrate

TEM study of amorphization of Cu and Ti foils by cold-rolling

1990 ◽  
Vol 48 (4) ◽  
pp. 146-147
Author(s):  
W. A. Chiou ◽  
N. L. Jeon ◽  
Genbao Xu ◽  
M. Meshii
Keyword(s):  
Solid State ◽  
Cold Rolling ◽  
High Energy ◽  
Rapid Quenching ◽  
Vapor Condensation ◽  
Metallic Alloys ◽  
Solid State Reactions ◽  
High Energy Particle ◽  
Amorphous Metallic Alloys ◽  
Thin Foils

For many years amorphous metallic alloys have been prepared by rapid quenching techniques such as vapor condensation or melt quenching. Recently, solid-state reactions have shown to be an alternative for synthesizing amorphous metallic alloys. While solid-state amorphization by ball milling and high energy particle irradiation have been investigated extensively, the growth of amorphous phase by cold-rolling has been limited. This paper presents a morphological and structural study of amorphization of Cu and Ti foils by rolling.Samples of high purity Cu (99.999%) and Ti (99.99%) foils with a thickness of 0.025 mm were used as starting materials. These thin foils were cut to 5 cm (w) × 10 cm (1), and the surface was cleaned with acetone. A total of twenty alternatively stacked Cu and Ti foils were then rolled. Composite layers following each rolling pass were cleaned with acetone, cut into half and stacked together, and then rolled again.

Results of Spatial Structure of Atmosphere Radiation in a Spectral Range (1.5–2) µm Research

2018 ◽  
pp. 7-13
Author(s):  
Anton M. Mishchenko ◽  
Sergei S. Rachkovsky ◽  
Vladimir A. Smolin ◽  
Igor V . Yakimenko
Keyword(s):  
Spatial Structure ◽  
Unmanned Aerial Vehicle ◽  
Wavelength Range ◽  
Spectral Range ◽  
Near Ir ◽  
Optoelectronic Systems ◽  
Aerial Vehicle

Results of experimental studying radiation spatial structure of atmosphere background nonuniformities and of an unmanned aerial vehicle being the detection object are presented. The question on a possibility of its detection using optoelectronic systems against the background of a cloudy field in the near IR wavelength range is also considered.

Experimental Assessment of the Practical Oxidative Stability of Lithium Thiophosphate Solid Electrolytes

2019 ◽  
Author(s):  
Georg Dewald ◽  
Saneyuki Ohno ◽  
Marvin Kraft ◽  
Raimund Koerver ◽  
Paul Till ◽  
...  
Keyword(s):  
Cyclic Voltammetry ◽  
Solid State ◽  
Oxidative Stability ◽  
Photoelectron Spectroscopy ◽  
Solid Electrolytes ◽  
Stability Limit ◽  
Lithium Ion ◽  
High Energy ◽  
Redox Activity ◽  
Solid State Batteries

<p>All-solid-state batteries are often expected to replace conventional lithium-ion batteries in the future. However, the practical electrochemical and cycling stability of the best-conducting solid electrolytes, i.e. lithium thiophosphates, are still critical issues that prevent long-term stable high-energy cells. In this study, we use <i>stepwise</i><i>cyclic voltammetry </i>to obtain information on the practical oxidative stability limit of Li<sub>10</sub>GeP<sub>2</sub>S<sub>12</sub>, a Li<sub>2</sub>S‑P<sub>2</sub>S<sub>5</sub>glass, as well as the argyrodite Li<sub>6</sub>PS<sub>5</sub>Cl solid electrolytes. We employ indium metal and carbon black as the counter and working electrode, respectively, the latter to increase the interfacial contact area to the electrolyte as compared to the commonly used planar steel electrodes. Using a stepwise increase in the reversal potentials, the onset potential at 25 °C of oxidative decomposition at the electrode-electrolyte interface is identified. X‑ray photoelectron spectroscopy is used to investigate the oxidation of sulfur(-II) in the thiophosphate polyanions to sulfur(0) as the dominant redox process in all electrolytes tested. Our results suggest that after the formation of these decomposition products, significant redox behavior is observed. This explains previously reported redox activity of thiophosphate solid electrolytes, which contributes to the overall cell performance in solid-state batteries. The <i>stepwise cyclic voltammetry</i>approach presented here shows that the practical oxidative stability at 25 °C of thiophosphate solid electrolytes against carbon is kinetically higher than predicted by thermodynamic calculations. The method serves as an efficient guideline for the determination of practical, kinetic stability limits of solid electrolytes. </p>

Experimental Assessment of the Practical Oxidative Stability of Lithium Thiophosphate Solid Electrolytes

2019 ◽  
Author(s):  
Georg Dewald ◽  
Saneyuki Ohno ◽  
Marvin Kraft ◽  
Raimund Koerver ◽  
Paul Till ◽  
...  
Keyword(s):  
Cyclic Voltammetry ◽  
Solid State ◽  
Oxidative Stability ◽  
Photoelectron Spectroscopy ◽  
Solid Electrolytes ◽  
Stability Limit ◽  
Lithium Ion ◽  
High Energy ◽  
Redox Activity ◽  
Solid State Batteries

<p>All-solid-state batteries are often expected to replace conventional lithium-ion batteries in the future. However, the practical electrochemical and cycling stability of the best-conducting solid electrolytes, i.e. lithium thiophosphates, are still critical issues that prevent long-term stable high-energy cells. In this study, we use <i>stepwise</i><i>cyclic voltammetry </i>to obtain information on the practical oxidative stability limit of Li<sub>10</sub>GeP<sub>2</sub>S<sub>12</sub>, a Li<sub>2</sub>S‑P<sub>2</sub>S<sub>5</sub>glass, as well as the argyrodite Li<sub>6</sub>PS<sub>5</sub>Cl solid electrolytes. We employ indium metal and carbon black as the counter and working electrode, respectively, the latter to increase the interfacial contact area to the electrolyte as compared to the commonly used planar steel electrodes. Using a stepwise increase in the reversal potentials, the onset potential at 25 °C of oxidative decomposition at the electrode-electrolyte interface is identified. X‑ray photoelectron spectroscopy is used to investigate the oxidation of sulfur(-II) in the thiophosphate polyanions to sulfur(0) as the dominant redox process in all electrolytes tested. Our results suggest that after the formation of these decomposition products, significant redox behavior is observed. This explains previously reported redox activity of thiophosphate solid electrolytes, which contributes to the overall cell performance in solid-state batteries. The <i>stepwise cyclic voltammetry</i>approach presented here shows that the practical oxidative stability at 25 °C of thiophosphate solid electrolytes against carbon is kinetically higher than predicted by thermodynamic calculations. The method serves as an efficient guideline for the determination of practical, kinetic stability limits of solid electrolytes. </p>

A Solid-State Near-IR Laser for Spin-Exchange Optical Pumping

2020 ◽  
Vol 84 (11) ◽  
pp. 1359-1361
Author(s):  
A. A. Antipov ◽  
A. G. Putilov ◽  
A. V. Osipov ◽  
A. E. Shepelev
Keyword(s):  
Solid State ◽  
Optical Pumping ◽  
Spin Exchange ◽  
Spin Exchange Optical Pumping ◽  
Near Ir ◽  
Ir Laser
Sign in / Sign up

Export Citation Format

Share Document