Selection of a Suitable Reactor Type for Water Desalination and Power Generation in Saudi Arabia

1988 ◽  
Vol 80 (3) ◽  
pp. 392-399 ◽  
Author(s):  
Fahmy M. Hussein
Keyword(s):  
Power Generation ◽  
Saudi Arabia ◽  
Water Desalination ◽  
Reactor Type ◽  
Selection Of

Assessment of the Dietary Intakes of 6- and 12-Month-Old Infants in Saudi Arabia

2017 ◽  
Vol 87 (1-2) ◽  
pp. 37-48
Author(s):  
Riyadh A. Alzaheb ◽  
Norah Alatawi ◽  
Khawla A. Daoud ◽  
Naema Altawil
Keyword(s):  
Vitamin D ◽  
Saudi Arabia ◽  
Age Groups ◽  
Dietary Intakes ◽  
Dietary Survey ◽  
Daily Energy ◽  
Omega 6 ◽  
24 Hour Recall ◽  
Adequate Nutrient ◽  
Selection Of

Abstract.Background: Establishing understanding of infants’ dietary intakes can support interventions to improve their diets and overall health. Because information on the dietary intakes of infants aged ≤12 months in Saudi Arabia is scarce, this study examined the diets of infants aged 6 and 12 months in Saudi Arabia and determined their main dietary sources of total energy and macronutrients. Methods: A crosssectional dietary survey employing a single 24-hour recall was performed between May and December 2015 with a sample of mothers of 278 healthy 6-month-old and 259 12-month-old infants. An analysis of the dietary intake data determined the nutrient intake adequacy and the percentage contributions of foods to energy and macronutrient intakes. Results: The respective mean daily energy intakes of the 6-month-old and 12-month-old infants in the study were 703 kcal and 929 kcal. Both age groups recorded adequate nutrient intakes, with the exception that the 6-month-olds’ mean vitamin D intake fell below the recommended Adequate Intake (AI), and the 12-month-olds’ intakes of omega-6 fatty acids and vitamin D were also below the AI, along with their iron intake which fell short of the Recommended Dietary Allowance (RDA). Conclusion: The data generated here will assist health professionals in planning interventions which aim to improve infants’ diets and to offer guidance to parents on the appropriate selection of food for their infants.

scholarly journals Analysis of measured and calculated counterpart test data in PWR and VVER 1000 simulators

2005 ◽  
Vol 20 (1) ◽  
pp. 3-15 ◽  
Author(s):  
Francesco d’Auria ◽  
Marco Cherubini ◽  
Maria Galassi ◽  
Nikolaus Muellner
Keyword(s):  
Nuclear Power ◽  
Computer Code ◽  
Scaling Analysis ◽  
Behavior Prediction ◽  
Plant Behavior ◽  
Test Methodology ◽  
Qualitative Level ◽  
Reactor Type ◽  
New Phenomena ◽  
Selection Of

This paper presents an over view of the "scaling strategy", in particular the role played by the counter part test methodology. The recent studies dealing with a scaling analysis in light water reactor with special regard to the VVER 1000 Russian reactor type are presented to demonstrate the phenomena important for scaling. The adopted scaling approach is based on the selection of a few characteristic parameters chosen by taking into account their relevance in the behavior of the transient. The adopted computer code used is RELAP5/Mod3.3 and its accuracy has been demonstrated by qualitative and quantitative evaluation. Comparing experimental data, it was found that the investigated facilities showed similar behavior concerning the time trends, and that the same thermal hydraulic phenomena on a qualitative level could be predicted. The main results are: PSB and LOBI main parameters have similar trends. This fact is the confirmation of the validity of the adopted scaling approach and it shows that PWR and VVER reactor type behavior is very similar. No new phenomena occurred during the counter part test, despite the fact that the two facilities had a different lay out, and the already known phenomena were predicted correctly by the code. The code capability and accuracy are scale-independent. Both character is tics are necessary to permit the full scale calculation with the aim of nuclear power plant behavior prediction. .

scholarly journals Selection of inorganic-based fertilizers in forward osmosis for water desalination

2015 ◽  
Vol 4 (2) ◽  
pp. 319-329 ◽  
Author(s):  
Tripti Mishra ◽  
RK Srivastava
Keyword(s):  
Molecular Weight ◽  
Water Flux ◽  
Forward Osmosis ◽  
Direct Application ◽  
Water Desalination ◽  
Performance Ratio ◽  
Low Molecular Weight ◽  
Inorganic Fertilizers ◽  
The Difference ◽  
Selection Of

The current study aims at the selection of an appropriate draw solute for forward osmosis process. Separation and recovery of the draw solute are the major criteria for the selection of draw solute for forward osmosis process. Therefore in this investigation six inorganic fertilizers draws solute were selected. The selections of inorganic fertilizers as draw solute eliminate the need of removal and recovery of draw solute from the final product. The final product water of forward osmosis process has direct application in agricultural as nutrient rich water for irrigation. These inorganic fertilizers were tested based on their water extraction (water flux) capacity. This experimental water flux was compared with the observed water flux. It was noted that the observed water flux is much higher than the attained experimental water flux. The difference of these two fluxes was used to calculate the performance ratio of each selected fertilizer. Highest performance ratio was shown by low molecular weight compound ammonium nitrate (22.73) and potassium chloride (21.03) at 1 M concentration, whereas diammonium phosphate (DAP) which has highest molecular weight among all the selected fertilizer show the lowest performance ratio (10.02) at 2 M concentration. DOI: http://dx.doi.org/10.3126/ije.v4i2.12660 International Journal of Environment Vol.4(2) 2015: 319-329

Rational Selection of Factors of Safety in Reliability-Based Design of Flexible Pavements in Saudi Arabia

1996 ◽  
Vol 1540 (1) ◽  
pp. 39-47 ◽  
Author(s):  
A. Samy Noureldin ◽  
Essam Sharaf ◽  
Abdulrahim Arafah ◽  
Faisal Al-Sugair
Keyword(s):  
Saudi Arabia ◽  
Performance Prediction ◽  
Flexible Pavement ◽  
Pavement Design ◽  
Pavement Performance ◽  
Design Performance ◽  
Reliability Based Design ◽  
Pavement Engineering ◽  
Pavement Performance Prediction ◽  
Selection Of

Explicit applications of reliability in pavement engineering have been of interest to pavement engineers for the last 10 years. Variabilities in parameters affecting pavement design performance result in variability in pavement performance prediction and thus affect the reliability of how long the pavement will last. Rational quantification of those variabilities is essential for incorporating reliability and selecting the proper factors of safety in the pavement design performance process. The prevailing methodology in Saudi Arabia of quantifying the variability in pavement performance due to the variabilities of the parameters affecting that performance is demonstrated. Factors of safety for flexible pavement design at various reliability levels and based on those prevailing variabilities are presented. These factors of safety are recommended for flexible pavement design in Saudi Arabia.

scholarly journals The Prospects for Coal-Fired Power Generation in Saudi Arabia

2015 ◽  
Author(s):  
Walid Matar ◽  
Rodrigo Echeverri ◽  
Axel Pierru
Keyword(s):  
Power Generation ◽  
Saudi Arabia

Decision-making method for evaluating solar desalination options: the case of Saudi Arabia

2019 ◽  
Vol 11 (3) ◽  
pp. 343-356
Author(s):  
Sa'd Shannak ◽  
Malak Alnory
Keyword(s):  
Saudi Arabia ◽  
Solar Energy ◽  
Water Desalination ◽  
Economies Of Scope ◽  
Base Case ◽  
Analysis Model ◽  
Content Type ◽  
Desalination Plants ◽  
The Impact ◽  
Solar Generation

Purpose Solar as an energy source has a massive potential to reduce dependence on fossil fuels in Gulf Countries (GC). One attractive application of solar energy is solar-powered desalination, which is a viable method to produce fresh water. The most significant factor determining the potential deployment of this application is economics. Design/methodology/approach In this study, the classical economic analysis model has been modified to assess the penetration of solar technology to power desalination plants at different periods during the project lifetime. Furthermore, the environmental and financial values were combined to assess the incentive of powering desalination plants with solar energy in Saudi Arabia. Three systems of solar technologies accompanied with water desalination based on technical applicability were modeled and economically analyzed to understand the impact of various design and operation parameters. Findings This study shows that PV-RO is currently more competitive at both market and administrated prices in Saudi Arabia, followed by the MED-CSP system and finally CSP-RO system. CSP-RO system starts to generate positive surplus after 11 years, while the base case shows no positive surplus at all during the entire lifetime. Moreover, the same trend continues to hold with MED-CSP and PV-RO systems. The MED-CSP generates positive surplus after six years and PV-RO after five years only. On average, it takes eight years for a project running based on solar (CAPEX and OPEX) and desalination OPEX to generate positive cash surplus. Originality/value This paper discusses the debate about incentives for renewable energy in GC and the impact of coupling water production and solar generation. Given that there is no analytical framework built earlier, this paper provides an alternative methodology for policy analysis to understand the role of economies of scope to incentivize solar generation. In other words, the authors are investigating options to reduce the total cost of solar production as a result of increasing the number of different goods produced.

Sign in / Sign up

Export Citation Format

Share Document