Study on Tritium Removal Performance by Gas Separation Membrane with Reflux Flow for Tritium Removal System of Fusion Reactor

2005 ◽  
Vol 48 (1) ◽  
pp. 456-459 ◽  
Author(s):  
Yasunori Iwai ◽  
Toshihiko Yamanishi ◽  
Takumi Hayashi ◽  
Masataka Nishi
Keyword(s):  
Gas Separation ◽  
Fusion Reactor ◽  
Gas Separation Membrane ◽  
Separation Membrane ◽  
Removal System

Metal-induced microporous aminosilica creates a highly permeable gas-separation membrane

2021 ◽  
Author(s):  
Ufafa Anggarini ◽  
Toshinori Tsuru ◽  
Masakoto Kanezashi ◽  
Hiroki Nagasawa ◽  
Liang Yu
Keyword(s):  
Gas Separation ◽  
Gas Separation Membrane ◽  
Separation Membrane

Hybrid microporous aminosilica membranes have been successfully synthesized via doping with Ag-, Cu- and Ni- into dense bis [3-(trimethoxysilyl) propyl] amine (BTPA) membranes, which creates micropores via the crosslinking between...

Preparation and characterization of a polyethersulfone/polyaniline nanocomposite membrane for ultrafiltration and as a substrate for a gas separation membrane

RSC Advances ◽  
2015 ◽  
Vol 5 (34) ◽  
pp. 27211-27223 ◽  
Author(s):  
Shu Zhu ◽  
Mengqi Shi ◽  
Song Zhao ◽  
Zhi Wang ◽  
Jixiao Wang ◽  
...  
Keyword(s):  
Gas Separation ◽  
Woven Fabrics ◽  
Nanocomposite Membrane ◽  
Selective Layer ◽  
Gas Separation Membrane ◽  
Supported Membrane ◽  
Suitable Substrate ◽  
Separation Membrane ◽  
Polyaniline Nanocomposite

PES/PANI nanocomposite membrane displayed excellent flux and antifouling property for UF. Meanwhile, PES/PANI non-woven fabrics supported membrane performed as a suitable substrate for gas separation membrane with PVAm selective layer.

CO2 reforming into fuel using TiO2 photocatalyst and gas separation membrane

2009 ◽  
Vol 148 (3-4) ◽  
pp. 341-349 ◽  
Author(s):  
Akira Nishimura ◽  
Nobuyuki Komatsu ◽  
Go Mitsui ◽  
Masafumi Hirota ◽  
Eric Hu
Keyword(s):  
Gas Separation ◽  
Tio2 Photocatalyst ◽  
Co2 Reforming ◽  
Gas Separation Membrane ◽  
Separation Membrane

scholarly journals Gas Separation Membranes upon Production of Functional Berry Juice

2019 ◽  
Vol 9 (1) ◽  
pp. 6616-6619
Keyword(s):  
Ascorbic Acid ◽  
Gas Separation ◽  
Biologically Active ◽  
Juice Quality ◽  
Active Components ◽  
Gas Separation Membrane ◽  
Separation Membranes ◽  
Gas Separation Membranes ◽  
Separation Membrane ◽  
New Generation

Nowadays manufacturing of new-generation food, including functional products, is especially important. Drinks based on fruits and berries are considered at present as optimum form of food required for organism replenishment with biologically active components and vitamins aiming at organism recovery. The retention of valuable components of fruits and berries is of great concern during such production. In order to produce functional juices, it is required to decrease oxygen amount upon their production in order to prevent destructive changes in drink, to improve its quality, to perform subsequent procedures and preservation. It is proposed to modify deaeration and to apply advanced equipment: deaerator with gas separation membrane which would allow to remove higher oxygen amount in comparison with the existing equipment while producing juices of predefined quality with high content of vitamins. The experiments were carried out with freshly squeezed black current juices using a vacuum unit, an Expert-009 analyzer of dissolved oxygen with optical sensor, a gas separation membrane. The juice quality was determined by its content of ascorbic acid (vitamin C) since it is destroyed under impact of oxygen. The content of ascorbic acid during storage was measured on juices produced by different deaeration procedures. The obtained experimental results proved efficiency of membrane application during juice production showing high content of vitamins. The content of ascorbic acid during storage was higher in the juice after deaeration using gas separation membrane in comparison with the juice without treatment and with the juice after vacuum deaeration. Therefore, the most efficient method to achieve the best removal of oxygen from juice is preheating of juice to 65°C with subsequent application of deaerator with gas separation membrane, subsequent packing and cooling of final product.

Sign in / Sign up

Export Citation Format

Share Document