Modeling Evapotranspiration of Winter Wheat Using Contextual and Pixel-Based Surface Energy Balance Models

2021 ◽  
Vol 64 (2) ◽  
pp. 507-519
Author(s):  
Kul Khand ◽  
Nishan Bhattarai ◽  
Saleh Taghvaeian ◽  
Pradeep Wagle ◽  
Prasanna H. Gowda ◽  
...  

HighlightsThree contextual-based (CB) and two pixel-based (PB) models were evaluated to estimate ET of rainfed winter wheat.Instantaneous available energy estimation and ET upscaling impacted model performance.The CB models performed better at instantaneous and daily scales compared to the PB models.ET estimation biases increased during low vegetation and drier conditions, especially for the PB models.Abstract. Surface energy balance (SEB) models based on thermal remote sensing data are widely used in research applications to map evapotranspiration (ET) across various landscapes. However, their ability to capture ET from winter wheat remains underexplored, especially in practical applications such as integrated resource management and drought preparedness. Investigating winter wheat ET dynamics is important in agricultural regions such as the Southern Great Plains of the U.S., where winter wheat is extensively cultivated. The goal of this study was to evaluate the performance of five fully automated SEB models, three contextual-based (CB) and two pixel-based (PB), in estimating instantaneous and daily ET of winter wheat by comparing the model results with flux tower observations. The CB models included Surface Energy Balance Algorithm for Land (SEBAL), Mapping Evapotranspiration at high Resolution with Internalized Calibration (METRIC), and Triangular Vegetation Temperature (TVT). The PB models included Surface Energy Balance System (SEBS) and Two-Source Energy Balance (TSEB). Model evaluation during two winter wheat growing seasons (2016-2018) using 28 Landsat images showed that the instantaneous ET estimates from METRIC and TSEB had the smallest (RMSE = 0.14 mm h-1) and largest (RMSE = 0.27 mm h-1) errors, respectively. At the daily scale, SEBAL was the best performing model (RMSE = 1.0 mm d-1), followed by TVT (RMSE = 1.1 mm d-1), METRIC (RMSE = 1.2 mm d-1), SEBS (RMSE = 1.3 mm d-1), and TSEB (RMSE = 1.5 mm d-1). Overall, the CB models provided smaller errors than the PB models. Larger errors in daily ET estimation were observed during low vegetation and drier conditions, especially for the PB models. Keywords: Flux tower, Landsat, Southern Great Plains, Water use.

2016 ◽  
Author(s):  
Nobuhle P. Majozi ◽  
Chris M. Mannaerts ◽  
Abel Ramoelo ◽  
Renaud Mathieu ◽  
Alecia Nickless ◽  
...  

Abstract. Flux tower sites and data are in great demand to provide essential terrestrial climate, water and radiation budget information needed for environmental monitoring and evaluation of climate change impacts on ecosystems and society in general. They are also intended for calibration and validation of satellite-based earth observation and monitoring efforts, such as for example assessment of evapotranspiration from land and vegetation surfaces using surface energy balance approaches. Surface energy budget methods for ET estimation rely to a large extend on the basic assumption of a surface energy balance closure, assuming the full conversion of net solar radiation reaching the land surface into soil heat conduction and turbulent fluxes, i.e. the sensible (or convection) and latent heat components of the energy balance. Evapotranspiration is the conversion of the latent heat exchange fraction of the balance. In this paper, the Skukuza flux tower data were analysed in order to verify their use for validation of satellite–based evapotranspiration methods, under development in South Africa.Data series from 2000 until 2014 were used in the analysis. The energy balance ratio (EBR) concept, defined as the ratio between the sum of the turbulent convective and latent heat fluxes and radiation minus soil heat was used. At first typical diurnal patterns of EB partitioning were derived for four different seasons, well illustrating how this savannah-type biome responses to the weather conditions. Also the particular behaviour of the EB components during sunrise and sunset conditions, being important but usually neglected periods of energy transitions and inversions were noted and analysed. Annual estimates of the surface energy balance and its components were generated, including an evaluation of the balance closure. The seasonal variations were also investigated as well as the impact of nocturnal observations on the overall EB behaviour.


2021 ◽  
pp. 1-19
Author(s):  
Rebecca L. Stewart ◽  
Matthew Westoby ◽  
Francesca Pellicciotti ◽  
Ann Rowan ◽  
Darrel Swift ◽  
...  

Abstract Surface energy-balance models are commonly used in conjunction with satellite thermal imagery to estimate supraglacial debris thickness. Removing the need for local meteorological data in the debris thickness estimation workflow could improve the versatility and spatiotemporal application of debris thickness estimation. We evaluate the use of regional reanalysis data to derive debris thickness for two mountain glaciers using a surface energy-balance model. Results forced using ERA-5 agree with AWS-derived estimates to within 0.01 ± 0.05 m for Miage Glacier, Italy, and 0.01 ± 0.02 m for Khumbu Glacier, Nepal. ERA-5 data were then used to estimate spatiotemporal changes in debris thickness over a ~20-year period for Miage Glacier, Khumbu Glacier and Haut Glacier d'Arolla, Switzerland. We observe significant increases in debris thickness at the terminus for Haut Glacier d'Arolla and at the margins of the expanding debris cover at all glaciers. While simulated debris thickness was underestimated compared to point measurements in areas of thick debris, our approach can reconstruct glacier-scale debris thickness distribution and its temporal evolution over multiple decades. We find significant changes in debris thickness over areas of thin debris, areas susceptible to high ablation rates, where current knowledge of debris evolution is limited.


2020 ◽  
pp. 1-16
Author(s):  
Tim Hill ◽  
Christine F. Dow ◽  
Eleanor A. Bash ◽  
Luke Copland

Abstract Glacier surficial melt rates are commonly modelled using surface energy balance (SEB) models, with outputs applied to extend point-based mass-balance measurements to regional scales, assess water resource availability, examine supraglacial hydrology and to investigate the relationship between surface melt and ice dynamics. We present an improved SEB model that addresses the primary limitations of existing models by: (1) deriving high-resolution (30 m) surface albedo from Landsat 8 imagery, (2) calculating shadows cast onto the glacier surface by high-relief topography to model incident shortwave radiation, (3) developing an algorithm to map debris sufficiently thick to insulate the glacier surface and (4) presenting a formulation of the SEB model coupled to a subsurface heat conduction model. We drive the model with 6 years of in situ meteorological data from Kaskawulsh Glacier and Nàłùdäy (Lowell) Glacier in the St. Elias Mountains, Yukon, Canada, and validate outputs against in situ measurements. Modelled seasonal melt agrees with observations within 9% across a range of elevations on both glaciers in years with high-quality in situ observations. We recommend applying the model to investigate the impacts of surface melt for individual glaciers when sufficient input data are available.


2008 ◽  
Vol 47 (3) ◽  
pp. 819-834 ◽  
Author(s):  
Timothy M. Barzyk ◽  
John E. Frederick

Abstract Individual structures within the same local-scale (102–104 m) environment may experience different microscale (<103 m) climates. Urban microclimate variations are often a result of site-specific features, including spatial and material characteristics of surfaces and surrounding structures. A semiempirical surface energy balance model is presented that incorporates radiative and meteorological measurements to statistically parameterize energy fluxes that are not measured directly, including sensible heat transport, storage heat flux through conduction, and evaporation (assumed to be negligible under dry conditions). Two Chicago rooftops were chosen for detailed study. The City Hall site was located in an intensely developed urban area characterized by close-set high-rise buildings. The University rooftop was in a highly developed area characterized by three- to seven-story buildings of stone, concrete, and brick construction. Two identical sets of instruments recorded measurements contemporaneously from these rooftops during summer 2005, and results from the week of 29 July to 5 August are presented here. The model explains 83.7% and 96% of the variance for the City Hall and University sites, respectively. Results apply to a surface area of approximately 1260 m2, at length scales similar to the dimensions of built structures and other urban elements. A site intercomparison revealed variations in surface energy balance components caused by site-specific features and demonstrated the relevance of the model to urban applications.


2021 ◽  
Vol 310 ◽  
pp. 108631
Author(s):  
Pradeep Wagle ◽  
Prasanna H. Gowda ◽  
Brian K. Northup ◽  
James P.S. Neel ◽  
Patrick J. Starks ◽  
...  

2009 ◽  
Vol 28 (1) ◽  
pp. 51-64 ◽  
Author(s):  
Luis Octavio Lagos ◽  
Derrel L. Martin ◽  
Shashi B. Verma ◽  
Andrew Suyker ◽  
Suat Irmak

Sign in / Sign up

Export Citation Format

Share Document