Dependence of the ghostbursting model’s dynamical states on the current injected into the dendritic compartment and the ratio of somatic to total surface areas

2017 ◽  
Vol 11 ◽  
pp. 561-565
Author(s):  
Takaaki Shirahata
Keyword(s):  
Dendritic Compartment ◽  
Surface Areas

Cerebral Tissue Response in Chronic Electrode Implantation

1977 ◽  
Vol 35 ◽  
pp. 624-625
Author(s):  
R.F. Dodson ◽  
L.W-F Chu ◽  
N. Ishihara
Keyword(s):  
Tissue Response ◽  
Whole Body ◽  
Platinum Electrodes ◽  
Fixed Tissue ◽  
Electrode Implantation ◽  
Surface Areas ◽  
Tissue Changes ◽  
Micron Diameter ◽  
Extent Of Damage ◽  
Electrode Sheath

The extent of damage surrounding an implanted electrode in the cerebral cortex is a question of significant importance with regard to attaining consistency and validity of physiological recordings. In order to determine the extent of such tissue changes, 150 micron diameter platinum electrodes were implanted in the cortex of four adult baboons, and after eight days the animals were sacrificed by whole body perfusion with a 3% glutaraldehyde in 0.1M phosphate fixative.The calvarium was carefully removed and the electrode tracts were readily discernible in the firm, glutaraldehyde fixed tissue.Careful dissection of the zone of the electrode tract resulted in a small block which was further sectioned into tip, mid-tract and surface areas. Ultrastructurally, damage extended from the electrode sheath to the greatest extent of from 0.2 to 3.5 mm.

Tissue section lifting for electron microscopy

1978 ◽  
Vol 36 (2) ◽  
pp. 86-87
Author(s):  
Adrian F. van Dellen
Keyword(s):  
Infectious Disease ◽  
Electron Microscopy ◽  
Tissue Culture ◽  
Organ System ◽  
Surrounding Tissue ◽  
Paraffin Sections ◽  
Surface Areas ◽  
Specific Determination ◽  
High Degree ◽  
Accuracy And Repeatability

The morphologic pathologist may require information on the ultrastructure of a non-specific lesion seen under the light microscope before he can make a specific determination. Such lesions, when caused by infectious disease agents, may be sparsely distributed in any organ system. Tissue culture systems, too, may only have widely dispersed foci suitable for ultrastructural study. In these situations, when only a few, small foci in large tissue areas are useful for electron microscopy, it is advantageous to employ a methodology which rapidly selects a single tissue focus that is expected to yield beneficial ultrastructural data from amongst the surrounding tissue. This is in essence what "LIFTING" accomplishes. We have developed LIFTING to a high degree of accuracy and repeatability utilizing the Microlift (Fig 1), and have successfully applied it to tissue culture monolayers, histologic paraffin sections, and tissue blocks with large surface areas that had been initially fixed for either light or electron microscopy.

In situ REM imaging of surface processes on ceramic bulk crystals from 300 to 1670 K in a conventional TEM

1991 ◽  
Vol 49 ◽  
pp. 660-661
Author(s):  
Z. L. Wang ◽  
J. Bentley
Keyword(s):  
High Temperatures ◽  
Image Resolution ◽  
Atomic Processes ◽  
Crystal Surfaces ◽  
Beam Radiation ◽  
Surface Areas ◽  
Transmission Electron ◽  
Reflection Electron Microscopy ◽  
Gas Reactions

Studying the behavior of surfaces at high temperatures is of great importance for understanding the properties of ceramics and associated surface-gas reactions. Atomic processes occurring on bulk crystal surfaces at high temperatures can be recorded by reflection electron microscopy (REM) in a conventional transmission electron microscope (TEM) with relatively high resolution, because REM is especially sensitive to atomic-height steps.Improved REM image resolution with a FEG: Cleaved surfaces of a-alumina (012) exhibit atomic flatness with steps of height about 5 Å, determined by reference to a screw (or near screw) dislocation with a presumed Burgers vector of b = (1/3)<012> (see Fig. 1). Steps of heights less than about 0.8 Å can be clearly resolved only with a field emission gun (FEG) (Fig. 2). The small steps are formed by the surface oscillating between the closely packed O and Al stacking layers. The bands of dark contrast (Fig. 2b) are the result of beam radiation damage to surface areas initially terminated with O ions.

Cell morphology, volume, and surface area determinations from multilevel contouring within HVEM micrographs of serial sections and whole-cell mounts

1987 ◽  
Vol 45 ◽  
pp. 588-589
Author(s):  
M. Marko ◽  
A. Leith ◽  
D. Parsons
Keyword(s):  
Surface Area ◽  
Electron Micrographs ◽  
Cell Morphology ◽  
Individual Variation ◽  
Serial Section ◽  
Stereo Pair ◽  
Complex Structures ◽  
Serial Sections ◽  
Surface Areas ◽  
Computer Based

The use of serial sections and computer-based 3-D reconstruction techniques affords an opportunity not only to visualize the shape and distribution of the structures being studied, but also to determine their volumes and surface areas. Up until now, this has been done using serial ultrathin sections.The serial-section approach differs from the stereo logical methods of Weibel in that it is based on the Information from a set of single, complete cells (or organelles) rather than on a random 2-dimensional sampling of a population of cells. Because of this, it can more easily provide absolute values of volume and surface area, especially for highly-complex structures. It also allows study of individual variation among the cells, and study of structures which occur only infrequently.We have developed a system for 3-D reconstruction of objects from stereo-pair electron micrographs of thick specimens.

Hair cell changes after cationic stimulation of corti's organ

1989 ◽  
Vol 47 ◽  
pp. 798-799
Author(s):  
Cesar D. Fermin ◽  
Hans-Peter Zenner
Keyword(s):  
Organ Of Corti ◽  
Cross Sectional ◽  
Surface Areas ◽  
High K ◽  
Anatomical Arrangement ◽  
Cell Cytosol ◽  
High Concentrations ◽  
K Concentration ◽  
Cell Changes

Contraction of outer and inner hair cells (OHC&IHC) in the Organ of Corti (OC) of the inner ear is necessary for sound transduction. Getting at HC in vivo preparations is difficult. Thus, isolated HCs have been used to study OHC properties. Even though viability has been shown in isolated (iOHC) preparations by good responses to current and cationic stimulation, the contribution of adjoining cells can not be explained with iOHC preparations. This study was undertaken to examine changes in the OHC after expossure of the OHC to high concentrations of potassium (K) and sodium (Na), by carefully immersing the OC in either artifical endolymph or perilymph. After K and Na exposure, OCs were fixed with 3% glutaraldehyde, post-fixed in osmium, separated into base, middle and apex and embedded in Araldite™. One μm thick sections were prepared for analysis with the light and E.M. Cross sectional areas were measured with Bioquant™ software.Potassium and sodium both cause isolated guinea pig OHC to contract. In vivo high K concentration may cause uncontrolled and sustained contractions that could contribute to Meniere's disease. The behavior of OHC in the vivo setting might be very different from that of iOHC. We show here changes of the cell cytosol and cisterns caused by K and Na to OHC in situs. The table below shows results from cross sectional area measurements of OHC from OC that were exposed to either K or Na. As one would expect, from the anatomical arrangement of the OC, OHC#l that are supported by rigid tissue would probably be displaced (move) less than those OHC located away from the pillar. Surprisingly, cells in the middle turn of the cochlea changed their surface areas more than those at either end of the cochlea. Moreover, changes in surface area do not seem to differ between K and Na treated OCs.

Milestone solution for snow removal problem in Moscow

2019 ◽  
pp. 66-72
Keyword(s):  
New Technologies ◽  
Environmental Safety ◽  
Winter Period ◽  
Special Importance ◽  
Master Plan ◽  
Infrastructure Development ◽  
Snow Removal ◽  
Surface Areas ◽  
The City ◽  
Deicing Agents

The main principle of the strategy for the complex improvement of the functioning of northern cities in winter, including their infrastructure development, is a comprehensive solution of the problem of industrial-scale snow-mass collection, removal and utilization at different areas of urban roadway networks. For its implementation in the capital of Russia, “MosvodokanalNIIproject” JSC developed in 2002 the Snow Removal Master Plan for the city of Moscow. The meteorological conditions in the city, which have changed considerably in the recent years, including the changes in the snow-cover depth and in the road-surface areas to be cleaned, as well as emerging of new technologies for the cleaning of urban streets, yards and sidewalks and some new types of deicing agents, resulted in the necessity to update the above-mentioned Snow Removal Master Plan developed for the city of Moscow. Efficient application of deicing agents is of special importance for its updating in the context of the environmental safety of the city in a winter period. The article considers the results of the implementation of the updated Snow Removal Master Plan and contains some proposals concerning snow removal under the conditions of extreme snowfalls.

A Highly Crystalline Anthracene-Based MOF-74 Series Featuring Electrical Conductivity and Luminescence

2019 ◽  
Author(s):  
Patricia Scheurle ◽  
Andre Mähringer ◽  
Andreas Jakowetz ◽  
Pouya Hosseini ◽  
Alexander Richter ◽  
...  
Keyword(s):  
Electrical Conductivity ◽  
Metal Ions ◽  
Light Emission ◽  
Block Design ◽  
High Surface ◽  
Visible Spectrum ◽  
Building Blocks ◽  
Divalent Metal Ions ◽  
Conductivity Enhancement ◽  
Surface Areas

Recently, a small group of metal-organic frameworks (MOFs) has been discovered featuring substantial charge transport properties and electrical conductivity, hence promising to broaden the scope of potential MOF applications in fields such as batteries, fuel cells and supercapacitors. In combination with light emission, electroactive MOFs are intriguing candidates for chemical sensing and optoelectronic applications. Here, we incorporated anthracene-based building blocks into the MOF-74 topology with five different divalent metal ions, that is, Zn2+, Mg2+, Ni2+, Co2+ and Mn2+, resulting in a series of highly crystalline MOFs, coined ANMOF-74(M). This series of MOFs features substantial photoluminescence, with ANMOF-74(Zn) emitting across the whole visible spectrum. The materials moreover combine this photoluminescence with high surface areas and electrical conductivity. Compared to the original MOF-74 materials constructed from 2,5-dihydroxy terephthalic acid and the same metal ions Zn2+, Mg2+, Ni2+, Co2+ and Mn2+, we observed a conductivity enhancement of up to six orders of magnitude. Our results point towards the importance of building block design and the careful choice of the embedded MOF topology for obtaining materials with desired properties such as photoluminescence and electrical conductivity.

Kinetic Control of Interpenetration in Fe-Biphenyl-4,4′-dicarboxylate MOFs by Coordination and Oxidation Modulation

2018 ◽  
Author(s):  
Dominic Bara ◽  
Claire Wilson ◽  
Max Mörtel ◽  
Marat M. Khusniyarov ◽  
ben slater ◽  
...  
Keyword(s):  
Self Assembly ◽  
Surface Areas ◽  
Metal Precursors ◽  
Additional Coordination ◽  
Fine Control ◽  
Multiple Alternative ◽  
Metal Organic ◽  
Dft Simulations ◽  
High Valent ◽  
And Control

Phase control in the self-assembly of metal-organic frameworks (MOFs) – materials wherein organic ligands connect metal ions or clusters into network solids with potential porosity – is often a case of trial and error. Judicious control over a number of synthetic variables is required to select for the desired topology and control features such as interpenetration and defectivity, which have significant impact on physical properties and application. Herein, we present a comprehensive investigation of self-assembly in the Fe-biphenyl-4,4'-dicarboxylate system, demonstrating that coordination modulation, the addition of competing ligands into solvothermal syntheses, can reliably tune between the kinetic product, non-interpenetrated MIL-88D(Fe), and the thermodynamic product, two-fold interpenetrated MIL-126(Fe). DFT simulations reveal that correlated disorder of the terminal anions on the metal clusters in the interpentrated phase results in H-bonding between adjacent nets and is the thermodynamic driving force for its formation. Coordination modulation slows self-assembly and therefore selects the thermodynamic product MIL-126(Fe), while offering fine control over defectivity, inducing mesoporosity, but electron microscopy shows the MIL-88D(Fe) phase persists in many samples despite not being evident in diffraction experiments, suggesting its presence accounts for the lower than predicted surface areas reported for samples to date. Interpenetration control is also demonstrated by utilizing the 2,2'-bipyridine-5,5'-dicarboxylate linker; DFT simulations show that it is energetically prohibitive for it to adopt the twisted conformation required to form the interpenetrated phase, and are confirmed by experimental data, although multiple alternative phases are identified due to additional coordination of the Fe cations to the N-donors of the ligand. Finally, we introduce oxidation modulation – the concept of using metal precursors in a different oxidation state to that found in the final MOF – as a further protocol to kinetically control self-assembly. Combining coordination and oxidation modulation allows the synthesis of pristine MIL-126(Fe) with BET surface areas close to the predicted maximum capacity for the first time, suggesting that combining the two may be a powerful methodology for the controlled self-assembly of high-valent MOFs.<br><br>

Sign in / Sign up

Export Citation Format

Share Document