scholarly journals ERROR IN MEASUREMENT OF GAS FLOW RATE IN GAS-SOLIDS TWO-PHASE FLOW BY USE OF A HORIZONTAL DIFFUSER

1973 ◽  
Vol 6 (3) ◽  
pp. 278-282 ◽  
Author(s):  
HIROAKI MASUDA ◽  
YOSHIFUMI ITO ◽  
KOIGHI IINOYA
Keyword(s):  
Flow Rate ◽  
Gas Flow ◽  
Two Phase Flow ◽  
Phase Flow ◽  
Gas Flow Rate ◽  
Two Phase

Experimental, Numerical, and Statistical Investigation of Two Phase Flow in a Cylindrical Perforation Tunnel

2021 ◽  
Author(s):  
Ekhwaiter Abobaker ◽  
Abadelhalim Elsanoose ◽  
Mohammad Azizur Rahman ◽  
Faisal Khan ◽  
Amer Aborig ◽  
...  
Keyword(s):  
Numerical Simulation ◽  
Steady State ◽  
Statistical Analysis ◽  
Flow Rate ◽  
Gas Flow ◽  
Two Phase Flow ◽  
Phase Flow ◽  
Gas Flow Rate ◽  
Two Phase ◽  
Flow Through

Abstract Perforation is the final stage in well completion that helps to connect reservoir formations to wellbores during hydrocarbon production. The drilling perforation technique maximizes the reservoir productivity index by minimizing damage. This can be best accomplished by attaining a better understanding of fluid flows that occur in the near-wellbore region during oil and gas operations. The present work aims to enhance oil recovery by modelling a two-phase flow through the near-wellbore region, thereby expanding industry knowledge about well performance. An experimental procedure was conducted to investigate the behavior of two-phase flow through a cylindrical perforation tunnel. Statistical analysis was coupled with numerical simulation to expand the investigation of fluid flow in the near-wellbore region that cannot be obtained experimentally. The statistical analysis investigated the effect of several parameters, including the liquid and gas flow rate, liquid viscosity, permeability, and porosity, on the injection build-up pressure and the time needed to reach a steady-state flow condition. Design-Expert® Design of Experiments (DoE) software was used to determine the numerical simulation runs using the ANOVA analysis with a Box-Behnken Design (BBD) model and ANSYS-FLUENT was used to analyses the numerical simulation of the porous media tunnel by applying the volume of fluid method (VOF). The experimental data were validated to the numerical results, and the comparison of results was in good agreement. The numerical and statistical analysis demonstrated each investigated parameter’s effect. The permeability, flow rate, and viscosity of the liquid significantly affect the injection pressure build-up profile, and porosity and gas flow rate substantially affect the time required to attain steady-state conditions. In addition, two correlations obtained from the statistical analysis can be used to predict the injection build-up pressure and the required time to reach steady state for different scenarios. This work will contribute to the clarification and understanding of the behavior of multiphase flow in the near-wellbore region.

scholarly journals Measurement of Gas-Oil Two-Phase Flow Patterns by Using CNN Algorithm Based on Dual ECT Sensors with Venturi Tube

Sensors ◽  
2020 ◽  
Vol 20 (4) ◽  
pp. 1200 ◽  
Author(s):  
Zhuoqun Xu ◽  
Fan Wu ◽  
Xinmeng Yang ◽  
Yi Li
Keyword(s):  
Flow Rate ◽  
Gas Flow ◽  
Two Phase Flow ◽  
Flow Patterns ◽  
Venturi Tube ◽  
Phase Flow ◽  
Gas Flow Rate ◽  
Two Phase ◽  
Oil Flow ◽  
Oil Gas

In modern society, the oil industry has become the foundation of the world economy, and how to efficiently extract oil is a pressing problem. Among them, the accurate measurement of oil-gas two-phase parameters is one of the bottlenecks in oil extraction technology. It is found that through the experiment the flow patterns of the oil-gas two-phase flow will change after passing through the venturi tube with the same flow rates. Under the different oil-gas flow rate, the change will be diverse. Being motivated by the above experiments, we use the dual ECT sensors to collect the capacitance values before and after the venturi tube, respectively. Additionally, we use the linear projection algorithm (LBP) algorithm to reconstruct the image of flow patterns. This paper discusses the relationship between the change of flow patterns and the flow rates. Furthermore, a convolutional neural network (CNN) algorithm is proposed to predict the oil flow rate, gas flow rate, and GVF (gas void fraction, especially referring to sectional gas fraction) of the two-phase flow. We use ElasticNet regression as the loss function to effectively avoid possible overfitting problems. In actual experiments, we compare the Typical-ECT-imaging-based-GVF algorithm and SVM (Support Vector Machine) algorithm with CNN algorithm based on three different ECT datasets. Three different sets of ECT data are used to predict the gas flow rate, oil flow rate, and GVF, and they are respectively using the venturi front-based ECT data only, while using the venturi behind-based ECT data and using both these data.

scholarly journals Development of Gas Flow Rate Measurement Technique in Intermittent Two-Phase Flow in a Complex Channel

2018 ◽  
Vol 32 (1) ◽  
pp. 73-79
Author(s):  
Kiyora IWAKAMI ◽  
Yuzo INOUE ◽  
Akiko KANEKO ◽  
Yutaka ABE ◽  
Mitsuaki SAKAI
Keyword(s):  
Flow Rate ◽  
Measurement Technique ◽  
Gas Flow ◽  
Two Phase Flow ◽  
Phase Flow ◽  
Rate Measurement ◽  
Gas Flow Rate ◽  
Flow Rate Measurement ◽  
Two Phase ◽  
Complex Channel

Wet Gas Flow Metering Based on Differential Pressure and BSS Techniques

2011 ◽  
Vol 383-390 ◽  
pp. 4922-4927
Author(s):  
Peng Xia Xu ◽  
Yan Feng Geng
Keyword(s):  
Flow Rate ◽  
Liquid Flow ◽  
Gas Flow ◽  
Two Phase Flow ◽  
Liquid Flow Rate ◽  
Differential Pressure ◽  
Phase Flow ◽  
Two Phase ◽  
Flow Metering ◽  
Wet Gas

Wet gas flow is a typical two-phase flow with low liquid fractions. As differential pressure signal contains rich information of flow parameters in two-phase flow metering, a new method is proposed for wet gas flow metering based on differential pressure (DP) and blind source separation (BSS) techniques. DP signals are from a couple of slotted orifices and the BSS method is based on time-frequency analysis. A good relationship between the liquid flow rate and the characteristic quantity of the separated signal is established, and a differential pressure correlation for slotted orifice is applied to calculate the gas flow rate. The calculation results are good with 90% relative errors less than ±10%. The results also show that BSS is an effective method to extract liquid flow rate from DP signals of wet gas flow, and to analysis different interactions among the total DP readings.

Visualization Study on Two-Phase Flow Behaviors in the Gas-Liquid-Solid Microreactor for Hydrogenation of Nitrobenzene

2016 ◽  
Author(s):  
Hao Feng ◽  
Xun Zhu ◽  
Rong Chen ◽  
Qiang Liao
Keyword(s):  
Flow Rate ◽  
Liquid Flow ◽  
Gas Flow ◽  
Two Phase Flow ◽  
Flow Direction ◽  
Flow Characteristics ◽  
Phase Flow ◽  
Microchannel Reactor ◽  
Two Phase ◽  
Modified Surface

In this study, visualization study on the gas-liquid two phase flow characteristics in a gas-liquid-solid microchannel reactor was carried out. Palladium nanocatalyst was coated onto the polydopamine functionalized surface of the microchannel through eletroless deposition. The materials characterization results indicated that palladium nanocatalyst were well dispersed on the modified surface. The effects of both the gas and liquid flow rates as well as inlet nitrobenzene concentration on the two-phase flow characteristics were studied. The experimental results revealed that owing to the chemical reaction inside the microreactor, the gas slug length gradually decreased along the flow direction. For a given inlet nitrobenzene concentration, increasing the liquid flow rate or decreasing the gas flow rate would make the variation of the gas slug length more obvious. High inlet nitrobenzene concentration would intensify both the nitrobenzene transfer efficiency and gas reactants consumption, and thereby the flow pattern in the microchannel was transferred from Taylor flow into bubble flow. Besides, the effect of both flow rate and original nitrobenzene concentration on the variation of nitrobenzene conversion and the desired product aniline yield were also discussed.

Modeling Oscillatory Behavior of ESP Wells Under Two-Phase Flow Conditions

2012 ◽  
Author(s):  
Rinaldo Antonio de Melo Vieira ◽  
Mauricio Gargaglione Prado
Keyword(s):  
Flow Rate ◽  
Liquid Flow ◽  
Gas Flow ◽  
Two Phase Flow ◽  
Liquid Flow Rate ◽  
Oscillatory Behavior ◽  
Phase Flow ◽  
Flow Conditions ◽  
Two Phase ◽  
Operational Conditions

The effect of free gas on the Electrical Submersible Pump (ESP) performance is well known. At a constant rotational speed and constant liquid flowrate, small amount of gas causes a mild head reduction when compared to the single phase liquid head. However, at higher gas rates, a drastic reduction in the head is observed. This critical condition, known as surging point, is a combination of liquid and gas flow rates that cause a maximum in the head performance curve. The first derivative of the head with respect to the liquid flow rate change sign as the liquid flow rate crosses the surging point. In several works on ESP two-phase flow performance, production conditions to the left of the surging region are described or reported as unstable operational conditions. This paper reviews basic concepts on stability of dynamical systems and shows through simulation that ESP oscillatory behavior may result from two-phase flow conditions. A specific drift flux computation code was developed to simulate the dynamic behavior of ESP wells producing without packer.

scholarly journals Numerical Simulation of Flow Behavior within a Venturi Scrubber

2014 ◽  
Vol 2014 ◽  
pp. 1-7
Author(s):  
M. M. Toledo-Melchor ◽  
C. del C. Gutiérrez-Torres ◽  
J. A. Jiménez-Bernal ◽  
J. G. Barbosa-Saldaña ◽  
S. A. Martínez-Delgadillo ◽  
...  
Keyword(s):  
Numerical Simulation ◽  
Pressure Drop ◽  
Mass Flow Rate ◽  
Mass Flow ◽  
Flow Rate ◽  
Gas Flow ◽  
Two Phase Flow ◽  
Phase Flow ◽  
Two Phase ◽  
Venturi Scrubber

The present work details the three-dimensional numerical simulation of single-phase and two-phase flow (air-water) in a venturi scrubber with an inlet and throat diameters of 250 and 122.5 mm, respectively. The dimensions and operating parameters correspond to industrial applications. The mass flow rate conditions were 0.483 kg/s, 0.736 kg/s, 0.861 kg/s, and 0.987 kg/s for the gas only simulation; the mass flow rate for the liquid was 0.013 kg/s and 0.038 kg/s. The gas flow was simulated in five geometries with different converging and diverging angles while the two-phase flow was only simulated for one geometry. The results obtained were validated with experimental data obtained by other researchers. The results show that the pressure drop depends significantly on the gas flow rate and that water flow rate does not have significant effects neither on the pressure drop nor on the fluid maximum velocity within the scrubber.

The influence of the Stokes and Archimedes forces on the stability of a two-phase flow

2003 ◽  
Vol 3 ◽  
pp. 266-270
Author(s):  
B.H. Khudjuyerov ◽  
I.A. Chuliev
Keyword(s):  
Spectral Method ◽  
Stability Region ◽  
Gas Flow ◽  
Two Phase Flow ◽  
Solid Phase ◽  
Stability Characteristic ◽  
Phase Flow ◽  
Two Phase ◽  
The Stability

The problem of the stability of a two-phase flow is considered. The solution of the stability equations is performed by the spectral method using polynomials of Chebyshev. A decrease in the stability region gas flow with the addition of particles of the solid phase. The analysis influence on the stability characteristic of Stokes and Archimedes forces.

scholarly journals Correction to Flow Rate Profile Interpretation for a Two-Phase Flow in Multistage Fractured Horizontal Wells by Inversion of DTS Data

ACS Omega ◽  
2020 ◽  
Vol 5 (41) ◽  
pp. 26955-26955
Author(s):  
Hongwen Luo ◽  
Beibei Jiang ◽  
Haitao Li ◽  
Ying Li ◽  
Zhangxin Chen
Keyword(s):  
Flow Rate ◽  
Two Phase Flow ◽  
Horizontal Wells ◽  
Phase Flow ◽  
Two Phase ◽  
Fractured Horizontal Wells ◽  
Rate Profile

scholarly journals Bubble behavior in horizontal two-phase flow under flow rate fluctuation

2014 ◽  
Vol 1 (4) ◽  
pp. TEP0019-TEP0019 ◽  
Author(s):  
Jun-ichi TAKANO ◽  
Hideaki MONJI ◽  
Akiko KANEKO ◽  
Yutaka ABE ◽  
Hiroyuki YOSHIDA ◽  
...  
Keyword(s):  
Flow Rate ◽  
Two Phase Flow ◽  
Phase Flow ◽  
Bubble Behavior ◽  
Two Phase ◽  
Rate Fluctuation
Sign in / Sign up

Export Citation Format

Share Document