scholarly journals Nature of Catalytically Active Sites over Solid Acids. II. Relationships between Acidic Properties of Silica–Alumina and Its Catalytic Activities for Olefin Polymerization

1977 ◽  
Vol 50 (1) ◽  
pp. 49-51 ◽  
Author(s):  
Jun-ichiro Take ◽  
Masanori Ikeda ◽  
Yukio Yoneda
Keyword(s):  
Active Sites ◽  
Olefin Polymerization ◽  
Solid Acids ◽  
Acidic Properties ◽  
Catalytic Activities ◽  
Catalytically Active ◽  
Silica Alumina

scholarly journals Effect of Na2O Doping on the Surface and Catalytic Properties of the Mn2O3/Al2O3 System

1995 ◽  
Vol 12 (2) ◽  
pp. 119-128 ◽  
Author(s):  
G.A. El-Shobaky ◽  
A.M. Ghozza ◽  
S. Hammad
Keyword(s):  
Catalytic Activity ◽  
Active Sites ◽  
Catalytic Properties ◽  
Xrd Analysis ◽  
Manganese Carbonate ◽  
Oxidation Of Co ◽  
Mechanical Mixing ◽  
Catalytic Activities ◽  
Specific Catalytic Activity ◽  
Catalytically Active

Manganese/aluminium mixed oxide solids having the formula 0.2MnCO3/Al2O3 were prepared by mechanical mixing of a known weight of finely powdered manganese carbonate and aluminium hydroxide. The solids obtained were treated with NaNO3 (0.75–6 mol%) solution and dried at 110°C, then calcined in air at 500°C and 800°C for 6 h. The phases produced were identified by XRD analysis. The surface properties (SBET, Vp and r̄) of the pure and doped solids were studied by using N2 adsorption at – 196°C and their catalytic activities were determined by studying the oxidation of CO by O2at 125–300°C. The results obtained reveal that pure and doped mixed solids preheated in air at 500°C and 800°C consist of Mn2O3 (partridgite) and a poorly crystalline γ-alumina. Doping with sodium oxide at 500°C and 800°C resulted in a small decrease (14–19%) in the SBET value of the treated solids. However, this treatment brought about a significant modification in the catalytic activity of the doped solids. Doping with 0.75% Na2O at 500°C led to an increase of about 30–50% in the specific catalytic activity which was found to decrease on increasing the percentage of Na2O above this limit, falling to values smaller than that measured for the undoped catalyst. Doping at 800°C led to a progressive decrease in the activity of the treated solid to an extent proportional to the amount of dopant present. The doping process at 500°C and 800°C did not modify the mechanism of the catalytic reaction but altered the number of catalytically-active sites contributing in the catalysis of CO oxidation by O2 without changing their energetic nature.

scholarly journals Surface and Catalytic Properties of NiO and Fe2O3 Solids

1997 ◽  
Vol 15 (8) ◽  
pp. 593-607 ◽  
Author(s):  
A. Abd. El-Aal ◽  
A.M. Ghozza ◽  
G.A. El-Shobaky
Keyword(s):  
Catalytic Activity ◽  
Calcination Temperature ◽  
Active Sites ◽  
Pore Radius ◽  
Total Pore Volume ◽  
Surface Characteristics ◽  
Oxidation Of Co ◽  
Catalytic Activities ◽  
Catalytically Active ◽  
The Mean

The surface characteristics, viz., the specific surface area SBET, the total pore volume Vp and the mean pore radius r̄, of NiO and Fe2O3 were determined from N2 adsorption isotherms conducted at −196°C for the different adsorbents preheated in air at temperatures in the range 300–800°C. The catalytic activities exhibited in CO oxidation by O2 on the various solids were investigated at temperatures varying between 150°C and 400°C. The effect of heating the NiO and Fe2O3 solids in CO and O2 atmospheres at 175–275°C on their catalytic activities was also studied. The results showed that increasing the calcination temperature in the range 300–800°C resulted in a progressive decrease in the SBET value of NiO and Fe2O3. The computed values of the apparent activation energy for the sintering of the oxides were 71 and 92 kJ/mol, respectively. The sintering of NiO and Fe2O3 took place mainly via a particle adhesion mechanism. The catalytic activity of NiO decreased progressively on increasing its calcination temperature from 300°C to 800°C, due to a decrease in its SBET value and the progressive removal of excess O2 which was present as non-stoichiometric NiO. This treatment also decreased the catalytic activity of Fe2O3. The decrease was, however, more pronounced when the temperature increased from 300°C to 400°C which was a result of the crystallization of the ferric oxide into the α-Fe2O3 phase. An increase in the calcination temperature for both oxides from 300°C to 800°C did not modify the mechanism of oxidation of CO by O2 over the various solids but rather changed the concentration of catalytically active sites. Heating NiO and Fe2O3 in CO and O2 atmospheres at 175–275°C modified their catalytic activities, with Fe2O3 being influenced to a greater extent than NiO.

scholarly journals Effect of Li2O Doping on the Surface and Catalytic Properties of the Cr2O/Al2O3 System

1998 ◽  
Vol 16 (6) ◽  
pp. 415-429 ◽  
Author(s):  
G.A. El-Shobaky ◽  
A.M. Ghozza ◽  
H.G. El-Shobaky
Keyword(s):  
Co Oxidation ◽  
Catalytic Reaction ◽  
Active Sites ◽  
Catalytic Properties ◽  
Nitrogen Adsorption ◽  
Maximum Increase ◽  
Exponential Factor ◽  
Catalytic Activities ◽  
Catalytically Active ◽  
Maximum Decrease

Two Cr2O3/Al2O3 samples with the nominal compositions 0.06Cr2O2/Al2O3 and 0.125Cr2O3/Al2O3 (AlCr-I and AlCr-II, respectively) were prepared by mixing a known amount of finely powdered Al(OH)3 with calculated amounts of CrO3, followed by drying at 120°C and calcination at 700°C and 800°C. Doped solid specimens were prepared by treating Al(OH)3 samples with known amounts of LiNO3 dissolved in the minimum amount of distilled water prior to mixing with CrO3. Dopant concentrations of 0.75, 1.50, 3.00 and 6.00 mol% Li2O were employed. The surface and catalytic properties of the pure and doped solids thus prepared were investigated using nitrogen adsorption at −196°C and studies of the catalysis of CO oxidation by O2 over the solid specimens at 300–400°C. The results of such studies showed that Li2O doping followed by calcination at 700°C led to a maximum increase in the specific surface area, SBET, of 26% for AlCr-I and of 55% for AlCr-II when these samples were doped with 3.00 mol% Li2O. The reverse effect was found when the calcination temperature was increased to 800°C, where a decrease of 34% in the SBET value of the AlCr-II sample doped with 3.00 mol% Li2O was detected. The catalytic activities measured at 350°C over the pure and doped solids decreased on increasing the dopant concentration, the maximum decrease in such activity being ca. 33% and 50%, respectively, for the AlCr-I and AlCr-II samples calcined at 700°C. Doping led to noticable changes in the magnitude of the activation energy for the catalytic reaction. Such changes were accompanied by parallel changes in the value of the pre-exponential factor in the Arrhenius equation. These results may indicate that Li2O doping has no effect on the mechanism of the catalytic reaction but modifies (decreases) the concentration of catalytically active sites taking part in chemisorption during the catalysis of CO oxidation by O2.

scholarly journals Manganese vacancy-confined single-atom Ag in cryptomelane nanorods for efficient Wacker oxidation of styrene derivatives

2021 ◽  
Author(s):  
Hongling Yang ◽  
Xun Zhang ◽  
Yi Yu ◽  
Zheng Chen ◽  
Qinggang Liu ◽  
...  
Keyword(s):  
Molecular Sieve ◽  
Active Sites ◽  
Single Atom ◽  
Wacker Oxidation ◽  
Catalytically Active ◽  
Styrene Derivatives

Single-atom catalysts provide a pathway to elucidate the nature of catalytically active sites. However, keeping them stabilized during operation proves to be challenging. Herein, we employ cryptomelane-type octahedral molecular sieve...

Tuning electronic states of catalytic sites enhances SCR activity of hexagonal WO3by Mo framework substitution

2017 ◽  
Vol 7 (12) ◽  
pp. 2467-2473 ◽  
Author(s):  
Yaxin Chen ◽  
Zichenxi Dong ◽  
Zhiwei Huang ◽  
Meijuan Zhou ◽  
Jiayi Gao ◽  
...  
Keyword(s):  
Active Sites ◽  
Electronic States ◽  
Catalytic Sites ◽  
Catalytically Active

The electronic states of the catalytically active sites of HWO were tuned by Mo framework substitution.

ChemInform Abstract: Catalytically Active Sites and Their Complexity: A Micro-review.

ChemInform ◽  
2014 ◽  
Vol 45 (11) ◽  
pp. no-no ◽  
Author(s):  
Marco Piumetti ◽  
Francesca Stefania Freyria ◽  
Barbara Bonelli
Keyword(s):  
Active Sites ◽  
Catalytically Active
Sign in / Sign up

Export Citation Format

Share Document