scholarly journals The Base-catalyzed Condensation ofo-Nitroacetophenone. III. The Structure of Compound A, a Condensation Product

1965 ◽  
Vol 38 (1) ◽  
pp. 18-21 ◽  
Author(s):  
Takeo Sakan ◽  
Kousuke Kusuda ◽  
Toshio Miwa
Keyword(s):  
Condensation Product ◽  
Compound A

Characterization of Chemical Impurities in Glutaraldehyde

1975 ◽  
Vol 33 ◽  
pp. 620-621
Author(s):  
B. J. Grenon ◽  
A. J. Tousimis
Keyword(s):  
Glutaric Acid ◽  
Spectroscopic Analysis ◽  
Aldol Condensation ◽  
Condensation Product ◽  
Amorphous Solid ◽  
Water Soluble ◽  
Impurity Component ◽  
Chemical Impurities ◽  
Soluble Liquid

Ever since the introduction of glutaraldehyde as a fixative in electron microscopy of biological specimens, the identification of impurities and consequently their effects on biologic ultrastructure have been under investigation. Several reports postulate that the impurities of glutaraldehyde, used as a fixative, are glutaric acid, glutaraldehyde polymer, acrolein and glutaraldoxime.Analysis of commercially available biological or technical grade glutaraldehyde revealed two major impurity components, none of which has been reported. The first compound is a colorless, water-soluble liquid with a boiling point of 42°C at 16 mm. Utilizing Nuclear Magnetic Resonance (NMR) spectroscopic analysis, this compound has been identified to be — dihydro-2-ethoxy 2H-pyran. This impurity component of the glutaraldehyde biological or technical grades has an UV absorption peak at 235nm. The second compound is a white amorphous solid which is insoluble in water and has a melting point of 80-82°C. Initial chemical analysis indicates that this compound is an aldol condensation product(s) of glutaraldehyde.

Kinetics of Various 99mTc-Sn-Pyrophosphate Compounds in the Rat

1977 ◽  
Vol 16 (04) ◽  
pp. 157-162 ◽  
Author(s):  
C. Schümichen ◽  
B. Mackenbrock ◽  
G. Hoffmann
Keyword(s):  
Normal Saline ◽  
Half Life ◽  
Compound A ◽  
Short Half Life ◽  
Low Concentrations ◽  
The Stability ◽  
Kinetics Of ◽  
In Vitro Stability

SummaryThe bone-seeking 99mTc-Sn-pyrophosphate compound (compound A) was diluted both in vitro and in vivo and proved to be unstable both in vitro and in vivo. However, stability was much better in vivo than in vitro and thus the in vitro stability of compound A after dilution in various mediums could be followed up by a consecutive evaluation of the in vivo distribution in the rat. After dilution in neutral normal saline compound A is metastable and after a short half-life it is transformed into the other 99mTc-Sn-pyrophosphate compound A is metastable and after a short half-life in bone but in the kidneys. After dilution in normal saline of low pH and in buffering solutions the stability of compound A is increased. In human plasma compound A is relatively stable but not in plasma water. When compound B is formed in a buffering solution, uptake in the kidneys and excretion in urine is lowered and blood concentration increased.It is assumed that the association of protons to compound A will increase its stability at low concentrations while that to compound B will lead to a strong protein bond in plasma. It is concluded that compound A will not be stable in vivo because of a lack of stability in the extravascular space, and that the protein bond in plasma will be a measure of its in vivo stability.

Kinetics of Various 99mTc-Sn-Pyrophosphate Compounds in the Rat

1977 ◽  
Vol 16 (03) ◽  
pp. 100-103 ◽  
Author(s):  
C. Schümichen ◽  
J. Waiden ◽  
G. Hoffmann
Keyword(s):  
Glomerular Filtration ◽  
Renal Clearance ◽  
Plasma Protein ◽  
Kinetic Data ◽  
Adult Rats ◽  
Compound A ◽  
Extravascular Space ◽  
Tubular Cells ◽  
Glomerular Filtrate ◽  
Kinetics Of

SummaryThe kinetic data of two different 99mTc-Sn-pyrophosphate compounds (compound A and B) were evaluated in non-adult rats. Only compound A concentrated in bone. Both compounds dispersed rapidly in the intravascular as well as the extravascular space. The plasma protein bond of both compounds increased with time after injection and impaired both the renal clearance of both compounds and the bone clearance of compound A. The renal clearance of both compounds was somewhat above that of 5 1Cr-EDTA. It is concluded that compound A and B is mainly excreted by glomerular filtration. About one fourth of the glomerular filtrate of compound B is reabsorbed and accumulated by the tubular cells.

Synthesis, Structure and Reactivities of Pentacoordinated Phosphorus–Boron Bonded Compounds

2020 ◽  
Author(s):  
Nathan O'Brien ◽  
Naokazu Kano ◽  
Nizam Havare ◽  
Ryohei Uematsu ◽  
Romain Ramozzi ◽  
...  
Keyword(s):  
Crystal Structure ◽  
Ring Expansion ◽  
Bicyclic Compound ◽  
Compound A ◽  
Ligand System ◽  
Large Bulk ◽  
Rearrangement Reaction ◽  
Hydride Abstraction ◽  
Pentacoordinated Phosphorus ◽  
Acids And Bases

<div>The isolation and reactivities of two pentacoordinated phosphorus–tetracoordinated boron bonded compounds were</div><div>explored. A strong Lewis acidic boron reagent and electron-withdrawing ligand system were required to form the</div><div>pentacoordinated phosphorus state of the P–B bond. The first compound, a phosphoranyl-trihydroborate, gave a THF</div><div>stabilised phosphoranyl-borane intermediate upon a single hydride abstraction in THF. This compound could undergo a</div><div>unique rearrangement reaction, that involved a two-fold ring expansion, to give an unusual fused bicyclic compound or it</div><div>could act as a mono-hydroboration reagent. The hydroboration reactivity of the intermediate was found to be more reactive</div><div>towards alkynes over alkenes with good to moderate regioselectivity towards the terminal carbon. The second compound,</div><div>a phosphoranyl-triarylborate, was found to have a vastly different reactivity to the trihydroborate as it was highly stable</div><div>towards acids and bases. This is thought to be due to the large bulk around the P–B bond as shown in the crystal structure</div>

Folding-Controlled Assembly of Ortho-Phenylene-Based Macrocycles

2020 ◽  
Author(s):  
Viraj kirinda ◽  
Scott Hartley
Keyword(s):  
Self Assembly ◽  
Structural Control ◽  
Structural Changes ◽  
Condensation Product ◽  
Gel Permeation Chromatography ◽  
Emergent Behavior ◽  
Order Structure ◽  
High Level ◽  
Alkoxy Groups ◽  
Energy Surfaces

The self-assembly of foldamers into macrocycles is a simple approach to non-biological higher-order structure. Previous work on the co-assembly of ortho-phenylene foldamers with rod-shaped linkers has shown that folding and self-assembly affect each other; that is, the combination leads to new emergent behavior, such as access to otherwise unfavorable folding states. To this point this relationship has been passive. Here, we demonstrate control of self-assembly by manipulating the foldamers’ conformational energy surfaces. A series of o-phenylene decamers and octamers have been assembled into macrocycles using imine condensation. Product distributions were analyzed by gel-permeation chromatography and molecular geometries extracted from a combination of NMR spectroscopy and computational chemistry. The assembly of o-phenylene decamers functionalized with alkoxy groups or hydrogens gives both [2+2] and [3+3] macrocycles. The mixture results from a subtle balance of entropic and enthalpic effects in these systems: the smaller [2+2] macrocycles are entropically favored but require the oligomer to misfold, whereas a perfectly folded decamer fits well within the larger [3+3] macrocycle that is entropically disfavored. Changing the substituents to fluoro groups, however, shifts assembly quantitatively to the [3+3] macrocycle products, even though the structural changes are well-removed from the functional groups directly participating in bond formation. The electron-withdrawing groups favor folding in these systems by strengthening arene–arene stacking interactions, increasing the enthalpic penalty to misfolding. The architectural changes are substantial even though the chemical perturbation is small: analogous o-phenylene octamers do not fit within macrocycles when perfectly folded, and quantitatively misfold to give small macrocycles regardless of substitution. Taken together, these results represent both a high level of structural control in structurally complex foldamer systems and the demonstration of large-amplitude structural changes as a consequence of a small structural effects.

Extraction, isolation and characterization of Bauhinia variegata flower

2020 ◽  
pp. 9-12
Author(s):  
Akanksha Gupta ◽  
Abhishek K Tripathi ◽  
Pushpraj S Gupta
Keyword(s):  
Biological Activities ◽  
Molecular Formula ◽  
Native Plant ◽  
Compound A ◽  
Active Constituents ◽  
Chromatographic Techniques ◽  
Isolation And Characterization ◽  
Soxhlet Apparatus ◽  
Bauhinia Variegata

Background: Bauhinia variegata Linn. is a native plant of Asia and China. B. variegata is found in tropical regions of the world. It belongs to family Leguminosae. It is used for diarrhea, hemorrhoids, constipation, piles, edema, leprosy, wounds, tumors, etc.  Objective: The objective of the present study was to perform extraction of B. variegata flower and isolation of active constituents from the extract. Materials and Methods: The ethanolic extraction of B. variegata flower was performed using the Soxhlet apparatus. The isolation of active constituents from the extract was performed using chromatographic techniques. In column chromatographic studies, n-hexane- [dichloromethane (DCM)] (2:8) was used as an eluting system and further purified through thin layer chromatography (TLC). Compound A and B were isolated through chromatographic techniques, then the molecular formula and characterization of these compounds were carried out with mass and infrared (IR) spectral analysis. Results and Discussion: The percentage yield of B. variegata ethanolic extract (BVE) was found to be 20.8% w/w. The different fractions were F1 having 12.5 grams with n-hexane, F2 (17.1 grams) with CH2Cl2, F3 (21.2 grams) with EtOAc, and F4 (13.4 grams) with EtOH. Compound A and B were isolated from the solvent fractions of n-hexane-DCM (2:8) and EtOAc-DCM (1:9), respectively. The compound A was characterized as 3-hydroxy-6-methoxy-2-phenyl-4H-chromen-4-one. The compound B was characterized as 3-hydroxy-6-methyl-2-phenyl-4H-chromen-4-one. Conclusion: Thus, B. variegata flowers possess active components that need to identify their biological activities.

Sign in / Sign up

Export Citation Format

Share Document