scholarly journals Non-linear amplification of graded voltage signals in the first-order visual interneurons of the butterflyPapilio xuthus

2018 ◽  
Vol 221 (12) ◽  
pp. jeb179085 ◽  
Author(s):  
Juha Rusanen ◽  
Roman Frolov ◽  
Matti Weckström ◽  
Michiyo Kinoshita ◽  
Kentaro Arikawa
Keyword(s):  
Linear Amplification ◽  
First Order ◽  
Non Linear

scholarly journals Influence of the Porosity of Polymer Foams on the Performances of Capacitive Flexible Pressure Sensors

Sensors ◽  
2019 ◽  
Vol 19 (9) ◽  
pp. 1968 ◽  
Author(s):  
Sylvie Bilent ◽  
Thi Hong Nhung Dinh ◽  
Emile Martincic ◽  
Pierre-Yves Joubert
Keyword(s):  
Experimental Data ◽  
Linear Model ◽  
Dielectric Material ◽  
Pressure Sensors ◽  
Volume Ratio ◽  
Measurement Range ◽  
Polymer Foams ◽  
First Order ◽  
Non Linear ◽  
Flexible Pressure Sensors

This paper reports on the study of microporous polydimethylsiloxane (PDMS) foams as a highly deformable dielectric material used in the composition of flexible capacitive pressure sensors dedicated to wearable use. A fabrication process allowing the porosity of the foams to be adjusted was proposed and the fabricated foams were characterized. Then, elementary capacitive pressure sensors (15 × 15 mm2 square shaped electrodes) were elaborated with fabricated foams (5 mm or 10 mm thick) and were electromechanically characterized. Since the sensor responses under load are strongly non-linear, a behavioral non-linear model (first order exponential) was proposed, adjusted to the experimental data, and used to objectively estimate the sensor performances in terms of sensitivity and measurement range. The main conclusions of this study are that the porosity of the PDMS foams can be adjusted through the sugar:PDMS volume ratio and the size of sugar crystals used to fabricate the foams. Additionally, the porosity of the foams significantly modified the sensor performances. Indeed, compared to bulk PDMS sensors of the same size, the sensitivity of porous PDMS sensors could be multiplied by a factor up to 100 (the sensitivity is 0.14 %.kPa−1 for a bulk PDMS sensor and up to 13.7 %.kPa−1 for a porous PDMS sensor of the same dimensions), while the measurement range was reduced from a factor of 2 to 3 (from 594 kPa for a bulk PDMS sensor down to between 255 and 177 kPa for a PDMS foam sensor of the same dimensions, according to the porosity). This study opens the way to the design and fabrication of wearable flexible pressure sensors with adjustable performances through the control of the porosity of the fabricated PDMS foams.

scholarly journals A secure and highly efficient first-order masking scheme for AES linear operations

Cybersecurity ◽  
2021 ◽  
Vol 4 (1) ◽  
Author(s):  
Jingdian Ming ◽  
Yongbin Zhou ◽  
Huizhong Li ◽  
Qian Zhang
Keyword(s):  
Cost Reduction ◽  
Provable Security ◽  
State Of The Art ◽  
Side Channel ◽  
First Order ◽  
Highly Efficient ◽  
Non Linear ◽  
Device Independence ◽  
Practical Implications ◽  
Provably Secure

AbstractDue to its provable security and remarkable device-independence, masking has been widely accepted as a noteworthy algorithmic-level countermeasure against side-channel attacks. However, relatively high cost of masking severely limits its applicability. Considering the high tackling complexity of non-linear operations, most masked AES implementations focus on the security and cost reduction of masked S-boxes. In this paper, we focus on linear operations, which seems to be underestimated, on the contrary. Specifically, we discover some security flaws and redundant processes in popular first-order masked AES linear operations, and pinpoint the underlying root causes. Then we propose a provably secure and highly efficient masking scheme for AES linear operations. In order to show its practical implications, we replace the linear operations of state-of-the-art first-order AES masking schemes with our proposal, while keeping their original non-linear operations unchanged. We implement four newly combined masking schemes on an Intel Core i7-4790 CPU, and the results show they are roughly 20% faster than those original ones. Then we select one masked implementation named RSMv2 due to its popularity, and investigate its security and efficiency on an AVR ATMega163 processor and four different FPGA devices. The results show that no exploitable first-order side-channel leakages are detected. Moreover, compared with original masked AES implementations, our combined approach is nearly 25% faster on the AVR processor, and at least 70% more efficient on four FPGA devices.

scholarly journals Perception of Auditory Distance in Normal-Hearing and Moderate-to-Profound Hearing-Impaired Listeners

2019 ◽  
Vol 23 ◽  
pp. 233121651988761 ◽  
Author(s):  
Gilles Courtois ◽  
Vincent Grimaldi ◽  
Hervé Lissek ◽  
Philippe Estoppey ◽  
Eleftheria Georganti
Keyword(s):  
Hearing Loss ◽  
Hearing Aids ◽  
Normal Hearing ◽  
Hearing Impaired ◽  
Spatial Cues ◽  
Linear Amplification ◽  
Profound Hearing Loss ◽  
Wireless Microphone ◽  
Auditory Distance ◽  
Non Linear

The auditory system allows the estimation of the distance to sound-emitting objects using multiple spatial cues. In virtual acoustics over headphones, a prerequisite to render auditory distance impression is sound externalization, which denotes the perception of synthesized stimuli outside of the head. Prior studies have found that listeners with mild-to-moderate hearing loss are able to perceive auditory distance and are sensitive to externalization. However, this ability may be degraded by certain factors, such as non-linear amplification in hearing aids or the use of a remote wireless microphone. In this study, 10 normal-hearing and 20 moderate-to-profound hearing-impaired listeners were instructed to estimate the distance of stimuli processed with different methods yielding various perceived auditory distances in the vicinity of the listeners. Two different configurations of non-linear amplification were implemented, and a novel feature aiming to restore a sense of distance in wireless microphone systems was tested. The results showed that the hearing-impaired listeners, even those with a profound hearing loss, were able to discriminate nearby and far sounds that were equalized in level. Their perception of auditory distance was however more contracted than in normal-hearing listeners. Non-linear amplification was found to distort the original spatial cues, but no adverse effect on the ratings of auditory distance was evident. Finally, it was shown that the novel feature was successful in allowing the hearing-impaired participants to perceive externalized sounds with wireless microphone systems.

Testing non-linear amplification factors used in ground motion models

2021 ◽  
Author(s):  
Karina Loviknes ◽  
Danijel Schorlemmer ◽  
Fabrice Cotton ◽  
Sreeram Reddy Kotha
Keyword(s):  
Ground Motion ◽  
Site Effects ◽  
Ground Motions ◽  
Site Amplification ◽  
Building Codes ◽  
Linear Amplification ◽  
Motion Models ◽  
Earthquake Predictability ◽  
Non Linear ◽  
Ground Motion Models

<p>Non-linear site effects are mainly expected for strong ground motions and sites with soft soils and more recent ground-motion models (GMM) have started to include such effects. Observations in this range are, however, sparse, and most non-linear site amplification models are therefore partly or fully based on numerical simulations. We develop a framework for testing of non-linear site amplification models using data from the comprehensive Kiban-Kyoshin network in Japan. The test is reproducible, following the vision of the Collaboratory for the Study of Earthquake Predictability (CSEP), and takes advantage of new large datasets to evaluate <span>whether or not</span> non-linear site effects predicted by site-amplification models are supported by empirical data. The site amplification models are tested using residuals between the observations and predictions from a GMM based only on magnitude and distance. When the GMM is derived without any site term, the site-specific variability extracted from the residuals is expected to capture the site response of a site. The non-linear site amplification models are tested against a linear amplification model on individual well-record<span>ing</span> stations. Finally, the result is compared to building codes where non-linearity is included. The test shows that for most of the sites selected as having sufficient records, the non-linear site-amplification models do not score better than the linear amplification model. This suggests that including non-linear site amplification in GMMs and building codes may not yet be justified, at least not in the range of ground motions considered in the test (peak ground acceleration < 0.2 g).</p>

scholarly journals Internal model controller based PID with fractional filter design for a nonlinear process

2020 ◽  
Vol 10 (1) ◽  
pp. 243
Author(s):  
Hemavathy P.R. ◽  
Mohamed Shuaib Y ◽  
S.K. Lakshmanaprabu
Keyword(s):  
Internal Model ◽  
Process Model ◽  
Filter Design ◽  
Linear Process ◽  
Piecewise Linearization ◽  
Time Model ◽  
First Order ◽  
Non Linear ◽  
Internal Model Controller ◽  
Fractional Filter

In this paper, an Internal model Controller (IMC) based PID with fractional filter for a first order plus time delay process is proposed. The structure of the controller has two parts, one is integer PID controller part cascaded with fractional filter. The proposed controller has two tuning factors λ, filter time constant and a, fractional order of the filter. In this work, the two factors are decided in order to obtain low Integral Time Absolute Error (ITAE). The effectiveness of the proposed controller is studied by considering a non linear (hopper tank) process. The experimental set up is fabricated in the laboratory and then data driven model is developed from the experimental data. The non linear process model is linearised using piecewise linearization and two linear regions are obtained. At each operating point, linear first order plus dead time model is obtained and the controller is designed for the same. To show the practical applicability, the proposed controller is implemented for the proposed experimental laboratory prototype.

scholarly journals Manifold Calculus in System Theory and Control—Fundamentals and First-Order Systems

Symmetry ◽  
2021 ◽  
Vol 13 (11) ◽  
pp. 2092
Author(s):  
Simone Fiori
Keyword(s):  
Control Systems ◽  
Linear Systems ◽  
Linear Control Systems ◽  
First Order ◽  
Curved Manifolds ◽  
Non Linear ◽  
Covariant Derivation ◽  
Non Linear Systems ◽  
And Control

The aim of the present tutorial paper is to recall notions from manifold calculus and to illustrate how these tools prove useful in describing system-theoretic properties. Special emphasis is put on embedded manifold calculus (which is coordinate-free and relies on the embedding of a manifold into a larger ambient space). In addition, we also consider the control of non-linear systems whose states belong to curved manifolds. As a case study, synchronization of non-linear systems by feedback control on smooth manifolds (including Lie groups) is surveyed. Special emphasis is also put on numerical methods to simulate non-linear control systems on curved manifolds. The present tutorial is meant to cover a portion of the mentioned topics, such as first-order systems, but it does not cover topics such as covariant derivation and second-order dynamical systems, which will be covered in a subsequent tutorial paper.

Optimal First-Order Masking with Linear and Non-linear Bijections

2012 ◽  
pp. 360-377 ◽  
Author(s):  
Houssem Maghrebi ◽  
Claude Carlet ◽  
Sylvain Guilley ◽  
Jean-Luc Danger
Keyword(s):  
First Order ◽  
Non Linear
Sign in / Sign up

Export Citation Format

Share Document