Predicting the vortex shedding frequency at an open-channel lateral cavity

2020 ◽  
pp. 68-75
Author(s):  
C. Perrot-Minot ◽  
E. Mignot ◽  
N. Riviere ◽  
D. Lopez
Keyword(s):  
Vortex Shedding ◽  
Open Channel ◽  
Lateral Cavity ◽  
Vortex Shedding Frequency ◽  
Shedding Frequency

Vortex shedding frequency in open-channel lateral cavity

2020 ◽  
Vol 892 ◽  
Author(s):  
C. Perrot-Minot ◽  
E. Mignot ◽  
R. Perkins ◽  
D. Lopez ◽  
N. Riviere
Keyword(s):  
Vortex Shedding ◽  
Open Channel ◽  
Lateral Cavity ◽  
Vortex Shedding Frequency ◽  
Shedding Frequency ◽  
Image Position

scholarly journals Predicting the vortex shedding frequency at the interface of the lateral cavities

2018 ◽  
Vol 40 ◽  
pp. 05011 ◽  
Author(s):  
Clément Perrot-Minot ◽  
Emmanuel Mignot ◽  
Nicolas Riviere ◽  
Richard Perkins
Keyword(s):  
Gravity Waves ◽  
Water Depth ◽  
Vortex Shedding ◽  
Mixing Layer ◽  
Main Stream ◽  
Depth Variation ◽  
Lateral Cavity ◽  
Vortex Shedding Frequency ◽  
Shedding Frequency ◽  
Increasing Trends

The vortex shedding frequency in the mixing layer between a cavity and a main stream has been examined experimentally in absence of large oscillation of the free surface inside the cavity, called seiching. It was observed that the vortex shedding frequency follows a monotonically increasing trends with possible jumps from one to another with increasing Froude number of the main stream. These trends are obtained by solving a model based on the Rossiter approach. This model considers that the vortices shed in the mixing layer create some water depth variation at the impingement corner of the cavity. This water depth variation in turn generate pressure waves that propagates upstream and influence the vortex shedding process. Finally the measured vortex shedding frequencies correspond quite accurately to the frequencies predicted by the model. This highlights the existence of a resonant phenomena between vortices in the mixing layer of a lateral cavity and gravity waves even without any seiching phenomena.

The Influence of Boundary Layer Velocity Gradients and Bed Proximity on Vortex Shedding From Free Spanning Pipelines

1984 ◽  
Vol 106 (1) ◽  
pp. 70-78 ◽  
Author(s):  
A. J. Grass ◽  
P. W. J. Raven ◽  
R. J. Stuart ◽  
J. A. Bray
Keyword(s):  
Boundary Layer ◽  
Strouhal Number ◽  
Vortex Shedding ◽  
Combined Effects ◽  
Maximum Increase ◽  
Velocity Gradients ◽  
Large Velocity ◽  
Layer Velocity ◽  
Vortex Shedding Frequency ◽  
Shedding Frequency

The paper summarizes the results of a laboratory study of the separate and combined effects of bed proximity and large velocity gradients on the frequency of vortex shedding from pipeline spans immersed in the thick boundary layers of tidal currents. This investigation forms part of a wider project concerned with the assessment of span stability. The measurements show that in the case of both sheared and uniform approach flows, with and without velocity gradients, respectively, the Strouhal number defining the vortex shedding frequency progressively increases as the gap between the pipe base and the bed is reduced below two pipe diameters. The maximum increase in vortex shedding Strouhal number, recorded close to the bed in an approach flow with large velocity gradients, was of the order of 25 percent.

An Experimental Study on the Vertical Flow Past a Finite-Length Horizontal Cylinder at Low Reynolds Numbers

2014 ◽  
Vol 493 ◽  
pp. 68-73 ◽  
Author(s):  
Willy Stevanus ◽  
Yi Jiun Peter Lin
Keyword(s):  
Finite Length ◽  
Vortex Shedding ◽  
Vortex Formation ◽  
Reynolds Numbers ◽  
Horizontal Cylinder ◽  
Vortex Street ◽  
Vertical Flow ◽  
Low Reynolds Numbers ◽  
Vortex Shedding Frequency ◽  
Shedding Frequency

The research studies the characteristics of the vertical flow past a finite-length horizontal cylinder at low Reynolds numbers (ReD) from 250 to 1080. The experiments were performed in a vertical closed-loop water tunnel. Flow fields were observed by the particle tracer approach for flow visualization and measured by the Particle Image Velocimetry (P.I.V.) approach for velocity fields. The characteristics of vortex formation in the wake of the finite-length cylinder change at different regions from the tip to the base of it. Near the tip, a pair of vortices in the wake was observed and the size of the vortex increased as the observed section was away from the tip. Around a distance of 3 diameters of the cylinder from its tip, the vortex street in the wake was observed. The characteristics of vortex formation also change with increasing Reynolds numbers. At X/D = -3, a pair of vortices was observed in the wake for ReD = 250, but as the ReD increases the vortex street was observed at the same section. The vortex shedding frequency is analyzed by Fast Fourier Transform (FFT). Experimental results show that the downwash flow affects the vortex shedding frequency even to 5 diameters of the cylinder from its tip. The interaction between the downwash flow and the Von Kármán vortex street in the wake of the cylinder is presented in this paper.

Vortex-Induced Vibration for Heat Transfer Enhancement

2014 ◽  
Author(s):  
Junxiang Shi ◽  
Steven R. Schafer ◽  
Chung-Lung (C. L. ) Chen
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Heat Transfer Enhancement ◽  
Natural Frequency ◽  
Vortex Shedding ◽  
Pressure Loss ◽  
Thermal Boundary Layer ◽  
Transfer Enhancement ◽  
Vortex Shedding Frequency ◽  
Shedding Frequency

A passive, self-agitating method which takes advantage of vortex-induced vibration (VIV) is presented to disrupt the thermal boundary layer and thereby enhance the convective heat transfer performance of a channel. A flexible cylinder is placed at centerline of a channel. The vortex shedding due to the presence of the cylinder generates a periodic lift force and the consequent vibration of the cylinder. The fluid-structure-interaction (FSI) due to the vibration strengthens the disruption of the thermal boundary layer by reinforcing vortex interaction with the walls, and improves the mixing process. This novel concept is demonstrated by a three-dimensional modeling study in different channels. The fluid dynamics and thermal performance are discussed in terms of the vortex dynamics, disruption of the thermal boundary layer, local and average Nusselt numbers (Nu), and pressure loss. At different conditions (Reynolds numbers, channel geometries, material properties), the channel with the VIV is seen to significantly increase the convective heat transfer coefficient. When the Reynolds number is 168, the channel with the VIV improves the average Nu by 234.8% and 51.4% in comparison with a clean channel and a channel with a stationary cylinder, respectively. The cylinder with the natural frequency close to the vortex shedding frequency is proved to have the maximum heat transfer enhancement. When the natural frequency is different from the vortex shedding frequency, the lower natural frequency shows a higher heat transfer rate and lower pressure loss than the larger one.

Applicability of The Equivalent Diameter Approach to Estimate Vortex Shedding Frequency and Acoustic Resonance Excitation From Different Finned Cylinders In Cross-Flow

2021 ◽  
Author(s):  
Mohammed Alziadeh ◽  
Atef Mohany
Keyword(s):  
Strouhal Number ◽  
Vortex Shedding ◽  
Interaction Mechanism ◽  
Acoustic Resonance ◽  
Resonance Excitation ◽  
Equivalent Diameter ◽  
Effective Diameter ◽  
Finned Tubes ◽  
Vortex Shedding Frequency ◽  
Shedding Frequency

Abstract This article explores the applicability of utilizing different equivalent diameter (Deq) equations to estimate the vortex shedding frequency and onset of self-excited acoustic resonance for various types of finned cylinders. The focus is on three finned cylinder types that are commonly used in industrial heat exchangers: straight, twist-serrated, and crimped spirally finned cylinders. Within each type of fins, at least three different finned cylinders are investigated. The results indicate that at off-resonance conditions, utilizing the appropriate equivalent diameter collapses the Strouhal number data within the typical Strouhal number variations of an equivalent diameter circular, bare cylinder. However, when acoustic resonance is initiated, the onset and the peak of resonance excitation in all of the finned cylinder cases generally occurred at a reduced flow velocity earlier than that observed from their equivalent diameter bare cylinders. This suggests that although utilizing the appropriate equivalent diameter can reasonably estimate the vortex shedding frequency away from acoustic resonance excitation, it cannot be used to predict the onset of acoustic resonance in finned tubes. The findings of this study indicate that the effective diameter approach is not sufficient to capture the intrinsic changes in the flow-sound interaction mechanism as a result of adding fins to a bare cylinder. Thus, a revision of the acoustic Strouhal number charts is required for finned tubes of different types and arrangements.

Flow past a rotationally oscillating cylinder

2013 ◽  
Vol 735 ◽  
pp. 307-346 ◽  
Author(s):  
S. Kumar ◽  
C. Lopez ◽  
O. Probst ◽  
G. Francisco ◽  
D. Askari ◽  
...  
Keyword(s):  
Reynolds Number ◽  
Vortex Shedding ◽  
Three Dimensional ◽  
Far Field ◽  
Two Dimensional ◽  
Flow Past ◽  
Vortex Shedding Frequency ◽  
Shedding Frequency ◽  
Flow Visualizations ◽  
Hydrogen Bubble Technique

AbstractFlow past a circular cylinder executing sinusoidal rotary oscillations about its own axis is studied experimentally. The experiments are carried out at a Reynolds number of 185, oscillation amplitudes varying from $\mathrm{\pi} / 8$ to $\mathrm{\pi} $, and at non-dimensional forcing frequencies (ratio of the cylinder oscillation frequency to the vortex-shedding frequency from a stationary cylinder) varying from 0 to 5. The diagnostic is performed by extensive flow visualization using the hydrogen bubble technique, hot-wire anemometry and particle-image velocimetry. The wake structures are related to the velocity spectra at various forcing parameters and downstream distances. It is found that the phenomenon of lock-on occurs in a forcing frequency range which depends not only on the amplitude of oscillation but also the downstream location from the cylinder. The experimentally measured lock-on diagram in the forcing amplitude and frequency plane at various downstream locations ranging from 2 to 23 diameters is presented. The far-field wake decouples, after the lock-on at higher forcing frequencies and behaves more like a regular Bénard–von Kármán vortex street from a stationary cylinder with vortex-shedding frequency mostly lower than that from a stationary cylinder. The dependence of circulation values of the shed vortices on the forcing frequency reveals a decay character independent of forcing amplitude beyond forcing frequency of ${\sim }1. 0$ and a scaling behaviour with forcing amplitude at forcing frequencies ${\leq }1. 0$. The flow visualizations reveal that the far-field wake becomes two-dimensional (planar) near the forcing frequencies where the circulation of the shed vortices becomes maximum and strong three-dimensional flow is generated as mode shape changes in certain forcing parameter conditions. It is also found from flow visualizations that even at higher Reynolds number of 400, forcing the cylinder at forcing amplitudes of $\mathrm{\pi} / 4$ and $\mathrm{\pi} / 2$ can make the flow field two-dimensional at forcing frequencies greater than ${\sim }2. 5$.

Vortex Shedding Induced Dynamic Response of Marine Risers

1984 ◽  
Vol 106 (2) ◽  
pp. 214-221 ◽  
Author(s):  
F. Rajabi ◽  
M. F. Zedan ◽  
A. Mangiavacchi
Keyword(s):  
Dynamic Response ◽  
Vortex Shedding ◽  
Equation Of Motion ◽  
Continuous Beam ◽  
Regular Waves ◽  
Empirical Correlations ◽  
Fluid Resistance ◽  
Vortex Shedding Frequency ◽  
Shedding Frequency ◽  
Lock In

An analytical model to predict the dynamic response of a riser in regular waves or in current to vortex shedding-induced lift forces is described. The riser is treated as a continuous beam under tension. A modal superposition scheme is used to solve the linearized equation of motion in the frequency domain. The excitation lift force is represented by a harmonic function with a frequency equal to the dominant vortex shedding frequency. Empirical correlations are used to determine the lift coefficients and shedding frequencies along the riser. Lift amplification is considered at or near the “lock-in” conditions. The fluid resistance to riser oscillations is represented by a Morison’s equation-type expression.

Wind Tunnel Study of Vortex Shedding behind Cooling Tower Models

2014 ◽  
Vol 617 ◽  
pp. 280-284
Author(s):  
Petr Michálek ◽  
David Zacho
Keyword(s):  
Wind Tunnel ◽  
Vortex Shedding ◽  
Cooling Tower ◽  
Time Signal ◽  
Hot Wire ◽  
Model Surface ◽  
Surface Measurements ◽  
Vortex Shedding Frequency ◽  
Shedding Frequency ◽  
Wind Tunnel Study

Wind tunnel measurements of vortex shedding behind cooling tower models were performed in VZLU. Two variants of cooling tower models were used, i.e. model with smooth wall outer surface and model with rough wall surface. Measurements were conducted using hot-wire anemometer. Time signal from the anemometer was transformed using Fast-Fourier routine into frequency spectrum. Measurements have shown significant differences between smooth and rough variant of model surface and dependency of vortex shedding frequency on Reynolds number.

Sign in / Sign up

Export Citation Format

Share Document