A method to minimize the number of nodes maintaining water surface coverage by solar energy generation

2015 ◽  
pp. 1131-1137
Author(s):  
Hirotaka Ueno ◽  
Ryo Katsuma
Keyword(s):  
Solar Energy ◽  
Water Surface ◽  
Surface Coverage ◽  
Energy Generation

scholarly journals Up and Down Conversion of Photons with modified Perturb and Observe MPPT technique for Efficient Solar Energy Generation

2017 ◽  
Vol 117 ◽  
pp. 786-793 ◽  
Author(s):  
Atul Manmohan ◽  
Akhil Prasad ◽  
Ravi Dharavath ◽  
S. Prabhakar Karthikeyan ◽  
I. Jacob Raglend
Keyword(s):  
Solar Energy ◽  
Energy Generation ◽  
Perturb And Observe ◽  
Down Conversion

Parabolic Solar Collector Coverage Made of High-Performance Concrete with Addition of Active Rice Husk Silica Integrated to a Biomass Thermoelectric Unit

2014 ◽  
Vol 634 ◽  
pp. 72-82
Author(s):  
Rosa Ana Conte ◽  
Daltro Garcia Pinatti ◽  
Luiz Fernando M. Marton ◽  
Sebastião Ribeiro ◽  
Thaís Witt Acosta ◽  
...  
Keyword(s):  
Solar Energy ◽  
Rice Husk ◽  
Solar Collector ◽  
High Performance ◽  
High Performance Concrete ◽  
Electrical Energy ◽  
Energy Generation ◽  
Boiler Water ◽  
Rice Husk Silica ◽  
Short Rotation

Production of active rice husk silica (ARHS) in bubbling fluidized bed boiler of a thermoelectric unit (TEU) and its addition to high performance concrete (HPC) with a compression resistance of 90 MPa was developed in the last 10 years. A first factory in Brazil was established at Alegrete town, RS, and other factories are under planning. Data of ARHS production, specification and HPC trace are presented. Design of parabolic solar collector coverage (PSCC) for air heating for biomass drying in a special silo of the TEU is presented as well. Cost of HPC/ARHS is 10 times less than steel (USD 200/ton vs. USD 2000/ton, specific mass 2.5 vs. 7.6 g/cm3, respectively). Those characteristics allow simultaneous solution of four ecological problems: large span coverage, rain water collection, daily solar energy collection and storage, and drying of biomass. The integration of those characteristics results in decrease of biomass consumption maintaining the same UTE efficiency. Tracking parabolic solar collector can be avoided between Cancer and Capricorn Tropics, and it is sufficient its eastern-western orientation with inclination to the Equator by the latitude angle. Coverage of the area occupied by TEU is sufficient to dry its biomass consumption. Preheating of boiler water with solar energy is possible decreasing biomass consumption in sunny days; biomass is partially consummed at night and cloudy days. Coupling the above technologies with high pressure steam TEU and fast-growing short-rotation forest gives to the biomass electrical energy generation a competitive economical position with hydraulic, coal, natural gas, and aeolic energy generation.

scholarly journals Distributed generation of photovoltaic solar energy: impacts of ANEEL`s new regulation proposal on investment attractiveness

2021 ◽  
Vol 14 (2) ◽  
pp. 423-442
Author(s):  
Diego Silva Cardoso ◽  
Pedro Sartori Locatelli ◽  
Wanderley Ramalho ◽  
Nader Asgary
Keyword(s):  
Solar Energy ◽  
Distributed Generation ◽  
Energy Generation ◽  
Legal Framework ◽  
Government Policies ◽  
Solar Irradiation ◽  
Industrial Plant ◽  
The Subject ◽  
Photovoltaic Solar Energy ◽  
Practical Implications

Purpose – The production of photovoltaic solar energy has gained international prominence, being the subject of government policies aimed at its development. The purpose of this study is to analyze the profitability of a shared photovoltaic solar energy project, located in the national territory, resulting from changes in regulatory framework of the sector represented by different tariff levels.Design/methodology/approach – It is a quantitative study based on corporate finance as its theoretical-conceptual substrate. Simulations were carried out using different energy price and tariff scenarios.Findings - The results reveal that, under current conditions, distributed photovoltaic solar energy generation is financially very attractive to investors. In addition, it was found that significant changes in the tariff regime for this type of energy might prevent new investments in the segment. Practical implications – The evidence suggests caution in changing the legal framework of a segment that is still incipient in the country, which generates clean and renewable energy, and with enormous growth potential.Originality/value - The study presents, in a systematic way, the possible impacts of changes in the price and tariff scenarios on the attractiveness of investment in the distributed generation of photovoltaic solar energy generation. In this sense, it can be easily adapted to evaluate industrial plant projects of different sizes in regions with distinct levels of solar irradiation.           

scholarly journals ANÁLISE DOS PARÂMETROS PARA GERAÇÃO DE ENERGIA SOLAR FOTOVOLTAICA NO ACRE, BRASIL

2021 ◽  
Vol 7 (20) ◽  
pp. 202129
Author(s):  
Vivyane Alencar Marques Araújo do Nascimento ◽  
Taynara Bastos Trindade ◽  
Clarice Maia Carvalho
Keyword(s):  
Solar Energy ◽  
Electrical Energy ◽  
Energy Generation ◽  
Photovoltaic Cell ◽  
Solar Irradiation ◽  
Solar Panels ◽  
Cell Temperature ◽  
Photovoltaic Efficiency ◽  
Photovoltaic Solar Energy ◽  
Insolation Maximum

ANALYSIS OF PARAMETERS FOR PHOTOVOLTAIC SOLAR ENERGY GENERATION IN ACRE, BRAZILANÁLISIS DE PARÁMETROS PARA LA GENERACIÓN DE ENERGÍA SOLAR FOTOVOLTAICA EN ACRE, BRASILRESUMOEnergia solar é obtida através de placas solares fotovoltaicas com a função de captar a energia do sol e transformar em energia elétrica, aumentando a geração de energia solar nas regiões com maior captação de energia luminosa. Assim, neste artigo analisou-se os parâmetros para geração de energia solar fotovoltaica no Acre, Brasil. Coletou-se dados referentes a insolação, temperaturas máximas e mínimas, precipitação e umidade relativa no Instituto Nacional de Meteorologia, irradiação solar, no Centro de Referências para Energias Solar e Eólica Sérgio de S. Brito, regionais do Vale do Juruá e Vale do Acre, no período de 2015-2020. As análises foram quantitativas, utilizando o cálculo da média e cálculo do plano inclinado. Na comparação das regionais, o Vale do Acre apresentou melhores resultados para geração de energia solar e com um ângulo com a maior média diária anual de irradiação solar, considerando-se projetar-se células fotovoltaicas na regional. O trabalho apresenta que o Acre possui bastante insolação e irradiação solar, indicando alto potencial de geração de energia solar para as regionais do estado.Palavras-chave: Eficiência Fotovoltaica; Radiação Solar; Temperatura da Célula Fotovoltaica; Irradiação.ABSTRACTSolar energy is obtained through photovoltaic solar panels with the function of capturing the sun's energy and transforming it into electrical energy, increasing the generation of solar energy in regions with greater capture of light energy. Thus, the parameters for the generation of photovoltaic solar energy in Acre, Brazil were analyzed. Data on insolation, maximum and minimum temperatures, precipitation and relative humidity were collected at the National Institute of Meteorology, solar irradiation, at the Reference Center for Solar and Wind Energy Sérgio de S. Brito, regions of Vale do Juruá and Vale do Acre, in the period 2015-2020. Analyzes were quantitative, using mean calculation and inclined plane calculation. When comparing the regions, Vale do Acre presented better results for solar energy generation and with an angle with the highest annual daily average of solar irradiation, considering the project of photovoltaic cells in the region. The work shows that Acre has a lot of insolation and solar irradiation, indicating a high potential for generating solar energy for the regional regions of the state.Keywords: Photovoltaic Efficiency; Solar Radiation; Photovoltaic Cell Temperature; Irradiation.RESUMENLa energía solar se obtiene a través de paneles solares fotovoltaicos con la función de captar la energía del sol y transformarla en energía eléctrica, aumentando la generación de energía solar en las regiones con mayor captación de energía luminosa. Así, se analizaron los parámetros para la generación de energía solar fotovoltaica en Acre, Brasil. Los datos sobre insolación, temperaturas máximas y mínimas, precipitación y humedad relativa fueron recolectados en el Instituto Nacional de Meteorología, irradiación solar, en el Centro de Referencia de Energía Solar y Eólica Sérgio de S. Brito, regiones de Vale do Juruá y Vale do Acre, en el período 2015-2020. Los análisis fueron cuantitativos, utilizando cálculo de medias y cálculo de plano inclinado. Al comparar las regiones, Vale do Acre presentó mejores resultados para la generación de energía solar y con un ángulo con el promedio diario anual más alto de irradiación solar, considerando el diseño de células fotovoltaicas en la región. El trabajo muestra que Acre tiene mucha insolación e irradiación solar, lo que indica un alto potencial de generación de energía solar para las regiones regionales del estado.Palabras clave: Eficiencia Fotovoltaica; Radiación Solar; Temperatura de la Celda Fotovoltaica; Irradiación.

scholarly journals Solar Energy Generation Using Agriculture Cultivated Lands

2014 ◽  
Vol 05 (02) ◽  
pp. 31-42 ◽  
Author(s):  
T. Harinarayana ◽  
K. Sri Venkata Vasavi
Keyword(s):  
Solar Energy ◽  
Energy Generation

Solar Energy Generation and Internet of Energy (IoE)

2021 ◽  
pp. 175-191
Author(s):  
Sanghita Baidya ◽  
Champa Nandi
Keyword(s):  
Solar Energy ◽  
Energy Generation

scholarly journals An Optimization-Based Supervisory Control and Coordination Approach for Solar-Load Balancing in Building Energy Management

Mathematics ◽  
2020 ◽  
Vol 8 (8) ◽  
pp. 1215
Author(s):  
James Allen ◽  
Ari Halberstadt ◽  
John Powers ◽  
Nael H. El-Farra
Keyword(s):  
Solar Energy ◽  
Energy Use ◽  
Weather Forecasting ◽  
Energy Generation ◽  
Building Energy ◽  
Objective Functions ◽  
Forecasting Accuracy ◽  
Electricity Cost ◽  
The Impact ◽  
Building Loads

This work considers the problem of reducing the cost of electricity to a grid-connected commercial building that integrates on-site solar energy generation, while at the same time reducing the impact of the building loads on the grid. This is achieved through local management of the building’s energy generation-load balance in an effort to increase the feasibility of wide-scale deployment and integration of solar power generation into commercial buildings. To realize this goal, a simulated building model that accounts for on-site solar energy generation, battery storage, electrical vehicle (EV) charging, controllable lighting, and air conditioning is considered, and a supervisory model predictive control (MPC) system is developed to coordinate the building’s generation, loads and storage systems. The main aim of this optimization-based approach is to find a reasonable solution that minimizes the economic cost to the electricity user, while at the same time reducing the impact of the building loads on the grid. To assess this goal, three objective functions are selected, including the peak building load, the net building energy use, and a weighted sum of both the peak load and net energy use. Based on these objective functions, three MPC systems are implemented on the simulated building under scenarios with varying degrees of weather forecasting accuracy. The peak demand, energy cost, and electricity cost are compared for various forecast scenarios for each MPC system formulation, and evaluated in relation to a rules-based control scheme. The MPC systems tested the rules-based scheme based on simulations of a month-long electricity consumption. The performance differences between the individual MPC system formulations are discussed in the context of weather forecasting accuracy, operational costs, and how these impact the potential of on-site solar generation and potential wide-spread solar penetration.

Sign in / Sign up

Export Citation Format

Share Document