Influence of vegetated bed material on erosional patterns of meandering rivers: Preliminary experimental results

2014 ◽  
pp. 453-460
Author(s):  
D Termini
Keyword(s):  
Experimental Results ◽  
Meandering Rivers ◽  
Bed Material

scholarly journals THE EFFECT OF ARTIFICIAL SEAWEED IN PROMOTING THE BUILD-UP OF BEACHES

1968 ◽  
Vol 1 (11) ◽  
pp. 36 ◽  
Author(s):  
W.A. Price ◽  
K.W. Tomlinson ◽  
J.N. Hunt
Keyword(s):  
Wave Propagation ◽  
Mass Transport ◽  
Gravity Waves ◽  
Hydrodynamic Model ◽  
Wave Attenuation ◽  
Field Trials ◽  
Experimental Results ◽  
Wave Tank ◽  
Bed Material

The paper describes tests carried out m the laboratory and in the field in an attempt to discover whether a field of artificial seaweed placed offshore can promote an onshore transport of bed material and hence a build-up of beach levels. Tests in a wave tank showed that beach levels could be built up in this way - the effect of the seaweed being to increase the net drift of bed water m the direction of wave propagation i.e. towards the shore. The field trials were not as conclusive as was hoped, but nevertheless some build-up of beach levels did take place at a time when erosion of the beach due to many storms might have been anticipated. A simple hydrodynamic model is proposed to represent the effect of artificial seaweed on gravity waves. The model predicts increased wave attenuation and increased shoreward mass-transport consistent with the experimental results.

scholarly journals Capture of SO2 by limestone in a 71 MWe pressurized fluidized bed boiler

2003 ◽  
Vol 7 (1) ◽  
pp. 17-31 ◽  
Author(s):  
Tadaaki Shimizu ◽  
Mirko Peglow ◽  
Kazuaki Yamagiwa ◽  
Masato Tanaka ◽  
Shinichi Sakuno ◽  
...  
Keyword(s):  
Mathematical Model ◽  
Fly Ash ◽  
Fluidized Bed ◽  
Present Model ◽  
Experimental Results ◽  
Attrition Rate ◽  
Simple Mathematical Model ◽  
Bed Material

A 71 MWe pressurized fluidized bed coal combustor was operated. A wide variety of coals were burnt under fly ash recycle conditions. Limestone was fed to the combustor as bed material as well as sorbent. The emission of SO^ and limestone attrition rate were measured. A simple mathematical model of SO? capture by limestone with intermittent solid attrition was applied to the analysis of the present experimental results. Except for high sulfur fuel, the results of the present model agreed with the experimental results.

scholarly journals A Study of Fluctuation and Expansion Ratios for Gas-Solid Fluidized Columns

2020 ◽  
Vol 26 (10) ◽  
pp. 15-34
Author(s):  
Maha MuhyiAlwanA Alhussaini ◽  
Hassanain Abbas Hassan ◽  
Nada Sadoon Ahmedzeki
Keyword(s):  
Experimental Results ◽  
Correlation Equations ◽  
Direct Relation ◽  
Column Diameter ◽  
Air Velocity ◽  
Minimum Fluidization Velocity ◽  
Bed Height ◽  
Bed Material ◽  
Fluidizing Medium ◽  
Good Agreement

The fluctuation and expansion ratios have been studied for cylindrical gas-solid fluidized columns by using air as fluidizing medium and Paracetamol as the bed material. The variables were the column diameter (0.0762, 0.15, and 0.18 m), static bed height (0.05, 0.07, and 0.09 m), and air velocity to several times of minimum fluidization velocity. The results showed that both the fluctuation and expansion ratios had a direct relation with air velocity and an inverse one with column diameter and static bed height. A good agreement was between the experimental results and the calculated values by using the correlation equations from the literature.

Diagnostics of Gold Laser Plasmas

1988 ◽  
Vol 102 ◽  
pp. 357-360
Author(s):  
J.C. Gauthier ◽  
J.P. Geindre ◽  
P. Monier ◽  
C. Chenais-Popovics ◽  
N. Tragin ◽  
...  
Keyword(s):  
Experimental Results ◽  
Pure Gold ◽  
Electronic Temperature ◽  
X Ray ◽  
Laser Plasmas ◽  
Collisional Radiative Model ◽  
Radiative Model

AbstractIn order to achieve a nickel-like X ray laser scheme we need a tool to determine the parameters which characterise the high-Z plasma. The aim of this work is to study gold laser plasmas and to compare experimental results to a collisional-radiative model which describes nickel-like ions. The electronic temperature and density are measured by the emission of an aluminium tracer. They are compared to the predictions of the nickel-like model for pure gold. The results show that the density and temperature can be estimated in a pure gold plasma.

Observation of Phase Contrast Images in STEM and CTEM Modes by Using 100 kV Field Emission Electron Gun

1974 ◽  
Vol 32 ◽  
pp. 390-391
Author(s):  
Y. Harada ◽  
T. Goto ◽  
H. Koike ◽  
T. Someya
Keyword(s):  
Field Emission ◽  
Phase Contrast ◽  
Image Formation ◽  
Fresnel Diffraction ◽  
Experimental Results ◽  
Electron Gun ◽  
Scanning Microscopy ◽  
Emission Electron ◽  
Lattice Images

Since phase contrasts of STEM images, that is, Fresnel diffraction fringes or lattice images, manifest themselves in field emission scanning microscopy, the mechanism for image formation in the STEM mode has been investigated and compared with that in CTEM mode, resulting in the theory of reciprocity. It reveals that contrast in STEM images exhibits the same properties as contrast in CTEM images. However, it appears that the validity of the reciprocity theory, especially on the details of phase contrast, has not yet been fully proven by the experiments. In this work, we shall investigate the phase contrast images obtained in both the STEM and CTEM modes of a field emission microscope (100kV), and evaluate the validity of the reciprocity theory by comparing the experimental results.

A new dissociation mode for dislocations in silicon

1978 ◽  
Vol 36 (1) ◽  
pp. 346-347
Author(s):  
A. Ourmazd ◽  
G.R. Booker ◽  
C.J. Humphreys
Keyword(s):  
Detailed Examination ◽  
Experimental Results ◽  
Dislocation Network ◽  
Weak Beam ◽  
Phosphorus Doped

A (111) phosphorus-doped Si specimen, thinned to give a TEM foil of thickness ∼ 150nm, contained a dislocation network lying on the (111) plane. The dislocation lines were along the three <211> directions and their total Burgers vectors,ḇt, were of the type , each dislocation being of edge character. TEM examination under proper weak-beam conditions seemed initially to show the standard contrast behaviour for such dislocations, indicating some dislocation segments were undissociated (contrast A), while other segments were dissociated to give two Shockley partials separated by approximately 6nm (contrast B) . A more detailed examination, however, revealed that some segments exhibited a third and anomalous contrast behaviour (contrast C), interpreted here as being due to a new dissociation not previously reported. Experimental results obtained for a dislocation along [211] with for the six <220> type reflections using (g,5g) weak-beam conditions are summarised in the table below, together with the relevant values.

Multislice calculations of RHEED patterns from vicinal Si (001)

1993 ◽  
Vol 51 ◽  
pp. 1000-1001
Author(s):  
Scott Lordi
Keyword(s):  
Misorientation Angle ◽  
Incident Angle ◽  
Incident Beam ◽  
Experimental Results ◽  
Bragg Condition ◽  
Vicinal Surfaces ◽  
Kinematic Theory ◽  
Step Edges

Vicinal Si (001) surfaces are interesting because they are good substrates for the growth of III-V semiconductors. Spots in RHEED patterns from vicinal surfaces are split due to scattering from ordered step arrays and this splitting can be used to determine the misorientation angle, using kinematic arguments. Kinematic theory is generally regarded to be inadequate for the calculation of RHEED intensities; however, only a few dynamical RHEED simulations have been attempted for vicinal surfaces. The multislice formulation of Cowley and Moodie with a recently developed edge patching method was used to calculate RHEED patterns from vicinal Si (001) surfaces. The calculated patterns are qualitatively similar to published experimental results and the positions of the split spots quantitatively agree with kinematic calculations.RHEED patterns were calculated for unreconstructed (bulk terminated) Si (001) surfaces misoriented towards [110] ,with an energy of 15 keV, at an incident angle of 36.63 mrad ([004] bragg condition), and a beam azimuth of [110] (perpendicular to the step edges) and the incident beam pointed down the step staircase.

Appropriation des Savoirs et Mémoire Collective

2013 ◽  
Vol 72 (2) ◽  
pp. 71-78
Author(s):  
Sophie Richardot
Keyword(s):  
Collective Memory ◽  
Factorial Analysis ◽  
Experimental Results ◽  
Ancient History ◽  
Historical Events ◽  
Memoire Collective ◽  
Obedience To Authority

The aim of this study is to understand to what extent soliciting collective memory facilitates the appropriation of knowledge. After being informed about Milgram’s experiment on obedience to authority, students were asked to mention historical or contemporary events that came to mind while thinking about submission to authority. Main results of the factorial analysis show that the students who do not believe in the reproducibility of the experimental results oppose dramatic past events to a peaceful present, whereas those who do believe in the reproducibility of the results also mention dramatic contemporary events, thus linking past and present. Moreover, the students who do not accept the results for today personify historical events, whereas those who fully accept them generalize their impact. Therefore, according to their attitude toward this objet of knowledge, the students refer to two kinds of memory: a “closed memory,” which tends to relegate Milgram’s results to ancient history; and an “open memory,” which, on the contrary, transforms past events into a concept that helps them understand the present. Soliciting collective memory may contribute to the appropriation of knowledge provided the memory activated is an “open” one, linking past to present and going beyond the singularity of the event.

Sign in / Sign up

Export Citation Format

Share Document