IFC-based product modeling for tunnel boring machines

2012 ◽  
pp. 289-296 ◽  
Author(s):  
F Hegemann ◽  
K Lehner ◽  
M König
Keyword(s):  
Product Modeling ◽  
Tunnel Boring Machines ◽  
Tunnel Boring ◽  
Boring Machines

scholarly journals Advancement simulation of tunnel boring machines

2012 ◽  
Author(s):  
Tobias Rahm ◽  
Kambiz Sadri ◽  
Christian Koch ◽  
Markus Thewes ◽  
Markus Konig
Keyword(s):  
Tunnel Boring Machines ◽  
Tunnel Boring ◽  
Boring Machines

scholarly journals The Preparation of H13 Steel for TBM Cutter and the Performance Test Close to Working Condition

2018 ◽  
Vol 8 (10) ◽  
pp. 1877 ◽  
Author(s):  
Yong Hu ◽  
Jiyu Tian ◽  
Mingxu Xu ◽  
Hongwei Zhao ◽  
Mingze Wang ◽  
...  
Keyword(s):  
Compression Strength ◽  
Performance Test ◽  
Working Condition ◽  
H13 Steel ◽  
Tunnel Boring Machines ◽  
Tunnel Boring ◽  
Disc Cutters ◽  
Boring Machines ◽  
Full Face ◽  
Tbm Cutter

The material of disc cutters is important to full-face tunnel boring machines (TBM). In recent years, disc cutters were optimized and tested by many scholars all around the world. H13(4Cr5MoSiV1) steel is widely used due to its excellent properties, especially in TBM disc cutters. In this paper, H13 steel with optimized composition was prepared and heat treatment. The high temperature compression of H13 steel was conducted at the temperatures ranging from 100 °C to 700 °C, with strain rate at 0.01 s−1. The stress-strain curves, Rockwell hardness and microstructure of H13 steel after compression were obtained and analyzed. The results showed that the compression strength and hardness decreased as the temperature increased; and the compression strength, hardness and ductility decreased rapidly between 600 °C and 700 °C, HR700 (the hardness of H13 steel at 700 °C) only reached 33.23 HRC. It is not recommended for TBM disc cutters to work in an environment over 600 °C.

Sign in / Sign up

Export Citation Format

Share Document