scholarly journals Rotor performance enhancement through blade surging

2019 ◽  
Vol 11 ◽  
pp. 175682931984427
Author(s):  
T Bensebaa ◽  
T Jardin ◽  
S Prothin ◽  
N Doue
Keyword(s):  
Large Scale ◽  
Performance Enhancement ◽  
Leading Edge ◽  
Aerodynamic Performance ◽  
Short Paper ◽  
Optimal Frequency ◽  
Leading Edge Vortex ◽  
Disk Plane ◽  
Edge Vortex ◽  
Rotor Disk

This short paper introduces a new concept of rotor where the blades undergo a periodic surging motion in the rotor disk plane. It is shown that the unsteady actuation induces aerodynamic phenomenon that can enhance both rotor thrust and efficiency, depending on the amplitude and frequency of actuation. In particular, the increase in aerodynamic performance is found to correlate with the development of a large scale leading edge vortex. Accordingly, the optimal frequency is found to correlate with the formation time of this vortex.

scholarly journals Evolution of the leading-edge vortex over a flapping wing mechanism

2020 ◽  
Vol 14 (2) ◽  
pp. 6888-6894
Author(s):  
Muhamad Ridzuan Arifin ◽  
A.F.M. Yamin ◽  
A.S. Abdullah ◽  
M.F. Zakaryia ◽  
S. Shuib ◽  
...  
Keyword(s):  
Aerodynamic Force ◽  
Leading Edge ◽  
Aerodynamic Performance ◽  
Flapping Wing ◽  
Unsteady State ◽  
Leading Edge Vortex ◽  
Edge Vortex ◽  
Advance Ratio ◽  
Lift Enhancement ◽  
Lift And Drag

Leading-edge vortex governs the aerodynamic force production of flapping wing flyers. The primary factor for lift enhancement is the leading-edge vortex (LEV) that allows for stall delay that is associated with unsteady fluid flow and thus generating extra lift during flapping flight. To access the effects of LEV to the aerodynamic performance of flapping wing, the three-dimensional numerical analysis of flow solver (FLUENT) are fully applied to simulate the flow pattern. The time-averaged aerodynamic performance (i.e., lift and drag) based on the effect of the advance ratio to the unsteadiness of the flapping wing will result in the flow regime of the flapping wing to be divided into two-state, unsteady state (J<1) and quasi-steady-state(J>1). To access the benefits of aerodynamic to the flapping wing, both set of parameters of velocities 2m/s to 8m/s at a high flapping frequency of 3 to 9 Hz corresponding to three angles of attacks of α = 0o to α = 30o. The result shows that as the advance ratio increases the generated lift and generated decreases until advance ratio, J =3 then the generated lift and drag does not change with increasing advance ratio. It is also found that the change of lift and drag with changing angle of attack changes with increasing advance ratio. At low advance ratio, the lift increase by 61% and the drag increase by 98% between α =100 and α =200. The lift increase by 28% and drag increase by 68% between α = 200 and α = 300. However, at high advance ratio, the lift increase by 59% and the drag increase by 80% between α =100 and α = 200, while between α =200 and α =300 the lift increase by 20% and drag increase by 64%. This suggest that the lift and drag slope decreases with increasing advance ratio. In this research, the results had shown that in the unsteady state flow, the LEV formation can be indicated during both strokes. The LEV is the main factor to the lift enhancement where it generated the lower suction of negative pressure. For unsteady state, the LEV was formed on the upper surface that increases the lift enhancement during downstroke while LEV was formed on the lower surface of the wing that generated the negative lift enhancement. The LEV seem to breakdown at the as the wing flap toward the ends on both strokes.      

On the roles of chord-wise flexibility in a flapping wing with hovering kinematics

2010 ◽  
Vol 659 ◽  
pp. 94-115 ◽  
Author(s):  
JEFF D. ELDREDGE ◽  
JONATHAN TOOMEY ◽  
ALBERT MEDINA
Keyword(s):  
Stokes Equations ◽  
Leading Edge ◽  
Relative Sensitivity ◽  
Aerodynamic Performance ◽  
Flexible Wings ◽  
Leading Edge Vortex ◽  
Flexible Wing ◽  
Wide Range ◽  
Edge Vortex ◽  
Rigid Wing

The aerodynamic performance of a flapping two-dimensional wing section with simplified chord-wise flexibility is studied computationally. Bending stiffness is modelled by a torsion spring connecting two or three rigid components. The leading portion of the wing is prescribed with kinematics that are characteristic of biological hovering, and the aft portion responds passively. Coupled simulations of the Navier–Stokes equations and the wing dynamics are conducted for a wide variety of spring stiffnesses and kinematic parameters. Performance is assessed by comparison of the mean lift, power consumption and lift per unit power, with those from an equivalent rigid wing, and two cases are explored in greater detail through force histories and vorticity snapshots. From the parametric survey, four notable mechanisms are identified through which flexible wings behave differently from rigid counterparts. Rigid wings consistently require more power than their flexible counterparts to generate the same kinematics, as passive deflection leads to smaller drag and torque penalties. Aerodynamic performance is degraded in very flexible wings undergoing large heaving excursions, caused by a premature detachment of the leading-edge vortex. However, a mildly flexible wing has consistently good performance over a wide range of phase differences between pitching and heaving – in contrast to the relative sensitivity of a rigid wing to this parameter – due to better accommodation of the shed leading-edge vortex into the wake during the return stroke, and less tendency to interact with previously shed trailing-edge vortices. Furthermore, a flexible wing permits lift generation even when the leading portion remains nearly vertical, as the wing passively deflects to create an effectively smaller angle of attack, similar to the passive pitching mechanism recently identified for rigid wings. It is found that an effective pitch angle can be defined that accounts for wing deflection to align the results with those of the equivalent rigid wing.

Characterization of Vortex Dynamics in the Near Wake of an Oscillating Flexible Foil

2016 ◽  
Author(s):  
Firas F. Siala ◽  
Alexander D. Totpal ◽  
James A. Liburdy
Keyword(s):  
Large Scale ◽  
Flow Characteristics ◽  
Leading Edge ◽  
Mean Flow ◽  
Near Wake ◽  
Trailing Edge ◽  
Mean Velocity ◽  
Leading Edge Vortex ◽  
Edge Vortex ◽  
The Mean

An experimental study was conducted to explore the effect of surface flexibility at the leading and trailing edges on the near-wake flow dynamics of a sinusoidal heaving foil. Mid-span particle image velocimetry measurements were taken in a closed loop wind tunnel at a Reynolds number of 25,000 and at a range of reduced frequencies (k = fc/U) from 0.09–0.20. Time resolved and phase locked measurements were used to describe the mean flow characteristics and phase averaged vortex structures and their evolution throughout the oscillation cycle. Large eddy scale decomposition and swirl strength analysis were used to quantify the effect of flexibility on the vortical structures. The results demonstrate that flexibility at the trailing edge has a minimal influence on the mean flow characteristics when compared to the purely rigid foil. The mean velocity deficit for the flexible trailing edge and rigid foils is shown to remain constant for all reduced frequencies tested. However, the trailing edge flexibility increases the swirl strength of the small scale structures, which results in enhanced cross stream dispersion of the mean velocity profile. Flexibility at the leading edge is shown to generate a large scale leading edge vortex for k ≥ 0.18. This results in a reduction in the swirl strength due to the complex vortex interactions when compared to the flexible trailing edge and rigid foils. Furthermore, it is shown that the large scale leading edge vortex is responsible for extracting a significant portion of the energy from the mean flow, resulting in a substantial reduction of mean flow momentum in the wake. The kinetic energy loss in the wake is shown to scale well with the energy content of the leading edge vortex.

Flight

2018 ◽  
Author(s):  
Anders Hedenström
Keyword(s):  
Bird Species ◽  
Leading Edge ◽  
Micro Air Vehicles ◽  
Leading Edge Vortex ◽  
Confined Spaces ◽  
Unsteady Aerodynamic ◽  
Maneuvering Flight ◽  
Edge Vortex ◽  
Lifting Surfaces ◽  
Animal Flight

Animal flight represents a great challenge and model for biomimetic design efforts. Powered flight at low speeds requires not only appropriate lifting surfaces (wings) and actuator (engine), but also an advanced sensory control system to allow maneuvering in confined spaces, and take-off and landing. Millions of years of evolutionary tinkering has resulted in modern birds and bats, which are achieve controlled maneuvering flight as well as hovering and cruising flight with trans-continental non-stop migratory flights enduring several days in some bird species. Unsteady aerodynamic mechanisms allows for hovering and slow flight in insects, birds and bats, such as for example the delayed stall with a leading edge vortex used to enhance lift at slows speeds. By studying animal flight with the aim of mimicking key adaptations allowing flight as found in animals, engineers will be able to design micro air vehicles of similar capacities.

Flow criticality governs leading-edge-vortex initiation on finite wings in unsteady flow

2021 ◽  
Vol 910 ◽  
Author(s):  
Yoshikazu Hirato ◽  
Minao Shen ◽  
Ashok Gopalarathnam ◽  
Jack R. Edwards
Keyword(s):  
Unsteady Flow ◽  
Leading Edge ◽  
Leading Edge Vortex ◽  
Edge Vortex

Abstract

Vorticity transport in the leading-edge vortex on a rotating blade

2014 ◽  
Vol 743 ◽  
pp. 249-261 ◽  
Author(s):  
Craig J. Wojcik ◽  
James H. J. Buchholz
Keyword(s):  
Leading Edge ◽  
Quasi Equilibrium ◽  
Transport Mechanisms ◽  
Leading Edge Vortex ◽  
Rotating Blade ◽  
Edge Vortex ◽  
Rotation Motion ◽  
Vorticity Transport ◽  
Control Volumes ◽  
Quiescent Fluid

AbstractVorticity transport is analysed within the leading-edge vortex generated on a rectangular flat plate of aspect ratio 4 undergoing a starting rotation motion in a quiescent fluid. Two analyses are conducted on the inboard half of the blade to better understand the vorticity transport mechanisms responsible for maintaining the quasi-equilibrium state of the leading-edge vortex. An initial global analysis between the $25$ and $50\, \%$ spanwise positions suggests that, although spanwise velocity is significant, spanwise convection of vorticity is insufficient to balance the flux of vorticity from the leading-edge shear layer. Subsequent detailed analyses of vorticity transport in planar control volumes at the $25$ and $50\, \%$ spanwise positions verify this conclusion and demonstrate that vorticity annihilation due to interaction between the leading-edge vortex and the opposite-sign layer on the plate surface is an important, often dominant, mechanism for regulation of leading-edge-vortex circulation. Thus, it provides an important condition for maintenance of an attached leading-edge vortex on the inboard portion of the blade.

Sign in / Sign up

Export Citation Format

Share Document