A Parameter Self-Adjusting Optimization Model to Simulate and Forecast Short-Term Wind Speed Based on Least Square Support Vector Machine Regression Algorithm and Parameter Cross Validation Method

2012 ◽  
Vol 6 (1) ◽  
pp. 415-419
Author(s):  
Zhibin Liu ◽  
Qian Li
2014 ◽  
Vol 511-512 ◽  
pp. 927-930
Author(s):  
Shuai Zhang ◽  
Hai Rui Wang ◽  
Jin Huang ◽  
He Liu

In the paper, the forecast problems of wind speed are considered. In order to enhance the redaction accuracy of the wind speed, this article is about a research on particle swarm optimization least square support vector machine for short-term wind speed prediction (PSO-LS-SVM). Firstly, the prediction models are built by using least square support vector machine based on particle swarm optimization, this model is used to predict the wind speed next 48 hours. In order to further improve the prediction accuracy, on this basis, introduction of the offset optimization method. Finally large amount of experiments and measurement data comparison compensation verify the effectiveness and feasibility of the research on particle swarm optimization least square support vector machine for short-term wind speed prediction, Thereby reducing the short-term wind speed prediction error, very broad application prospects.


2014 ◽  
Vol 587-589 ◽  
pp. 2057-2062
Author(s):  
Jian Gu ◽  
Shu Yan Chen

This paper integrated superiority from time series model and least square support vector machine regression model with data aggregation for traffic speed short term forecasting. Based on the results of traffic data variations analysis, the practicability that speed data can be aggregated to several periods was confirmed, and aggregated model can be developed to forecast the speed with auto regression (AR) model and support vector machine regression (SVR). Then the speed data in case study were integrated to 4 periods at the location of Remote Traffic Microwave Sensors (RTMS) 2047 on 2ndRing Road Expressway in Beijing. Arguments with coefficients from AR models then act as the independent variables of LSSVR in aggregated model. Short term traffic speed was predicted by aggregated model, and the results indicated that taking advantages of time periods variation rule inside the aggregated model would help save the model running time cost under the premise of accuracy with better prediction ability than LSSVR in certain conditions.


2019 ◽  
Vol 44 (3) ◽  
pp. 266-281 ◽  
Author(s):  
Zhongda Tian ◽  
Yi Ren ◽  
Gang Wang

Wind speed prediction is an important technology in the wind power field; however, because of their chaotic nature, predicting wind speed accurately is difficult. Aims at this challenge, a backtracking search optimization–based least squares support vector machine model is proposed for short-term wind speed prediction. In this article, the least squares support vector machine is chosen as the short-term wind speed prediction model and backtracking search optimization algorithm is used to optimize the important parameters which influence the least squares support vector machine regression model. Furthermore, the optimal parameters of the model are obtained, and the short-term wind speed prediction model of least squares support vector machine is established through parameter optimization. For time-varying systems similar to short-term wind speed time series, a model updating method based on prediction error accuracy combined with sliding window strategy is proposed. When the prediction model does not match the actual short-term wind model, least squares support vector machine trains and re-establishes. This model updating method avoids the mismatch problem between prediction model and actual wind speed data. The actual collected short-term wind speed time series is used as the research object. Multi-step prediction simulation of short-term wind speed is carried out. The simulation results show that backtracking search optimization algorithm–based least squares support vector machine model has higher prediction accuracy and reliability for the short-term wind speed. At the same time, the prediction performance indicators are also improved. The prediction result is that root mean square error is 0.1248, mean absolute error is 0.1374, mean absolute percentile error is 0.1589% and R2 is 0.9648. When the short-term wind speed varies from 0 to 4 m/s, the average value of absolute prediction error is 0.1113 m/s, and average value of absolute relative prediction error is 8.7111%. The proposed prediction model in this article has high engineering application value.


Author(s):  
Didik Djoko Susilo ◽  
A. Widodo ◽  
T. Prahasto ◽  
M. Nizam

This is an erratum to International Journal of Automotive and Mechanical Engineering 2021; 18(1): 8464–8477. Please refer to the related article: https://doi.org/10.15282/ijame.18.1.2021.06.0641


2016 ◽  
Vol 2016 ◽  
pp. 1-7 ◽  
Author(s):  
Bin Zhang ◽  
Jinke Gong ◽  
Wenhua Yuan ◽  
Jun Fu ◽  
Yi Huang

In order to effectively predict the sieving efficiency of a vibrating screen, experiments to investigate the sieving efficiency were carried out. Relation between sieving efficiency and other working parameters in a vibrating screen such as mesh aperture size, screen length, inclination angle, vibration amplitude, and vibration frequency was analyzed. Based on the experiments, least square support vector machine (LS-SVM) was established to predict the sieving efficiency, and adaptive genetic algorithm and cross-validation algorithm were used to optimize the parameters in LS-SVM. By the examination of testing points, the prediction performance of least square support vector machine is better than that of the existing formula and neural network, and its average relative error is only 4.2%.


2017 ◽  
Vol 21 (1) ◽  
pp. 37 ◽  
Author(s):  
Hua Deng ◽  
Yan Li ◽  
Yingchao Zhang ◽  
Hou Zhou ◽  
Peipei Cheng ◽  
...  

The forecast of wind energy is closely linked to the prediction of the variation of winds over very short time intervals. Four wind towers located in the Inner Mongolia were selected to understand wind power resources in the compound plateau region. The mesoscale weather research and forecasting combining Yonsei University scheme and Noah land surface model (WRF/YSU/Noah) with 1-km horizontal resolution and 10-min time resolution were used to be as the wind numerical weather prediction (NWP) model. Three statistical techniques, persistence, back-propagation artificial neural network (BP-ANN), and least square support vector machine (LS-SVM) were used to improve the wind speed forecasts at a typical wind turbine hub height (70 m) along with the WRF/YSU/Noah output. The current physical-statistical forecasting techniques exhibit good skill in three different time scales: (1) short-term (day-ahead); (2) immediate-short-term (6-h ahead); and (3) nowcasting (1-h ahead). The forecast method, which combined WRF/YSU/Noah outputs, persistence, and LS-SVM methods, increases the forecast skill by 26.3-49.4% compared to the direct outputs of numerical WRF/YSU/Noah model. Also, this approach captures well the diurnal cycle and seasonal variability of wind speeds, as well as wind direction. Predicción de vientos en una altiplanicie a la altura del eje con el esquema de la Universidad Yonsei/Modelo Superficie Terrestre Noah y la predicción estadísticaResumenLa estimación de la energía eólica está relacionada con la predicción en la variación de los vientos en pequeños intervalos de tiempo. Se seleccionaron cuatro torres eólicas ubicadas al interior de Mongolia para estudiar los recursos eólicos en la complejidad de un altiplano. Se utilizó la investigación climática a mesoscala y la combinación del esquema de la Universidad Yonsei con el Modelo de Superficie Terrestre Noah (WRF/YSU/Noah), con resolución de 1km horizontal y 10 minutos, como el modelo numérico de predicción meteorológica (NWP, del inglés Numerical Weather Prediction). Se utilizaron tres técnicas estadísticas, persistencia, propagación hacia atrás en redes neuronales artificiales y máquina de vectores de soporte-mínimos cuadrados (LS-SVM, del inglés Least Square Support Vector Machine), para mejorar la predicción de la velocidad del viento en una turbina con la altura del eje a 70 metros y se complementó con los resultados del WRF/YSU/Noah. Las técnicas de predicción físico-estadísticas actuales tienen un buen desempeo en tres escalas de tiempo: (1) corto plazo, un día en adelante; (2) mediano plazo, de seis días en adelante; (3) cercano, una hora en adelante. Este método de predicción, que combina los resultados WRF/YSU/Noah con los métodos de persistencia y LS-SVM incrementa la precisión de predicción entre 26,3 y 49,4 por ciento, comparado con los resultados directos del modelo numérico WRF/YSU/Noah. Además, este método diferencia la variabilidad de las estaciones y el ciclo diurno en la velocidad y la dirección del viento.


2012 ◽  
Vol 608-609 ◽  
pp. 814-817
Author(s):  
Xiao Fu ◽  
Dong Xiang Jiang

The power fluctuation of wind turbine often causes serious problems in electricity grids. Therefore, short term prediction of wind speed and power as to eliminate the uncertainty determined crucially the development of wind energy. Compared with physical methods, support vector machine (SVM) as an intelligent artificial method is more general and shows better nonlinear modeling capacity. A model which combined fuzzy information granulation with SVM method was developed and implemented in short term future trend prediction of wind speed and power. The data, including the daily wind speed and power, from a wind farm in northern China were used to evaluate the proposed method. The prediction results show that the proposed model performs better and more stable than the standard SVM model when apply them into the same data set.


Sign in / Sign up

Export Citation Format

Share Document