Quality Assurance in 3-D Treatment Planning

2015 ◽  
pp. 104-114 ◽  
Author(s):  
Randall K. Ten Haken ◽  
Benedick A. Fraass
Keyword(s):  
Quality Assurance ◽  
Treatment Planning

scholarly journals Quality Assurance of Dose Distribution of Photon Beam Planning by Anisotropic Analytical Algorithm (AAA)

2013 ◽  
Vol 4 (1) ◽  
pp. 43-49
Author(s):  
M Jahangir Alam ◽  
Syed Md Akram Hussain ◽  
Kamila Afroj ◽  
Shyam Kishore Shrivastava
Keyword(s):  
Quality Assurance ◽  
Treatment Planning ◽  
Dose Distribution ◽  
Maximum Dose ◽  
Photon Beam ◽  
Field Size ◽  
Planning System ◽  
Treatment Planning System ◽  
Anisotropic Analytical Algorithm ◽  
Analytical Algorithm

A three dimensional treatment planning system has been installed in the Oncology Center, Bangladesh. This system is based on the Anisotropic Analytical Algorithm (AAA). The aim of this study is to verify the validity of photon dose distribution which is calculated by this treatment planning system by comparing it with measured photon beam data in real water phantom. To do this verification, a quality assurance program, consisting of six tests, was performed. In this program, both the calculated output factors and dose at different conditions were compared with the measurement. As a result of that comparison, we found that the calculated output factor was in excellent agreement with the measured factors. Doses at depths beyond the depth of maximum dose calculated on-axis or off-axis in both the fields or penumbra region were found in good agreement with the measured dose under all conditions of energy, SSD and field size, for open and wedged fields. In the build up region, calculated and measured doses only agree (with a difference 2.0%) for field sizes > 5 × 5 cm2 up to 25 × 25 cm2. For smaller fields, the difference was higher than 2.0% because of the difficulty in dosimetry in that region. Dose calculation using treatment planning system based on the Anisotropic Analytical Algorithm (AAA) is accurate enough for clinical use except when calculating dose at depths above maximum dose for small field size.DOI: http://dx.doi.org/10.3329/bjmp.v4i1.14686 Bangladesh Journal of Medical Physics Vol.4 No.1 2011 43-49

Quality assurance of volumetric-modulated arc therapy head and neck cancer treatment using PRESAGE® dosimeter

2018 ◽  
Vol 17 (4) ◽  
pp. 441-446 ◽  
Author(s):  
Jalil ur Rehman ◽  
Muhammad Isa ◽  
Nisar Ahmad ◽  
H. M. Noor ul Huda Khan Asghar ◽  
Zaheer A. Gilani ◽  
...  
Keyword(s):  
Quality Assurance ◽  
Cancer Treatment ◽  
Head And Neck ◽  
Treatment Planning ◽  
Volumetric Modulated Arc Therapy ◽  
Planning System ◽  
Treatment Planning System ◽  
Ct Scans ◽  
Arc Therapy ◽  
Calculated Dose

AbstractBackgroundAccurate three-dimensional dosimetry is essential in modern radiotherapy techniques such as volumetric-modulated arc therapy (VMAT) and intensity-modulated radiation therapy (IMRT). In this research work, the PRESAGE® dosimeter was used as quality assurance (QA) tool for VMAT planning for head and neck (H&N) cancer.Material and methodComputer tomography (CT) scans of an Image Radiation Oncology Core (IROC) H&N anthropomorphic phantom with both IROC standard insert and PRESAGE® insert were acquired separately. Both CT scans were imported into the Pinnacle (9.4 version) TPS for treatment planning, where the structures [planning target volume (PTV), organs at risk) and thermoluminescent detectors (TLDs) were manually contoured and used to optimise a VMAT plan. Treatment planning was done using VMAT (dual arc: 182°–178°, 178°–182°). Beam profile comparisons and gamma analysis were used to quantify agreement with film, PRESAGE® measurement and treatment planning system (TPS) calculated dose distribution.ResultsThe average ratio of TLD measured to calculated doses at the four PTV locations in the H&N phantom were between 0·95 to 0·99 for all three VMAT deliveries. Dose profiles were taken along the left–right, the anterior–posterior and superior–inferior axes, and good agreement was found between the PRESAGE® and Pinnacle profile. The mean value of gamma results for three VMAT deliveries in axial and sagittal planes were found to be 94·24 and 93·16% when compared with film and Pinnacle, respectively. The average values comparing the PRESAGE® results and dose values calculated on Pinnacle were observed to be 95·29 and 94·38% in the said planes, respectively, using a 5%/3 mm gamma criteria.ConclusionThe PRESAGE® dose measurements and calculated dose of pinnacle show reasonable agreement in both axial and sagittal planes for complex dual arc VMAT treatment plans. In general, the PRESAGE® dosimeter is found to be a feasible QA tool of VMAT plan for H&N cancer treatment.

Quality assurance in radiotherapy

2019 ◽  
pp. 520-536
Author(s):  
Patricia Díez ◽  
Edwin GA Aird
Keyword(s):  
Quality Control ◽  
Clinical Trials ◽  
Quality Assurance ◽  
Treatment Planning ◽  
Patient Pathway

Chapter 23 discusses quality assurance of the patient pathway, concentrating on quality control of treatment planning and delivery. There is also discussion on relevant legislation associated with the radiotherapy process as well as a section on quality assurance for clinical trials.

3D CT–based high-dose-rate breast brachytherapy implants: treatment planning and quality assurance

2004 ◽  
Vol 59 (4) ◽  
pp. 1224-1228 ◽  
Author(s):  
Rupak K. Das ◽  
Rakesh Patel ◽  
Hiral Shah ◽  
Heath Odau ◽  
Robert R. Kuske
Keyword(s):  
Quality Assurance ◽  
Dose Rate ◽  
Treatment Planning ◽  
High Dose Rate ◽  
High Dose ◽  
3D Ct ◽  
Breast Brachytherapy

scholarly journals Quality assurance procedures based on dosimetric, gamma analysis as a fast reliable tool for commissioning brachytherapy treatment planning systems

2017 ◽  
Vol 51 (4) ◽  
pp. 469-474 ◽  
Author(s):  
Grzegorz Zwierzchowski ◽  
Grzegorz Bieleda ◽  
Janusz Skowronek
Keyword(s):  
Quality Assurance ◽  
Treatment Planning ◽  
Dose Distribution ◽  
Beam Quality ◽  
Calculated Data ◽  
Radiochromic Film ◽  
Film Dosimetry ◽  
Planning Systems ◽  
Treatment Planning Systems ◽  
Gamma Analysis

Abstract Background Fast and easily repeatable methods for commissioning procedures for brachytherapy (BT) treatment planning systems (TPS) are needed. Radiochromic film dosimetry with gamma analysis is widely used in external beam quality assurance (QA) procedures and planar film dosimetry is also increasingly used for verification of the dose distribution in BT applications. Using the gamma analysis method for comparing calculated and measured dose data could be used for commissioning procedures of the newly developed TG-186 and MBDCA calculation algorithms. The aim of this study was dosimetric verification of the calculation algorithm used in TPS when the CT/MRI ring applicator is used. Materials and methods Ring applicators with 26 and 30 mm diameters and a 60 mm intra-uterine tube with 60° angle were used for verification. Gafchromic® EBT films were used as dosimetric media. Dose grids, corresponding to each plane (dosimetric film location), were exported from the TPS as a raw data. Gafchromic® films were digitized after irradiation. gamma analysis of the data were performed using the OMNI Pro I’mRT® system, as recommended by the AAPM TG-119 rapport criterion for gamma analysis of 3%, 3 mm and a level of 95%. Results For the 26 mm and 30 mm rings, the average gamma ranged, respectively, from 0.1 to 0.44 and from 0.1 to 0.27. In both cases, 99% of the measured points corresponded with the calculated data. Conclusions This analysis showed excellent agreement between the dose distribution calculated with the TPS and the doses measured by Gafchromic films. This finding confirms the viability of using film dosimetry in BT.

Sign in / Sign up

Export Citation Format

Share Document