Accuracy of the Cardiac Electrical Field Approximation Using Equivalent Generators of Some Types

2015 ◽  
pp. 44-47
Author(s):  
L. I. Titomir
Keyword(s):  
Field Approximation ◽  
Electrical Field

Principles of Low-Vacuum SEM

1992 ◽  
Vol 50 (2) ◽  
pp. 1304-1305
Author(s):  
Klaus-Ruediger Peters
Keyword(s):  
New Technologies ◽  
High Vacuum ◽  
Optical Microscope ◽  
Specimen Surface ◽  
Electrical Field ◽  
Gaseous Environment ◽  
New Information ◽  
Gas Molecules ◽  
New Interactions ◽  
Gas Pressures

Only recently it became possible to expand scanning electron microscopy to low vacuum and atmospheric pressure through the introduction of several new technologies. In principle, only the specimen is provided with a controlled gaseous environment while the optical microscope column is kept at high vacuum. In the specimen chamber, the gas can generate new interactions with i) the probe electrons, ii) the specimen surface, and iii) the specimen-specific signal electrons. The results of these interactions yield new information about specimen surfaces not accessible to conventional high vacuum SEM. Several microscope types are available differing from each other by the maximum available gas pressure and the types of signals which can be used for investigation of specimen properties.Electrical non-conductors can be easily imaged despite charge accumulations at and beneath their surface. At high gas pressures between 10-2 and 2 torr, gas molecules are ionized in the electrical field between the specimen surface and the surrounding microscope parts through signal electrons and, to a certain extent, probe electrons. The gas provides a stable ion flux for a surface charge equalization if sufficient gas ions are provided.

An ultrastructural analysis of the sympathetic innervation of the rabbit ear artery and middle cerebral artery and their branches

1992 ◽  
Vol 50 (1) ◽  
pp. 934-935
Author(s):  
John T. Dodge ◽  
John A. Bevan
Keyword(s):  
Middle Cerebral Artery ◽  
Cerebral Artery ◽  
Sympathetic Innervation ◽  
Electrical Field Stimulation ◽  
Rabbit Ear Artery ◽  
Electrical Field ◽  
Functional Differences ◽  
Ear Artery ◽  
Rabbit Ear ◽  
Vascular Beds

Unlike many peripheral vascular beds, the sympathetic nervous system exerts little control on cerebral blood flow. The contractile response of isolated rabbit middle cerebral artery (MCA) segments to electrical field stimulation of its intramural nerves is less than in a similar-sized artery from the ear. This study was undertaken to characterize and compare the perivascular neuromuscular relationships and innervation density of similar-sized arteries varying in diameter from these two different regional arterial beds to see if there were structural correlates for these functional differences.

Electrical Anisotropy of Thin Metal Films Growing on Dielectric Substrates

2002 ◽  
Vol 7 (2) ◽  
pp. 45-52
Author(s):  
L. Jakučionis ◽  
V. Kleiza
Keyword(s):  
Magnetic Field ◽  
Thin Films ◽  
Uniaxial Anisotropy ◽  
Metal Films ◽  
Thin Layers ◽  
Electrical Anisotropy ◽  
Electrical Field ◽  
Dielectric Substrates ◽  
Unequal Probability ◽  
Conductive Thin Films

Electrical properties of conductive thin films, that are produced by vacuum evaporation on the dielectric substrates, and which properties depend on their thickness, usually are anisotropic i.e. they have uniaxial anisotropy. If the condensate grow on dielectric substrates on which plane electrical field E is created the transverse voltage U⊥ appears on the boundary of the film in the direction perpendicular to E. Transverse voltage U⊥ depends on the angle γ between the applied magnetic field H and axis of light magnetisation. When electric field E is applied to continuous or grid layers, U⊥ and resistance R of layers are changed by changing γ. It means that value of U⊥ is the measure of anisotropy magnitude. Increasing voltage U0 , which is created by E, U⊥ increases to certain magnitude and later decreases. The anisotropy of continuous thin layers is excited by inequality of conductivity tensor components σ0 ≠ σ⊥. The reason of anisotropy is explained by the model which shows that properties of grain boundaries are defined by unequal probability of transient of charge carrier.

Analysis of the Bias Dependent Spectral Response of a-SiC:H p-i-n Photodiode

2002 ◽  
Vol 715 ◽  
Author(s):  
P. Louro ◽  
A. Fantoni ◽  
Yu. Vygranenko ◽  
M. Fernandes ◽  
M. Vieira
Keyword(s):  
Bias Voltage ◽  
Voltage Dependence ◽  
Spectral Response ◽  
Surface Recombination ◽  
Electrical Field ◽  
Field Reversal ◽  
Current Voltage ◽  
Voltage Dependent ◽  
And Inversion ◽  
Device Operation

AbstractThe bias voltage dependent spectral response (with and without steady state bias light) and the current voltage dependence has been simulated and compared to experimentally obtained values. Results show that in the heterostructures the bias voltage influences differently the field and the diffusion part of the photocurrent. The interchange between primary and secondary photocurrent (i. e. between generator and load device operation) is explained by the interaction of the field and the diffusion components of the photocurrent. A field reversal that depends on the light bias conditions (wavelength and intensity) explains the photocurrent reversal. The field reversal leads to the collapse of the diode regime (primary photocurrent) launches surface recombination at the p-i and i-n interfaces which is responsible for a double-injection regime (secondary photocurrent). Considerations about conduction band offsets, electrical field profiles and inversion layers will be taken into account to explain the optical and voltage bias dependence of the spectral response.

The Determination of the Magnetoelectric Coupling Coefficient in Ferroelectric–Ferromagnetic Composite Based on PZT–Ferrite

2013 ◽  
Vol 58 (4) ◽  
pp. 1401-1403 ◽  
Author(s):  
J.A. Bartkowska ◽  
R. Zachariasz ◽  
D. Bochenek ◽  
J. Ilczuk
Keyword(s):  
Dielectric Permittivity ◽  
Coupling Coefficient ◽  
Mean Field ◽  
Field Approximation ◽  
Theoretical Description ◽  
Magnetoelectric Coupling ◽  
Mean Field Approximation ◽  
Dielectric Measurements ◽  
Temperature Dependences ◽  
Multiferroic Composite

Abstract In the present work, the magnetoelectric coupling coefficient, from the temperature dependences of the dielectric permittivity for the multiferroic composite was determined. The research material was ferroelectric-ferromagnetic composite on the based PZT and ferrite. We investigated the temperature dependences of the dielectric permittivity (") for the different frequency of measurement’s field. From the dielectric measurements we determined the temperature of phase transition from ferroelectric to paraelectric phase. For the theoretical description of the temperature dependence of the dielectric constant, the Hamiltonian of Alcantara, Gehring and Janssen was used. To investigate the dielectric properties of the multiferroic composite this Hamiltonian was expressed under the mean-field approximation. Based on dielectric measurements and theoretical considerations, the values of the magnetoelectric coupling coefficient were specified.

Development of an AC Electrical Field Tribochemical Polishing Technique to Promote High-Efficiency Polishing for Glass Substrates

2012 ◽  
Vol 78 (4) ◽  
pp. 316-320
Author(s):  
Hiroshi IKEDA ◽  
Yoichi AKAGAMI ◽  
Michio UNEDA ◽  
Osamu OHNISHI ◽  
Syuhei KUROKAWA ◽  
...  
Keyword(s):  
High Efficiency ◽  
Electrical Field ◽  
Glass Substrates

Magnetic Field Approximation in MR Tomography

PIERS Online ◽  
2007 ◽  
Vol 3 (8) ◽  
pp. 1250-1253
Author(s):  
Michal Hadinec ◽  
Pavel Fiala ◽  
Eva Kroutilova ◽  
M. Steinbauer ◽  
Karel Bartusek
Keyword(s):  
Magnetic Field ◽  
Field Approximation ◽  
Mr Tomography
Sign in / Sign up

Export Citation Format

Share Document