scholarly journals Investigating the Effect of Temperature Changes on the Physical Field of Surrounding Rock in a Deep Gold Mine

2021 ◽  
Vol 2021 ◽  
pp. 1-13
Author(s):  
Xinghui Wu ◽  
Qifeng Guo ◽  
Peng Li ◽  
Fenhua Ren ◽  
Jie Zhang ◽  
...  

To explore the fracture mechanism of surrounding rock for thermal-mechanical coupling in deep mining, the theoretical solution of the internal temperature and stress evolution of the underground chamber cold boundary subjected to cold impact was obtained by thermoelastic theory. The conduction law of temperature and the evolution characteristics of stress were studied by theoretical formulas, and the influence of the convective heat transfer coefficient on the rate of tensile stress reduction was analyzed. The results show that the theoretical solution is in good agreement with the field measured value, which proves that the theoretical calculation method adopted in this paper is reliable and accurate. When the surface of the underground chamber is impacted by the change of temperature, the cold boundary temperature drops sharply at first, then gradually slows down, and finally reaches the same temperature as the air; the tensile stress decreases sharply from the initial high-stress value, then gradually decreases, and finally tends to be stable. The effects of different convective heat transfer coefficients on the change of temperature resistance of rocks were considered by numerical simulation. The numerical simulation results show that increasing the convective heat transfer coefficient not only increases the tensile stress of the heat transfer boundary but also increases the possibility of cracks, which makes the rock easier to crack. Based on the research results, we introduced the thermal-mechanical coupling disturbance range coefficient β = L/2D (β = 6–8) and proposed that the convective heat transfer coefficient is the reference index of the deep mining support structure, which can provide a theoretical basis and technical support for the selection of support materials.

Author(s):  
Feng Sun ◽  
G. Aguilar ◽  
K. M. Kelly ◽  
G.-X. Wang

Basel cell carcinoma (BCC) is the most common human skin malignancy. Its incidence has increased significantly in Australia, Europe and North America over the past decade. A number of modalities are currently used for treatment of BCC, including cryosurgery which offers a potential for high cure rate, low cost, minimal bleeding and good cosmetic effect. However, cryosurgery is not used frequently for BCC because no current method exists to design adequate treatment parameters. We present a numerical analysis on the thermal history of the target tissue during cryosurgery of a nodular BCC using liquid nitrogen (LN2) spray. The model uses Pennes equation to describe the heat transfer within the target tissue. A convective thermal boundary is used to describe the heat interaction between the tissue and LN2, and the apparent heat capacity method is applied to address the tissue phase change process. A parametric study is conducted on the convective heat transfer coefficient (hs: 104~106 W/m2·K), cooling site area (rs/R0: 0.5~1.0) and spray time (t: 0~30 sec.), with the objective to understand the thermal history during tissue freezing, including lethal temperature (-50 °C) and cooling rate (CR). Results demonstrate that propagation of the lethal isotherm is sensitive to the convective heat transfer coefficient, hs, with a range of 104~5×104 W/m2·K. Increasing the cooling site area can significantly enhance cooling efficiency, producing dramatic increase in the amount of tissue encompassed by the lethal isotherm. The cooling rate (CR) shows a highly dynamic distribution during the cooling process: the highest CR drops quickly from 140 °C/sec. (t=0.5 sec.) to 20 °C/sec. (t=5 sec.). The highest CR is initially located close to the cooling site but moves toward the inside of the tissue as treatment proceeds. The model presented herein provides a simulation tool for treatment planning of cryosurgery using LN2 spray, in which the protocol parameters, e.g. cooling site area and spray time, can be determined for an optimal outcome. The quantitative predictions on the propagation of lethal isotherm and the distribution of CR should help to optimize cryosurgery efficacy.


Sign in / Sign up

Export Citation Format

Share Document