scholarly journals Simplified Analytical Method for Predicting the Lateral Ground Displacements due to Shield Tunnelling

2021 ◽  
Vol 2021 ◽  
pp. 1-10
Author(s):  
Lianwei Sun ◽  
Zhong-chao Li ◽  
Rong-zhu Liang

Earth pressure balance or slurry shield tunnelling will squeeze the subsoils and lead to lateral outward ground displacement. However, current methods to estimate the shield tunnelling-induced ground displacements generally use the methods based on the face unsupported tunnelling (e.g., New Austrian tunnelling and open shield excavation), which cannot predict the lateral ground movement due to shield tunnelling. In this paper, a novel simplified analytical method is proposed to predict the ground lateral displacement during the shield advancing process. The key shield tunnelling operation factors, including the additional pressure of cutter head, the friction forces around shield body, the back-fill grouting pressure, and the soil volume loss are all considered. The lateral ground displacements induced by the four former factors are calculated by using Mindlin’s solutions. The soil volume loss-induced lateral ground displacement is calculated by employing the expression introduced by Pinto and Whittle. Combining with the displacement obtained from all the factors, the analytical method for lateral ground displacement induced by shield tunnelling is obtained. The applicability of the proposed analytical approach is verified with three well-documented case histories involving slurry shield and EPB shield machines.

Author(s):  
Hamid Karimian ◽  
Pete Barlow ◽  
Chris Blackwell ◽  
Chris Campbell

Abstract The Wapiti River South Slope (the Slope) near Grand Prairie, Alberta, Canada, is 500 m long and consists of a steep lower slope and a shallower upper slope. Both the upper and the lower slopes are located within a landslide complex with ground movements of varying magnitudes and depths. The Alliance Pipeline (Alliance) NPS 42 Mainline (the pipeline) was installed in the winter of 2000 using conventional trenching techniques at an angle of approximately 8° to the slope fall line. Evidence of slope instability was observed in the slope since 2007. The surficial geology of the slope comprises a colluvium layer draped over bedrock formation in the lower slope, and glacial deposits in the upper slope. Available data indicated two different slide mechanisms. In the lower slope, there is a shallow translational slide within a colluvium layer, and in the upper slope there is a deep-seated translational slide within the glacial deposits. Both the upper and lower slope landslides have been confirmed to be active in the past decade. Gradual ground displacements in the order of several centimeters per year were observed in both the upper and lower slopes between 2007 and 2012. Large ground displacements in the order of several meters were observed between 2012 and 2014 in the lower slope that led to the first stress relief and subsequent slope mitigation measures in the spring and summer of 2014. Monitoring of the slope after mitigations indicated significant reduction in the rate of ground movement in the lower slope. Surveying of the pipeline before and after stress relief indicated an increase in lateral pipeline deformation in the direction of ground movement, following the stress relief. This observation raised questions regarding the effectiveness of partial stress relief to reduce stresses and strains associated with ground movements. Finite element analysis (FEA) was conducted in 2016 to aid in assessing the condition of the pipeline after being subject to ground displacements prior to 2014, stress relief in 2014, and subsequent ground displacement from July 2014 to December 2016. The results and findings of the FEA reasonably matched the observed pipeline behaviour before and after stress relief in the lower slope. The FEA results demonstrated that while the lateral displacement of the pipeline, originally caused by ground movement, increased following the removal of the soil loading during the stress relief, the maximum pipeline strain was reduced within the excavated portion. The FEA was also employed to assess the pipeline response to potential ground displacement scenarios following December 2016. For this assessment, three ground displacement scenarios that comprise different lengths of the pipeline were analyzed. An increased rate of ground displacement, with a pattern that matched one of the analyzed scenarios, was observed in the upper slope in the spring of 2017. The results of FEA were used to assess the pipeline response to the increased rate of displacement in the upper slope. Subsequently a decision was made to stress-relieve the pipeline. The second stress-relief was conducted in the summer of 2017. This stress relief was conducted locally at the toe and head of the active slide in the upper slope, where the FEA showed the greatest stress concentrations in the pipeline.


2020 ◽  
Vol 13 (4) ◽  
pp. 372-381
Author(s):  
Zdenek Zizka ◽  
Sebastian Kube ◽  
Britta Schößer ◽  
Markus Thewes

2019 ◽  
Vol 36 (4) ◽  
pp. 1219-1237
Author(s):  
Zhi Ding ◽  
Xinjiang Wei ◽  
Xiao Zhang ◽  
Xinsheng Yin

Purpose The shield tunnels closely constructed near the foundations have an inevitable influence on the structures, even results in the large settlement or uplift of the structures. Design/methodology/approach The comparison of structural deformation of three different foundations is presented based on the field monitoring data. Findings Shield tunnelling parameters vary for the different types of foundations. For the long pile foundations, the recommended speed is 3 to 4 cm/min, the grouting pressure is about 0.3 MPa and the grouting rate ranges from 150 to 180. Originality/value The study based on the field monitoring data is rarely reported, especially the topic about the structural deformation of different types of the foundations.


Geosciences ◽  
2018 ◽  
Vol 8 (8) ◽  
pp. 303 ◽  
Author(s):  
Matteo Albano ◽  
Michele Saroli ◽  
Antonio Montuori ◽  
Christian Bignami ◽  
Cristiano Tolomei ◽  
...  

We investigated the contribution of earthquake-induced surface movements to the ground displacements detected through Interferometric Synthetic Aperture Radar (InSAR) data, after the Mw 3.9 Ischia earthquake on 21 August 2017. A permanent displacement approach, based on the limit equilibrium method, allowed estimation of the spatial extent of the earthquake-induced landslides and the associated probability of failure. The proposed procedure identified critical areas potentially affected by slope movements partially overlapping the coseismic ground displacement retrieved by InSAR data. Therefore, the observed ground displacement field is the combination of both fault slip and surficial sliding caused by the seismic shaking. These findings highlight the need to perform preliminary calculations to account for the non-tectonic contributions to ground displacements before any estimation of the earthquake source geometry and kinematics. Such information is fundamental to avoid both the incorrect definition of the source geometry and the possible overestimation of the coseismic slip over the causative fault. Moreover, knowledge of the areas potentially affected by slope movements could contribute to better management of a seismic emergency, especially in areas exposed to high seismic and hydrogeological risks.


Author(s):  
Yoshikazu Hashimoto ◽  
Hiroshi Yatabe ◽  
Naoto Hagiwara ◽  
Noritake Oguchi

In this paper, the deformability of line pipe with local metal loss was examined. A full-scale experiment and a finite element (FE) analysis were carried out for line pipe with local metal loss subjected to an axial compressive load. As a result, a good agreement was obtained between the analytical and experimental results. This indicated that the present analytical method was applicable to evaluate the deformability of line pipes with local metal loss subjected to a large ground movement. Parametric studies were then conducted to clarify the relationship between the geometry of the local metal loss and the deformability using the FE analytical method.


2020 ◽  
Vol 2020 ◽  
pp. 1-14
Author(s):  
Jian Cui ◽  
Wang-Hao Xu ◽  
Yong Fang ◽  
Li-Ming Tao ◽  
Chuan He

There are severe challenges for slurry pressure balance tunnel boring machine (TBM) tunnelling in sandy cobble soil of Beijing, Chengdu, and Lanzhou in China. And the problems caused by tunnelling from silty clay to sandy cobble stratum are more serious. With the change of stratum, the key parameters and surface settlement will change correspondingly. Controlling the key parameters and predicting the surface settlement accurately and efficiently is important for hazard mitigation and risk management. In this study, based on the Tsinghuayuan Tunnel project in Beijing, the key parameters and surface settlement while tunnelling from silty clay to sandy cobble stratum are studied. Firstly, the difference of key parameters while tunnelling in two different strata is analyzed. The analysis shows that immediate responses to changes in the stratum are recommended in order to ensure construction efficiency. Then, a refined 3D finite difference model is developed to simulate the slurry TBM tunnelling in different strata. For refined simulation, three key parameters obtained from measurement data were applied to the 3D models, and the simulation results were compared with the field data. Results show that the refined model has good performance in terms of the accuracy and efficiency. This study provides a good engineering practice reference for slurry TBM tunnelling in mixed strata.


2011 ◽  
Vol 243-249 ◽  
pp. 3078-3081 ◽  
Author(s):  
Cun Gang Lin ◽  
Zhong Miao Zhang ◽  
Shi Ming Wu

The Qing-chun Road Cross-river Tunnel is the first road tunnel under the Qiantang River in Hangzhou, and it is also the first experiences of slurry shield tunnelling in Hangzhou soft ground. In order to ensure the safety of construction and reduction of environmental impacts while shield tunnelling, a comprehensive monitoring system was carried out during construction, which included ground settlements, displacements and deformations of installed linings and so on. In this paper, the long-term ground settlements induced by slurry shield tunnelling were described in detail, and careful analysis of monitoring ground settlements was made. This case study shows that: 1. The surface transverse consolidation settlements do not follow the Gaussian curve; usually the largest settlements exist above the centerline of the tunnel or nearby, from where settlements descend outwards. Due to consolidation, the surface settlement troughs widen with time.2. Shield tunneling in soft ground, the turning point in settlement-time curves or settlement rate-time curves can be chosen as the time divides the immediate and long-term consolidation settlements.


Sign in / Sign up

Export Citation Format

Share Document