scholarly journals Energy Dissipation and Particle Size Distribution of Granite under Different Incident Energies in SHPB Compression Tests

2020 ◽  
Vol 2020 ◽  
pp. 1-14
Author(s):  
Fengqiang Gong ◽  
Hangyu Jia ◽  
Zongxian Zhang ◽  
Jian Hu ◽  
Song Luo
Keyword(s):  
Particle Size ◽  
Energy Dissipation ◽  
Particle Size Distribution ◽  
Critical Incident ◽  
Incident Energy ◽  
Dynamic Compression ◽  
Dissipated Energy ◽  
Compression Tests ◽  
The Impact ◽  
Rock Specimens

To investigate energy dissipation and particle size distribution of rock under dynamic loads, a series of dynamic compression tests of granite specimens were conducted using a conventional split-Hopkinson pressure bar (SHPB) device with a high-speed camera. The experimental results show that the dissipated energy increases linearly with an increasing incident energy, following two different inclined paths connected by a critical incident energy, and the linear energy dissipation law in the dynamic compression test has been confirmed. This critical incident energy was found to be 0.29–0.33 MJ/m3. As the incident energy was smaller than the critical incident energy, the rock specimens remained unruptured after the impact. When the incident energy was greater than the critical incident energy, the rock specimens were ruptured or fragmented after the impact. In addition, the experimental results indicate that the dissipated energy and energy consumption ratio of a rock specimen, either unruptured or fragmented, increase with an increasing strain rate. Furthermore, it was found that fragment sizes at each mesh decrease with an increasing incident energy; that is, fragmentation becomes finer as incident energy increases.

scholarly journals Dynamic Compression Damage Energy Consumption and Fractal Characteristics of Shale

2019 ◽  
Vol 2019 ◽  
pp. 1-7
Author(s):  
Guoliang Yang ◽  
Jingjiu Bi ◽  
Linian Ma
Keyword(s):  
Fractal Dimension ◽  
Energy Consumption ◽  
Energy Dissipation ◽  
Strain Rate ◽  
Split Hopkinson Pressure Bar ◽  
Dynamic Compression ◽  
Fractal Theory ◽  
Dissipated Energy ◽  
Impact Tests ◽  
The Impact

Studying the relationship between energy consumption and crushed size of shale under different loading conditions is the key to efficient shale cracking. The split Hopkinson pressure bar system was used to study the dynamic mechanical properties of shale under parallel- and vertical-bedding loading, and energy dissipation in the impact tests was calculated. Relationships between the average crushed size of shale fracture products and energy dissipation and between the fractal dimension and dissipated energy were studied using fractal theory. The experimental results showed that the dynamic compressive strength of shale under parallel- and vertical-bedding conditions had an obvious positive correlation with the strain rate. Dissipative energy of the shale samples under loading in both directions increased with the increase of strain rate. The increase of the strain rate enhanced crushing of the sample. The vertical-bedding shale samples had stronger ability to absorb energy and more internal crack propagation. Dissipative energies of the shale samples in the parallel- and vertical-bedding impact tests were positively related to the fractal dimension. The fractal dimension increased with the increase of dissipative energy during sample failure; with further increase in the dissipative energy, its effect on the change of fractal dimension gradually weakened.

scholarly journals Experimental Investigation on Dynamic Fracture Mechanism and Energy Evolution of Saturated Yellow Sandstone under Different Freeze-Thaw Temperatures

2019 ◽  
Vol 2019 ◽  
pp. 1-16 ◽  
Author(s):  
Liang Chen ◽  
Xianbiao Mao ◽  
Shengli Yang ◽  
Chao An ◽  
Peng Wu
Keyword(s):  
Particle Size ◽  
Energy Dissipation ◽  
Dynamic Fracture ◽  
Fracture Mechanism ◽  
Slope Failure ◽  
Dynamic Compression ◽  
Average Particle ◽  
Freeze Thaw ◽  
Side Slope ◽  
The Impact

The coupling effect of freeze-thaw (F-T) temperature and dynamic load on the dynamic mechanical properties and fracture mechanism of saturated yellow sandstone was experimentally investigated in this research. The dynamic compression tests on the specimen after different F-T temperatures (i.e., −5°С, −10°С, −15°С, −20°С, −30°С, and 20°С) have been carried out with split-Hopkinson pressure bar (SHPB) setup under eight F-T cycle numbers. The density and P-wave velocity of the specimens were obtained before and after the F-T tests. After the F-T tests, the specimen microstructures were examined via the scanning electron microscope (SEM). The dynamic fracture process was visualized by the high-speed camera. The particle size distribution and fragment shapes of the specimens were analyzed using a classifying screen. In addition, the energy dissipation law of specimens during the impact test was also discussed. Experimental results show that the dynamic elastic modulus, strength of the specimen, and the average particle size decrease with decreasing F-T temperature. SEM results reveal that low F-T temperature leads to severer internal damage of the specimen by inducing freeze-swell holes, interconnected cracks, and pore clusters. In addition, the fragmentation shapes of the failed specimens exhibit double-cone failure, single-side slope failure, double-side slope failure, and split failure. The energy dissipation increases gradually with increasing F-T temperature. This study helps to prevent geological disasters and optimize engineering design in cold regions.

scholarly journals Green Preparation, Spheroidal, and Superior Property of Nano-1,3,5,7-Tetranittro-1,3,5,7-Tetrazocane

2018 ◽  
Vol 2018 ◽  
pp. 1-8 ◽  
Author(s):  
Xinlei Jia ◽  
Jingyu Wang ◽  
Conghua Hou ◽  
Yingxin Tan
Keyword(s):  
Activation Energy ◽  
Particle Size ◽  
Fractal Dimension ◽  
Particle Size Distribution ◽  
Size Distribution ◽  
Fractal Theory ◽  
Crystal Form ◽  
Decomposition Temperature ◽  
Scanning Calorimetry ◽  
The Impact

Herein, a green process for preparing nano-HMX, mechanical demulsification shearing (MDS) technology, was developed. Nano-HMX was successfully fabricated via MDS technology without using any chemical reagents, and the fabrication mechanism was proposed. Based on the “fractal theory,” the optimal shearing time for mechanical emulsification was deduced by calculating the fractal dimension of the particle size distribution. The as-prepared nano-HMX was characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), and differential scanning calorimetry (DSC). And the impact sensitivities of HMX particles were contrastively investigated. The raw HMX had a lower fractal dimension of 1.9273. The ideal shearing time was 7 h. The resultant nano-HMX possessed a particle size distribution ranging from 203.3 nm to 509.1 nm as compared to raw HMX. Nano-HMX particles were dense spherical, maintaining β-HMX crystal form. In addition, they had much lower impact sensitivity. However, the apparent activation energy as well as thermal decomposition temperature of nano-HMX particles was decreased, attributing to the reduced probability for hotspot generation. Especially when the shearing time was 7 h, the activation energy was markedly decreased.

scholarly journals Seismic Damage Model of Bridge Piers Subjected to Biaxial Loading Considering the Impact of Energy Dissipation

2019 ◽  
Vol 9 (7) ◽  
pp. 1481 ◽  
Author(s):  
Shangshun Lin ◽  
Zhanghua Xia ◽  
Jian Xia
Keyword(s):  
Energy Dissipation ◽  
Structural Damage ◽  
Biaxial Loading ◽  
Mechanical Performance ◽  
Damage Model ◽  
Damage Index ◽  
Seismic Damage ◽  
Bridge Piers ◽  
Dissipated Energy ◽  
The Impact

The large degradation of the mechanical performance of hollow reinforced concrete (RC) bridge piers subjected to multi-dimensional earthquakes has not been thoroughly assessed. This paper aims to improve the existing seismic damage model to assess the seismic properties of tall, hollow RC piers subjected to pseudo-static, biaxial loading. Cyclic bilateral loading tests on fourteen 1/14-scale pier specimens with different slenderness ratios, axial load ratios, and transverse reinforcement ratios were carried out to investigate the damage propagation and the cumulative dissipated energy with displacement loads. By considering the influence of energy dissipation on structural damage, a new damage model (M-Usami model) was developed to assess the damage characteristics of hollow RC piers. The results present four consecutive damage stages during the loading process: (a) cracking on concrete surface, (b) yielding of longitudinal reinforcements; (c) spalling of concrete, and (d) collapsing of pier after the concrete crushed and the longitudinal bars ruptured due to the flexural failure. The damage level caused by the seismic waves can be reduced by designing specimens with a good seismic energy dissipation capacity. The theoretical damage index values calculated by the M-Usami model agreed well with the experimental observations. The developed M-Usami model can provide insights into the approaches to assessing the seismic damage of hollow RC piers subjected to bilateral seismic excitations.

Sign in / Sign up

Export Citation Format

Share Document