scholarly journals Study on Crack Initiation and Propagation of New Corrosion Inhibitor during Stress Corrosion of Aluminum Alloy

2020 ◽  
Vol 2020 ◽  
pp. 1-18
Author(s):  
Juan Du ◽  
Zi-ming Wei ◽  
Xu-dong Yang ◽  
Qing-mao Liu ◽  
Hai-peng Song ◽  
...  
Keyword(s):  
Aluminum Alloy ◽  
Crack Initiation ◽  
Corrosion Inhibitor ◽  
Electrochemical Impedance ◽  
Sodium Succinate ◽  
Sodium Dodecyl ◽  
Sodium Dodecyl Benzene Sulfonate ◽  
Inhibition Mechanism ◽  
Crack Initiation And Propagation ◽  
Initiation And Propagation

In this paper, a novel method combining electrochemical impedance spectroscopy (EIS) and phase shift was used to systematically study the effect of corrosion inhibitor (sodium succinate, sodium dodecyl benzene sulfonate, and new corrosion inhibitor, namely, bis [2-amino-3-(dodecyl dimethyl quaternary ammonium) propyl]-propylamine dichloro) on crack initiation and propagation of aluminum alloy during the slow strain rate tensile process. Using a variety of characterization methods to verify the feasibility of using the new method for in-situ prediction, Kramers–Kronig transformations have been used to validate the experimental data obtained with the EIS measurements. The corrosion inhibition mechanism of these three kinds of inhibitors in the SSRT process was analyzed.

Fatigue crack paths and properties in A356-T6 aluminum alloy microstructurally modified by friction stir processing under different conditions

2015 ◽  
Author(s):  
A. Tajiri ◽  
Y. Uematsu ◽  
T. Kakiuchi ◽  
Y. Suzuki
Keyword(s):  
Aluminum Alloy ◽  
Fatigue Crack ◽  
Crack Initiation ◽  
Friction Stir Processing ◽  
Casting Defects ◽  
Processing Conditions ◽  
Tool Rotational Speed ◽  
Crack Initiation And Propagation ◽  
Friction Stir ◽  
Initiation And Propagation

A356-T6 cast aluminum alloy is a light weight structural material, but fatigue crack initiates and propagates from a casting defect leading to final fracture. Thus it is important to eliminate casting defects. In this study, friction stir processing (FSP) was applied to A356-T6, in which rotating tool with probe and shoulder was plunged into the material and travels along the longitudinal direction to induce severe plastic deformation, resulting in the modification of microstructure. Two different processing conditions with low and high tool rotational speeds were tried and subsequently fully reversed fatigue tests were performed to investigate the effect of processing conditions on the crack initiation and propagation behavior. The fatigue strengths were successfully improved by both conditions due to the elimination of casting defects. But the lower tool rotational speed could further improve fatigue strength than the higher speed. EBSD analyses revealed that the higher tool rotational speed resulted in the severer texture having detrimental effects on fatigue crack initiation and propagation resistances.

Sign in / Sign up

Export Citation Format

Share Document