scholarly journals Numerical Simulation of Gas-Particle Two-Phase Flow in a Nozzle with DG Method

2019 ◽  
Vol 2019 ◽  
pp. 1-12 ◽  
Author(s):  
Duan Maochang ◽  
Yu Xijun ◽  
Chen Dawei ◽  
Qing Fang ◽  
Zou Shijun
Keyword(s):  
Flow Field ◽  
Gas Phase ◽  
Mass Fraction ◽  
Gas Flow ◽  
Two Phase Flow ◽  
Phase Flow ◽  
Governing Equations ◽  
Two Phase ◽  
Dg Method ◽  
The Impact

In this paper, the discontinuous Galerkin (DG) method is applied to solve the governing equations of the dispersed two-phase flow with the two-fluid Euler/Euler approach. The resulting governing equations are simple in form and the solution process is very natural. The characteristics of the gas-particle two-phase flow in an engine nozzle are mainly analyzed, and the impacts of the particle mass fraction and particle size on the flow field and engine performance are evaluated. Because of the addition of particles, the gas flow field undergoes significant modifications. Increase in the mass fraction leads to a significant thrust loss in the gas phase, and the impact of the particles on the gas phase could be substantial. Therefore, a quantitative study of thrust loss in the nozzle due to the particle impact is made. It is found that the gas thrust in the two-phase flow is reduced, but the total thrust of the two-phase flow increases to a certain extent.

Numerical Research about Two-Phase Flow under Different Acceleration in SRM with Embedded Nozzle

2013 ◽  
Vol 365-366 ◽  
pp. 233-236
Author(s):  
Xiong Chen ◽  
Hai Feng Xue ◽  
Yong Luo
Keyword(s):  
Flow Field ◽  
Gas Flow ◽  
Two Phase Flow ◽  
Particle Diameter ◽  
Phase Flow ◽  
Solid Rocket Motor ◽  
Two Phase ◽  
Axial Acceleration ◽  
The Difference ◽  
The Impact

The complex gas-solid two-phase flow in a full-sized solid rocket motor with embedded nozzle under different acceleration condition was simulated with Euler-Lagrange model. Influences of different particle diameters and acceleration conditions on particle trajectories were analyzed. Simulation results show that the difference between gas flow field and two-phase flow field is significant. The particle accumulation zone above inner wall of chamber and nozzle is mainly concentrated in two regions. The accretion of the particle diameter will cause the following property worse, and the particles can easily form a highly-concentrated aggregation flow. With the increasing of axial-acceleration, the impact point in line2 will move backward in rear head.

Numerical Simulation of Two-Phase Flow under High Acceleration in SRM with Submerged Nozzle

2013 ◽  
Vol 712-715 ◽  
pp. 1253-1258
Author(s):  
Hai Feng Xue ◽  
Xiong Chen ◽  
Yong Ping Wang ◽  
Ya Zheng
Keyword(s):  
Flow Field ◽  
Gas Flow ◽  
Two Phase Flow ◽  
Phase Flow ◽  
Particle Phase ◽  
Solid Rocket Motor ◽  
Two Phase ◽  
Submerged Nozzle ◽  
High Acceleration ◽  
Axial Acceleration

The two-dimension axisymmetric and two-phase flow in a full-size solid rocket motor with submerged nozzle under high acceleration condition has been simulated with Euler-Lagrange model. Without acceleration and under high axial acceleration on particle trajectories, the influences of different particle diameters were analyzed. The difference between gas flow field and two-phase flow field is significant. The particle accumulation zone above the inner wall of chamber and nozzle is mainly concentrated in two regions. The axial acceleration will intensify the impaction to the end of the chamber. The accretion of the particle phase diameter will increase the inertia of the particle phase, which may cause the following property worse, and the particles can easily form a highly-concentrated aggregation flow.

Compressibility Effects in the Gas Phase for Unsteady Annular Two-Phase Flow in a Microchannel

2006 ◽  
Author(s):  
Alexandru Herescu ◽  
Jeffrey S. Allen
Keyword(s):  
Shock Wave ◽  
Gas Phase ◽  
High Speed ◽  
Gas Flow ◽  
Two Phase Flow ◽  
Flow Behavior ◽  
Flow Section ◽  
Phase Flow ◽  
Two Phase ◽  
Gas Liquid Flow

High speed microscopy experiments investigating two-phase (gas-liquid) flow behavior in capillary-scale systems, that is, systems where capillary forces are important relative to gravitational forces, have revealed a unique unsteady annular flow with periodic destabilization of the gas-liquid interface. Standing waves develop on the liquid film and grow into annular lobes similar with those observed in low-speed two-phase flow. The leading face of the lobe will decelerate and suddenly become normal to the wall of the capillary, suggesting the possibility of a shock wave in the gas phase at a downstream location from the minimum gas flow section. Visualization of the naturally occurring convergent-divergent nozzle-like structures as well as a discussion on the possibility of shock wave formation are presented.

scholarly journals Gas-solid Erosion Wear Characteristics of Two-phase Flow Tee Pipe

Mechanika ◽  
2021 ◽  
Vol 27 (3) ◽  
pp. 193-200
Author(s):  
Jin HU ◽  
Hao ZHANG ◽  
Jie ZHANG ◽  
Shiwei NIU ◽  
Wenbo CAI
Keyword(s):  
Gas Flow ◽  
Two Phase Flow ◽  
Flow Direction ◽  
Element Model ◽  
Phase Flow ◽  
Erosion Wear ◽  
Two Phase ◽  
Wear Characteristics ◽  
Volume Method ◽  
The Impact

Particles erosion wear always consist in the intersection of tee pipe, which is an inevitable problem. In order to obtain the erosion wear characteristics of two-phase flow tee pipe, several cases of different inlet diameters are investigated numerically in this paper. Euler-Lagrange method is adopted to describe the gas-solid two-phase flow and the finite volume method is adopted to solve the erosion results. Meshing O-type grids to obtain the reasonable boundary layer in ICEM CFD. By verifying and comparing the turbulence intensity and velocity of the six meshes, a reasonable finite element model is selected. Intersection, the severest erosion region, is the location where the gas flow direction changes. The inlet diameter determines the region of the impact particles directly hitting the wall. When the inlet diameter is smaller, the erosion of the intersection is severer. As the inlet velocity increases, both the erosion of the intersection and the outlet pipe become severer. However, there are only the erosion scars at the intersection are affected, with the increase of particle mass flow.

Status of Advanced Two-Phase Flow Model Development for SRM Chamber Flow Field and Combustion Modeling

2004 ◽  
Author(s):  
Gary Luke ◽  
Mark Eagar ◽  
Michael Sears ◽  
Scott Felt ◽  
Bob Prozan
Keyword(s):  
Flow Field ◽  
Flow Model ◽  
Two Phase Flow ◽  
Model Development ◽  
Phase Flow ◽  
Two Phase ◽  
Combustion Modeling

The influence of the Stokes and Archimedes forces on the stability of a two-phase flow

2003 ◽  
Vol 3 ◽  
pp. 266-270
Author(s):  
B.H. Khudjuyerov ◽  
I.A. Chuliev
Keyword(s):  
Spectral Method ◽  
Stability Region ◽  
Gas Flow ◽  
Two Phase Flow ◽  
Solid Phase ◽  
Stability Characteristic ◽  
Phase Flow ◽  
Two Phase ◽  
The Stability

The problem of the stability of a two-phase flow is considered. The solution of the stability equations is performed by the spectral method using polynomials of Chebyshev. A decrease in the stability region gas flow with the addition of particles of the solid phase. The analysis influence on the stability characteristic of Stokes and Archimedes forces.

Numerical Analysis of Two-Phase Pipe Flow of Liquid Helium Using Multi-Fluid Model

2001 ◽  
Vol 123 (4) ◽  
pp. 811-818 ◽  
Author(s):  
Jun Ishimoto ◽  
Mamoru Oike ◽  
Kenjiro Kamijo
Keyword(s):  
Phase Transition ◽  
Gas Phase ◽  
Liquid Helium ◽  
Two Phase Flow ◽  
Fluid Model ◽  
Numerical Results ◽  
Phase Flow ◽  
Two Dimensional ◽  
Two Phase ◽  
Normal Fluid

The two-dimensional characteristics of the vapor-liquid two-phase flow of liquid helium in a pipe are numerically investigated to realize the further development and high performance of new cryogenic engineering applications. First, the governing equations of the two-phase flow of liquid helium based on the unsteady thermal nonequilibrium multi-fluid model are presented and several flow characteristics are numerically calculated, taking into account the effect of superfluidity. Based on the numerical results, the two-dimensional structure of the two-phase flow of liquid helium is shown in detail, and it is also found that the phase transition of the normal fluid to the superfluid and the generation of superfluid counterflow against normal fluid flow are conspicuous in the large gas phase volume fraction region where the liquid to gas phase change actively occurs. Furthermore, it is clarified that the mechanism of the He I to He II phase transition caused by the temperature decrease is due to the deprivation of latent heat for vaporization from the liquid phase. According to these theoretical results, the fundamental characteristics of the cryogenic two-phase flow are predicted. The numerical results obtained should contribute to the realization of advanced cryogenic industrial applications.

Two-Phase Flow Field Numerical Simulation in Scrubber for Exhaust Gas Desulfurization

2014 ◽  
Vol 541-542 ◽  
pp. 1288-1291
Author(s):  
Zhi Feng Dong ◽  
Quan Jin Kuang ◽  
Yong Zheng Gu ◽  
Rong Yao ◽  
Hong Wei Wang
Keyword(s):  
Numerical Simulation ◽  
Flow Field ◽  
Flue Gas ◽  
Two Phase Flow ◽  
Three Dimensional ◽  
Flue Gas Desulfurization ◽  
Parameter Design ◽  
Phase Flow ◽  
Two Phase ◽  
Entrance Angle

Calculation fluid dynamics software Fluent was used to conduct three-dimensional numerical simulation on gas-liquid two-phase flow field in a wet flue gas desulfurization scrubber. The k-ε model and SIMPLE computing were adopted in the analysis. The numerical simulation results show that the different gas entrance angles lead to internal changes of gas-liquid two-phase flow field, which provides references for reasonable parameter design of entrance angle in the scrubber.

scholarly journals Modeling of Interior Ballistic Gas-Solid Flow Using a Coupled Computational Fluid Dynamics-Discrete Element Method

2013 ◽  
Vol 80 (3) ◽  
Author(s):  
Cheng Cheng ◽  
Xiaobing Zhang
Keyword(s):  
Discrete Element Method ◽  
Gas Phase ◽  
Two Phase Flow ◽  
Discrete Element ◽  
Particle Collision ◽  
Contact Detection ◽  
Reconstruction Method ◽  
Phase Flow ◽  
Two Phase ◽  
Element Method

In conventional models for two-phase reactive flow of interior ballistic, the dynamic collision phenomenon of particles is neglected or empirically simplified. However, the particle collision between particles may play an important role in dilute two-phase flow because the distribution of particles is extremely nonuniform. The collision force may be one of the key factors to influence the particle movement. This paper presents the CFD-DEM approach for simulation of interior ballistic two-phase flow considering the dynamic collision process. The gas phase is treated as a Eulerian continuum and described by a computational fluid dynamic method (CFD). The solid phase is modeled by discrete element method (DEM) using a soft sphere approach for the particle collision dynamic. The model takes into account grain combustion, particle-particle collisions, particle-wall collisions, interphase drag and heat transfer between gas and solid phases. The continuous gas phase equations are discretized in finite volume form and solved by the AUSM+-up scheme with the higher order accurate reconstruction method. Translational and rotational motions of discrete particles are solved by explicit time integrations. The direct mapping contact detection algorithm is used. The multigrid method is applied in the void fraction calculation, the contact detection procedure, and CFD solving procedure. Several verification tests demonstrate the accuracy and reliability of this approach. The simulation of an experimental igniter device in open air shows good agreement between the model and experimental measurements. This paper has implications for improving the ability to capture the complex physics phenomena of two-phase flow during the interior ballistic cycle and to predict dynamic collision phenomena at the individual particle scale.

Sign in / Sign up

Export Citation Format

Share Document