scholarly journals Adaptive Gain Control Method of a Phase-Locked Loop for GNSS Carrier Signal Tracking

2018 ◽  
Vol 2018 ◽  
pp. 1-14
Author(s):  
Zhibin Luo ◽  
Jicheng Ding ◽  
Lin Zhao

The global navigation satellite system (GNSS) has been widely used in both military and civil fields. This study focuses on enhancing the carrier tracking ability of the phase-locked loop (PLL) in GNSS receivers for high-dynamic application. The PLL is a very popular and practical approach for tracking the GNSS carrier signal which propagates in the form of electromagnetic wave. However, a PLL with constant coefficient would be suboptimal. Adaptive loop noise bandwidth techniques proposed by previous researches can improve PLL tracking behavior to some extent. This paper presents a novel PLL with an adaptive loop gain control filter (AGCF-PLL) that can provide an alternative. The mathematical model based on second- and third-order PLL was derived. The error characteristics of the AGCF-PLL were also derived and analyzed under different signal conditions, which mainly refers to the different combinations of carrier phase dynamic and signal strength. Based on error characteristic curves, the optimal loop gain control method has been achieved to minimize tracking error. Finally, the completely adaptive loop gain control algorithm was designed. Comparable test results and analysis using the new method, conventional PLL, FLL-assisted PLL, and FAB-LL demonstrate that the AGCF-PLL has stronger adaptability to high target movement dynamic.

2009 ◽  
Vol 62 (3) ◽  
pp. 523-542 ◽  
Author(s):  
Hyoungmin So ◽  
Ghangho Kim ◽  
Taikjin Lee ◽  
Sanghoon Jeon ◽  
Changdon Kee

Multipath is one of the main error sources in global navigation satellite system (GNSS) positioning. The high-resolution correlator (HRC) is a multipath mitigation technique well known for its outstanding performance for mid-delayed multipath, but still has a remaining error for the short-delayed multipath. This paper proposes a modified HRC scheme that can remove or reduce the error for short-delayed multipath signals. It estimates the HRC tracking error and augments the conventional HRC with the estimates. The method was implemented with a software receiver and the test results show short-delayed multipath-induced errors were reduced to about one third of those from the conventional HRC.


2017 ◽  
Vol 71 (2) ◽  
pp. 257-280 ◽  
Author(s):  
Vinh T. Tran ◽  
Nagaraj C. Shivaramaiah ◽  
Thuan D. Nguyen ◽  
Joon W. Cheong ◽  
Eamonn P. Glennon ◽  
...  

Synchronisation of the received Pseudorandom (PRN) code and its locally generated replica is fundamental when estimating user position in Global Navigation Satellite System (GNSS) receivers. It has been observed through experiments that user position accuracy decreases if sampling frequency is an integer multiple of the nominal code rate. This paper provides an accuracy analysis based on the number of samples and the residual code phase of each code chip. The outcomes reveal that the distribution of residual code phases in the code phase range [0, 1/ns), where ns is the number of samples per code chip, is the root cause of accuracy degradation, rather than the ratio between sampling frequency and nominal code rate. Doppler frequencies, coherent integration periods, front-end filter bandwidths and received Carrier to Noise ratios (C/N0) also influence receiver accuracy. Also provided are a sampling frequency selection guideline and new proposed estimates of the correlation output and the Delay Locked Loop (DLL) tracking error, which can be applied to precisely model GNSS receiver baseband signal processing.


2019 ◽  
Vol 73 (3) ◽  
pp. 658-677
Author(s):  
Yiwei Wang ◽  
Zhigang Huang

To reduce the operational complexity of the multipath estimating delay lock loop (MEDLL) and improve its anti-multipath performance for strobe correlators, a combination anti-multipath scheme, namely, the MEDLL on-strobe correlation technique, is proposed for global navigation satellite system (GNSS) signal processing. Short-delay multipath rays are separated from the strobe correlation function by the MEDLL mechanism; the dot product between the estimation residue and the standard correlation function or the BOC-PRN correlation function is then computed to eliminate the potential tracking ambiguity. Finally, this non-coherent combination result is sent to the loop filter to obtain anti-multipath code tracking. The proposed method is analysed via simulator data with a software receiver under different front-end bandwidth conditions. The results corroborate the better multipath mitigation capability and lower computational burden, although it is still difficult to eliminate all multipath interference, especially when the front-end bandwidth is insufficient.


2016 ◽  
Vol 55 (17) ◽  
pp. 4589 ◽  
Author(s):  
Yue Zheng ◽  
Chunxi Zhang ◽  
Lijing Li ◽  
Lailiang Song ◽  
Wen Chen

2010 ◽  
Vol 32 (11) ◽  
pp. 2772-2775
Author(s):  
Fei-hua Chen ◽  
Xin-zhong Duo ◽  
Xiao-wei Sun

2018 ◽  
Vol 940 (10) ◽  
pp. 2-6
Author(s):  
J.A. Younes ◽  
M.G. Mustafin

The issue of calculating the plane rectangular coordinates using the data obtained by the satellite observations during the creation of the geodetic networks is discussed in the article. The peculiarity of these works is in conversion of the coordinates into the Mercator projection, while the plane coordinate system on the base of Gauss-Kruger projection is used in Russia. When using the technology of global navigation satellite system, this task is relevant for any point (area) of the Earth due to a fundamentally different approach in determining the coordinates. The fact is that satellite determinations are much more precise than the ground coordination methods (triangulation and others). In addition, the conversion to the zonal coordinate system is associated with errors; the value at present can prove to be completely critical. The expediency of using the Mercator projection in the topographic and geodetic works production at low latitudes is shown numerically on the basis of model calculations. To convert the coordinates from the geocentric system with the Mercator projection, a programming algorithm which is widely used in Russia was chosen. For its application under low-latitude conditions, the modification of known formulas to be used in Saudi Arabia is implemented.


Sign in / Sign up

Export Citation Format

Share Document