Abstract
In dentistry, 3D printing already has diverse applicability, and holds a great deal of promise to make possible many new and exciting treatments and approaches to manufacturing dental restorations. Better availability, shorter processing time, and descending costs have resulted in the increased use of RP. Concomitantly the development of medical applications is expanding. (Zaharia et al., 2017)Many different printing technologies exist, each with their own advantages and disadvantages. Unfortunately, a common feature of the more functional and productive equipment is the high cost of the equipment, the materials, maintenance, and repair, often accompanied by a need for messy cleaning, difficult post-processing, and sometimes onerous health and safety concerns (Dawood et al., 2015)Low-cost 3D printers represent a great opportunity in the dental and medical field, as they could allow surgeons to use 3D models at a very low cost and, therefore, democratize the use of these 3D models in various indications. However, efforts should be made to establish a unified validation protocol for low-cost RP 3D printed models, including accuracy, reproducibility, and repeatability tests. Asaumi et al., suggested that dimensional changes may not affect the success of surgical applications if such changes are within a 2% variation .However, the proposed cut-off of 2% should be furthermore discussed, as the same accuracy may be not required for all types of indications. (Silva et al., 2008; Maschio et al., 2016)This aim of the present study is to evaluate the dimensional accuracy of the 3D printed mandibular models fabricated by two different additive manufacturing techniques, using highly precise one as selective laser sintering (SLS) and a low-cost one as fused filament fabrication and whether they are both comparable in terms of precision. In addition to evaluation of dimensional accuracy of linear measurements of the mandible in CBCT scans.7 mandibular models will be recruited. Radio-opaque markers of gutta-percha balls will be applied on the model to act as guide pointsTen linear measurements (5 long distances: Inter-condylar, inter-coronoidal, inter-mandibular notch, length of left ramus, length of right ramus; as well as 5 short distances: Length of the body of the mandible at midline, length of the body of the mandible in the area of last left molar, as well as that of the last right molar, the distance between the tip of right condyle to the tip of the right coronoid, as well as that of their left counterparts) will be obtained using digital calliper, to act as the reference standard later. Scanning of the model by CBCT will be next , 3D printing of the scanned image using SLS and FFF printers will be done. Recording of same linear measurment will be done on printed models. Comparison of the recorded values vs reference standard is the last step
Additive Manufacturing Techniques for the Reconstruction of 3D Fetal Faces