scholarly journals Application of DC-AC Hybrid Grid and Solar Photovoltaic Generation with Battery Storage Using Smart Grid

2017 ◽  
Vol 2017 ◽  
pp. 1-16 ◽  
Author(s):  
Shoaib Rauf ◽  
Nasrullah Khan

Smart grid for the past few years has been the prime focus of research in power systems. The aim is to eliminate load shedding and problematic blackout conditions, further offering cheap and continuous supply of electricity for both large and small consumers. Another benefit is to integrate renewable energy resources with existing dump grid in more efficient and cost-effective manner. In past few years, growing demand for sustainable energy increases the consumption of solar PV. Since generation from solar PV is in DC and most of the appliances at home could be operated on DC, AC-DC hybrid distribution system with energy management system is proposed in this paper. EMS helps to shift or control the auxiliary load and compel the users to operate specific load at certain time slots. These techniques further help to manage the excessive load during peak and off peak hours. It demonstrates the practical implementation of DC-AC network with integration of solar PV and battery storage with existing infrastructure. The results show a remarkable improvement using hybrid AC-DC framework in terms of reliability and efficiency. All this functioning together enhances the overall efficiency; hence, a secure, economical, reliable, and intelligent system leads to a smart grid.

Author(s):  
Reza Tajik

Nowadays, the utilization of renewable energy resources in distribution systems (DSs) has been rapidly increased. Since distribution generation (DG) use renewable resources (i.e., biomass, wind and solar) are emerging as proper solutions for electricity generation. Regarding the tremendous deployment of DG, common distribution networks are undergoing a transition to DSs, and the common planning methods have become traditional in the high penetration level. Indeed, in conformity with the voltage violation challenge of these resources, this problem must be dealt with too. So, due to the high penetration of DG resources and nonlinear nature of most industrial loads, the planning of DG installation has become an important issue in power systems. The goal of this paper is to determine the planning of DG in distribution systems through smart grid to minimize losses and control grid factors. In this regard, the present work intending to propose a suitable method for the planning of DSs, the key properties of DS planning problem are evaluated from the various aspects, such as the allocation of DGs, and planning, and high-level uncertainties. Also depending on these analyses, this universal literature review addressed the updated study associated with DS planning. In this work, an operational design has been prepared for a higher performance of the power distribution system in the presence of DG. Artificial neural network (ANN) has been used as a method for voltage monitoring and generation output optimization. The findings of the study show that the proposed method can be utilized as a technique to improve the process of the distribution system under various penetration levels and in the presence of DG. Also, the findings revealed that the optimal use of ANN method leads to more controllable and apparent DS.


2019 ◽  
Vol 8 (2S11) ◽  
pp. 2293-2295

The smart grid is transformation method for out-of-date electric allocation system, smart grid is a fresh solution of upcoming infrastructure. It is used to Shield, scrutinize and auto optimize the electric operations from very high voltage network to disseminated structure. The smart grid is a grouping of information and the communication knowledge, transmission and distribution system. The standing traditional grid wasfurther down pressure and challengedvaried issues. There are many modifications between smart and traditional grids such as two way operations instead of one way operations, computational intellect, self-monitoring abilities, cyber protected communication, safe, cost-effective environment. Number of various literatures discussed the positive topographiesof smart grid for power systems. In this paper deliberated about the evaluation about Grid Architecture typicalfinished the Function Layers mapped on Zones and domains.


The smart grid is transformation method for out-of-date electric allocation system, smart grid is a fresh solution of upcoming infrastructure. It is used to Shield, scrutinize and auto optimize the electric operations from very high voltage network to disseminated structure. The smart grid is a grouping of information and the communication knowledge, transmission and distribution system. The standing traditional grid wasfurther down pressure and challengedvaried issues. There are many modifications between smart and traditional grids such as two way operations instead of one way operations, computational intellect, self-monitoring abilities, cyber protected communication, safe, cost-effective environment. Number of various literatures discussed the positive topographiesof smart grid for power systems. In this paper deliberated about the evaluation about Grid Architecture typicalfinished the Function Layers mapped on Zones and domains.


Author(s):  
Adnan Khashman ◽  
Kadri Buruncuk ◽  
Samir Jabr

The explosive growth in decision-support systems over the past 30 years has yielded numerous “intelligent” systems that have often produced less-than-stellar results (Michalewicz Z. et al., 2005). The increasing trend in developing intelligent systems based on neural networks is attributed to their capability of learning nonlinear problems offline with selective training, which can lead to sufficiently accurate online response. Artificial neural networks have been used to solve many problems obtaining outstanding results in various application areas such as power systems. Power systems applications can benefit from such intelligent systems; particularly for voltage stabilization, where voltage instability in power distribution systems could lead to voltage collapse and thus power blackouts. This article presents an intelligent system which detects voltage instability and classifies voltage output of an assumed power distribution system (PDS) as: stable, unstable or overload. The novelty of our work is the use of voltage output images as the input patterns to the neural network for training and generalizing purposes, thus providing a faster instability detection system that simulates a trained operator controlling and monitoring the 3-phase voltage output of the simulated PDS.


2014 ◽  
Vol 2014 ◽  
pp. 1-10 ◽  
Author(s):  
Ying-Yi Hong ◽  
Faa-Jeng Lin ◽  
Fu-Yuan Hsu

The Kyoto protocol recommended that industrialized countries limit their green gas emissions in 2012 to 5.2% below 1990 levels. Photovoltaic (PV) arrays provide clear and sustainable renewable energy to electric power systems. Solar PV arrays can be installed in distribution systems of rural and urban areas, as opposed to wind-turbine generators, which cause noise in surrounding environments. However, a large PV array (several MW) may incur several operation problems, for example, low power quality and reverse power. This work presents a novel method to reconfigure the distribution feeders in order to prevent the injection of reverse power into a substation connected to the transmission level. Moreover, a two-stage algorithm is developed, in which the uncertain bus loads and PV powers are clustered by fuzzy-c-means to gain representative scenarios; optimal reconfiguration is then achieved by a novel mean-variance-based particle swarm optimization. The system loss is minimized while the operational constraints, including reverse power and voltage variation, are satisfied due to the optimal feeder reconfiguration. Simulation results obtained from a 70-bus distribution system with 4 large PV arrays validate the proposed method.


Energies ◽  
2020 ◽  
Vol 13 (7) ◽  
pp. 1545 ◽  
Author(s):  
Sara Deilami ◽  
S. M. Muyeen

The electrification of transportation has been developed to support energy efficiency and CO2 reduction. As a result, electric vehicles (EVs) have become more popular in the current transport system to create more efficient energy. In recent years, this increase in EVs as well as renewable energy resources (RERs) has led to a major issue for power system networks. This paper studies electrical vehicles (EVs) and their applications in the smart grid and provides practical solutions for EV charging strategies in a smart power system to overcome the issues associated with large-scale EV penetrations. The research first reviews the EV battery infrastructure and charging strategies and introduces the main impacts of uncontrolled charging on the power grid. Then, it provides a practical overview of the existing and future solutions to manage the large-scale integration of EVs into the network. The simulation results for two controlled strategies of maximum sensitivity selection (MSS) and genetic algorithm (GA) optimization are presented and reviewed. A comparative analysis was performed to prove the application and validity of the solution approaches. This also helps researchers with the application of the optimization approaches on EV charging strategies. These two algorithms were implemented on a modified IEEE 23 kV medium voltage distribution system with switched shunt capacitors (SSCs) and a low voltage residential network, including EVs and nonlinear EV battery chargers.


2014 ◽  
Vol 573 ◽  
pp. 346-351
Author(s):  
G.S. Satheesh Kumar ◽  
Chinnadurai Nagarajan ◽  
M. Lizzy Nesa Bagyam

A Recent concept of distribution infrastructure plays a vital role in the efficient utilization of energy. To avoid global warming and greenhouse gas emission, carbon based power plant should be replaced with distributed renewable energy (DRE) such as wind, solar etc. Renewable energy resources can be integrated to grid by intelligent electronic devices (IED). This paper deals with the novel automation architecture that supports power distribution systems to avoid power blackout and also it briefs the major requirement of the smart grid distribution system needed for a competitive world. International standard IEC 61850 and IEC 61499 provides a solution for substation automation through intelligent logical nodes (ILNs) which enhances interoperability and configurability.Later an open source platform is used for enhancing the communication that automatically generates the data model and communication nodes for intelligent electronic devices.However for future requirements in smart grid, the addition of new functions as well as the adaptation of function for IEDs is necessary. A concept of reconfigurable software architecture is introduced for integrating distributed and renewable energy resources. Such interfaces and services provide adaptation of the functional structure and contribute efficient Smart Grid system. This survey summarizes the communication infrastructure of smart energy system.


2015 ◽  
Vol 11 (2) ◽  
pp. 159-164
Author(s):  
Noman Nisar ◽  
Jay Panchal

The reliability of power system under fault susceptible environment has become major challenge for the power sector units. The injection of renewable power source has increased the complexity for distribution system and to deal with massive network, evolution of smart-grid has been enforced, which works in an automated fashion to improve overall reliability, efficiency and quality of the system. Proactive Self-healing is a critical feature of smart-grid. This paper tries to explain the concept sensing the occurrence of fault beforehand and providing possible solution for self-healing in smart grid. The fundamental base for incorporating afore discussed technology viz. understanding nature of fault, sources of fault and implementation of effective measuring techniques are enumerated in paper briefly. Support required in terms of technology is reviewed towards the end followed by a case study of practical implementation of self-healing control in a distribution system.


Energies ◽  
2019 ◽  
Vol 12 (1) ◽  
pp. 143 ◽  
Author(s):  
Gerardo J. Osório ◽  
Miadreza Shafie-khah ◽  
Mohamed Lotfi ◽  
Bernardo J. M. Ferreira-Silva ◽  
João P. S. Catalão

The integration of renewable energy resources (RES) (such as wind and photovoltaic (PV)) on large or small scales, in addition to small generation units, and individual producers, has led to a large variation in energy production, adding uncertainty to power systems (PS) due to the inherent stochasticity of natural resources. The implementation of demand-side management (DSM) in distribution grids (DGs), enabled by intelligent electrical devices and advanced communication infrastructures, ensures safer and more economical operation, giving more flexibility to the intelligent smart grid (SG), and consequently reducing pollutant emissions. Consumers play an active and key role in modern SG as small producers, using RES or through participation in demand response (DR) programs. In this work, the proposed DSM model follows a two-stage stochastic approach to deal with uncertainties associated with RES (wind and PV) together with demand response aggregators (DRA). Three types of DR strategies offered to consumers are compared. Nine test cases are modeled, simulated, and compared in order to analyze the effects of the different DR strategies. The purpose of this work is to minimize DG operating costs from the Distribution System Operator (DSO) point-of-view, through the analysis of different levels of DRA presence, DR strategies, and price variations.


Sign in / Sign up

Export Citation Format

Share Document