scholarly journals Ligament and Droplet Generation by Oil Film on a Rotating Disk

2015 ◽  
Vol 2015 ◽  
pp. 1-14 ◽  
Author(s):  
Hengchao Sun ◽  
Guoding Chen ◽  
Li’na Wang ◽  
Fei Wang
Keyword(s):  
Film Thickness ◽  
Flow Rate ◽  
Rotational Speed ◽  
Two Phase Flow ◽  
Rotating Disk ◽  
Droplet Generation ◽  
Phase Flow ◽  
Two Phase ◽  
Disk Radius ◽  
Oil Film

The lubrication and heat transfer designs of bearing chamber depend on an understanding of oil/air two-phase flow. As initial and boundary conditions, the characteristics of ligament and droplet generation by oil film on rotating parts have significant influence on the feasibility of oil/air two-phase flow analysis. An integrated model to predict the oil film flow, ligament number, and droplet Sauter mean diameter (SMD) of a rotating disk, which is an abstraction of the droplet generation sources in a bearing chamber, is developed based on the oil film force balance analysis and wave theory. The oil film thickness and velocity, ligaments number, and droplet SMD are calculated as functions of the rotating disk radius, rotational speed and oil volume flow rate and oil properties. The theoretical results show that the oil film thickness and SMD are decreased with an increasing rotational speed, while the radial, transverse velocities, and ligament number are increased. The oil film thickness, radial velocity, and SMD are increased with an increasing oil flow rate, but the transverse velocity and ligament number are decreased. A test facility is built for the investigation into the ligament number of a rotating disk, and the measurement of ligament number is carried out by means of a high speed photography.

Influences of Impeller Diameter and Diffuser Blades on Air-Water Two-Phase Flow Performance of Centrifugal Pump

2005 ◽  
Author(s):  
Naoki Matsushita ◽  
Akinori Furukawa ◽  
Kusuo Okuma ◽  
Satoshi Watanabe
Keyword(s):  
Centrifugal Pump ◽  
Water Flow ◽  
Flow Rate ◽  
Rotational Speed ◽  
Flow Condition ◽  
High Performance ◽  
Two Phase Flow ◽  
Water Flow Rate ◽  
Phase Flow ◽  
Two Phase

A tandem arrangement of double rotating cascades and single diffuser cascade, proposed as a centrifugal pump with high performance in air-water two-phase flow condition, yields lower head due to the smallness of the impeller outlet in comparison with a impeller with large outlet diameter and no diffuser. Influences of impeller diameter change and installation of diffuser blades on two-phase flow performance were experimentally investigated under the case of the same volute casing. As the result, the similarity law of the diameter of impeller having the similar blade geometry and the rotational speed is satisfied even in two-phase flow condition. Comparing pump performances between a large impeller without diffuser blades and a small one with diffuser blades, higher two-phase flow performance is obtained by controlling the rotational speed of a small impeller with diffuser blades in the range of small water flow rates, while a large impeller with no diffuser gives high performance in the range of high water flow rate and small air flow rate.

Effect of two-phase flow on transmission torque of oil film at high rotational speeds

2018 ◽  
Vol 70 (8) ◽  
pp. 1367-1373 ◽  
Author(s):  
Fangwei Xie ◽  
Xudong Zheng ◽  
Yaowen Tong ◽  
Bing Zhang ◽  
Xinjian Guo ◽  
...  
Keyword(s):  
Flow Regime ◽  
Rotational Speed ◽  
Two Phase Flow ◽  
Fluid Model ◽  
Flow Region ◽  
Phase Flow ◽  
Field Variation ◽  
Two Phase ◽  
Content Type ◽  
Oil Film

Purpose The purpose of this paper is to study the working characteristics of hydro-viscous clutch at high rotational speeds and obtain the trend of flow field variation of oil film. Design/methodology/approach The FLUENT simulation model of the oil film between the friction disks is built. The effect of variation of working parameters such as input rotational speed, oil flow rate and film thickness on two-phase flow regime and transmission torque is studied by using the volume of fluid model. Findings The results show that the higher the rotational speed, the severer the cavitation is. In addition, the two-phase flow region makes the coverage of oil film over the friction pairs’ surface reduce, which results in a decrease in transmission torque for the hydro-viscous clutch. Originality/value These simulation results are of interest for the study of hydro-viscous drive and its applications. This study can also provide a theoretical basis for power transmission mechanism of oil film by considering the existence of a two-phase flow regime consisting of oil and air.

Air/Water Two-Phase Flow Performance of Contra-Rotating Axial Flow Pump and Rotational Speed Control of Rear Rotor

2005 ◽  
Author(s):  
Toru Shigemitsu ◽  
Akinori Furukawa ◽  
Satoshi Watanabe ◽  
Kusuo Okuma
Keyword(s):  
Flow Rate ◽  
Rotational Speed ◽  
Two Phase Flow ◽  
Axial Flow ◽  
Phase Flow ◽  
Two Phase ◽  
Rate Range ◽  
Flow Rate Range ◽  
Axial Flow Pump ◽  
Flow Pump

An application of contra-rotating rotors, consisting of front and rear rotors rotating in the opposite direction from each other, has been proposed against a demand for developing a higher specific speed axial flow pump with a more compact structure, higher efficiency and higher cavitation performance. As axial flow pumps are used for standby operations of air-lock and air/water mixing discharge to prevent floods, air/water two-phase flow performance of the contra-rotating pump has to be also investigated. In the present paper, therefore, experimental results on air/water two-phase flow performance of a test pump with contra-rotating rotors are shown and compared with those of a conventional axial flow pump, consisting of a front rotor and a rear stator. Even under two-phase flow conditions head characteristic curve of the contra-rotating type has a more strongly negative slope than that of the conventional type. The contra-rotating type maintains higher head and higher efficiency even in the low flow rate range and vice versa in the high flow rate range. This result will be discussed by considering the change of outlet flow from front rotor due to two-phase flow with the help of observed air behavior in the rotors. Then effects of changes of rear rotor rotational speed different from front rotor speed, which is an advantage of the contra-rotating axial flow pump, on two-phase flow performance are examined. Under the condition of constant ratio of air to water flow rates, the head rise of the rear rotor linearly increases with rear rotor rotational speed. Air/water two-phase flow performance of the contra-rotating axial flow pump can be improved by this control procedure for the rear rotor rotational speed.

scholarly journals Correction to Flow Rate Profile Interpretation for a Two-Phase Flow in Multistage Fractured Horizontal Wells by Inversion of DTS Data

ACS Omega ◽  
2020 ◽  
Vol 5 (41) ◽  
pp. 26955-26955
Author(s):  
Hongwen Luo ◽  
Beibei Jiang ◽  
Haitao Li ◽  
Ying Li ◽  
Zhangxin Chen
Keyword(s):  
Flow Rate ◽  
Two Phase Flow ◽  
Horizontal Wells ◽  
Phase Flow ◽  
Two Phase ◽  
Fractured Horizontal Wells ◽  
Rate Profile

scholarly journals Bubble behavior in horizontal two-phase flow under flow rate fluctuation

2014 ◽  
Vol 1 (4) ◽  
pp. TEP0019-TEP0019 ◽  
Author(s):  
Jun-ichi TAKANO ◽  
Hideaki MONJI ◽  
Akiko KANEKO ◽  
Yutaka ABE ◽  
Hiroyuki YOSHIDA ◽  
...  
Keyword(s):  
Flow Rate ◽  
Two Phase Flow ◽  
Phase Flow ◽  
Bubble Behavior ◽  
Two Phase ◽  
Rate Fluctuation

Research on Two-Phase Flow Instability in Evaporator of Refrigeration System

2010 ◽  
Author(s):  
Nan Liang ◽  
Changqing Tian ◽  
Shuangquan Shao
Keyword(s):  
Pressure Drop ◽  
Mass Flow Rate ◽  
Mass Flow ◽  
Flow Rate ◽  
Two Phase Flow ◽  
Density Wave ◽  
Phase Flow ◽  
Constant Mass ◽  
Refrigeration System ◽  
Two Phase

As one kind of fluid machinery related to the two-phase flow, the refrigeration system encounters more problems of instability. It is essential to ensure the stability of the refrigeration systems for the operation and efficiency. This paper presents the experimental investigation on the static and dynamic instability in an evaporator of refrigeration system. The static instability experiments showed that the oscillatory period and swing of the mixture-vapor transition point by observation with a camera through the transparent quartz glass tube at the outlet of the evaporator. The pressure drop versus mass flow rate curves of refrigerant two phase flow in the evaporator were obtained with a negative slope region in addition to two positive slope regions, thus making the flow rate a multi-valued function of the pressure drop. For dynamic instabilities in the evaporation process, three types of oscillations (density wave type, pressure drop type and thermal type) were observed at different mass flow rates and heat fluxes, which can be represented in the pressure drop versus mass flow rate curves. For the dynamic instabilities, density wave oscillations happen when the heat flux is high with the constant mass flow rate. Thermal oscillations happen when the heat flux is correspondingly low with constant mass flow rate. Though the refrigeration system do not have special tank, the accumulator and receiver provide enough compressible volume to induce the pressure drop oscillations. The representation and characteristic of each oscillation type were also analyzed in the paper.

scholarly journals Power Loss Mechanism and Flow Structure in Two-phase Flow Driven by a Rotating Disk

2019 ◽  
Vol 33 (1) ◽  
pp. 37-45 ◽  
Author(s):  
Kohei HIGASHIKAWA ◽  
Tomoaki WATAMURA ◽  
Kazuyasu SUGIYAMA
Keyword(s):  
Flow Structure ◽  
Power Loss ◽  
Two Phase Flow ◽  
Rotating Disk ◽  
Phase Flow ◽  
Two Phase ◽  
Loss Mechanism

Experimental, Numerical, and Statistical Investigation of Two Phase Flow in a Cylindrical Perforation Tunnel

2021 ◽  
Author(s):  
Ekhwaiter Abobaker ◽  
Abadelhalim Elsanoose ◽  
Mohammad Azizur Rahman ◽  
Faisal Khan ◽  
Amer Aborig ◽  
...  
Keyword(s):  
Numerical Simulation ◽  
Steady State ◽  
Statistical Analysis ◽  
Flow Rate ◽  
Gas Flow ◽  
Two Phase Flow ◽  
Phase Flow ◽  
Gas Flow Rate ◽  
Two Phase ◽  
Flow Through

Abstract Perforation is the final stage in well completion that helps to connect reservoir formations to wellbores during hydrocarbon production. The drilling perforation technique maximizes the reservoir productivity index by minimizing damage. This can be best accomplished by attaining a better understanding of fluid flows that occur in the near-wellbore region during oil and gas operations. The present work aims to enhance oil recovery by modelling a two-phase flow through the near-wellbore region, thereby expanding industry knowledge about well performance. An experimental procedure was conducted to investigate the behavior of two-phase flow through a cylindrical perforation tunnel. Statistical analysis was coupled with numerical simulation to expand the investigation of fluid flow in the near-wellbore region that cannot be obtained experimentally. The statistical analysis investigated the effect of several parameters, including the liquid and gas flow rate, liquid viscosity, permeability, and porosity, on the injection build-up pressure and the time needed to reach a steady-state flow condition. Design-Expert® Design of Experiments (DoE) software was used to determine the numerical simulation runs using the ANOVA analysis with a Box-Behnken Design (BBD) model and ANSYS-FLUENT was used to analyses the numerical simulation of the porous media tunnel by applying the volume of fluid method (VOF). The experimental data were validated to the numerical results, and the comparison of results was in good agreement. The numerical and statistical analysis demonstrated each investigated parameter’s effect. The permeability, flow rate, and viscosity of the liquid significantly affect the injection pressure build-up profile, and porosity and gas flow rate substantially affect the time required to attain steady-state conditions. In addition, two correlations obtained from the statistical analysis can be used to predict the injection build-up pressure and the required time to reach steady state for different scenarios. This work will contribute to the clarification and understanding of the behavior of multiphase flow in the near-wellbore region.

Sign in / Sign up

Export Citation Format

Share Document