scholarly journals Characterization and Performance Evaluation of Dye Sensitized Solar Cell Using Nanostructured TiO2Electrode

2014 ◽  
Vol 2014 ◽  
pp. 1-6 ◽  
Author(s):  
Sule Erten-Ela

Metal-free organic sensitizer consisting of donor, electron conducting, and anchoring anhydride groups was engineered at molecular level and synthesized. Dye sensitized solar cells based on conjugated naphthalene dye were fabricated using nanoporous electrode. Photoelectrodes with a 7 μm thick nanoporous layer and a 5 μm thick light-scattering layer were used to fabricate dye sensitized solar cells. DSSCs were fabricated in a FTO/nc-TiO2/organic dye/I-/I3-/Pt/FTO device geometry. Dye sensitized solar cell was characterized by current density-voltage (J-V) measurement. All current-voltage (I-V) measurements were done under 100 mW/cm2light intensity and AM 1.5 conditions. The photovoltaic data revealed a short circuit photocurrent density of 1.86 mA/cm2, an open circuit voltage of 430 mV, and a fill factor of 0.63, corresponding to an overall conversion efficiency of 0.53%.

2018 ◽  
Vol 382 ◽  
pp. 369-373
Author(s):  
Usana Mahanitipong ◽  
Preeyapat Prompan ◽  
Rukkiat Jitchati

The four thiocyanate free ruthenium(II) complexes; [Ru(N^N)2(C^N)]PF6were synthesized and characterized for dye sensitized solar cells (DSSCs). The results showed that the broad absorptions covered the visible region from metal to ligand charge transfer (MLCT) were obtained with the main peaks at 560, 490 and 400 nm. The materials were studied DSSC performance under standard AM 1.5. Compound PP1 showed the power conversion efficiency (PCE) at 3.10%, with a short-circuit photocurrent density (Jsc) of 7.99 mA cm-2, an open-circuit photovoltage (Voc) of 563 mV and a high fill factor (ff) of 0.690.


2014 ◽  
Vol 1008-1009 ◽  
pp. 78-81
Author(s):  
Nair Gomesh ◽  
Z. M. Arief ◽  
Syafinar Ramli ◽  
M Irwanto ◽  
Y. M. Irwan ◽  
...  

Dye Sensitized Solar Cells (DSSC) is another kind of solar cell from the third generation that forms a photovoltaic. DSSC is designed to reduce cost from usage of expensive material in conventional solar panels. The purpose of this project is to fabricate and compare dye sensitized solar cells (DSSC) by using organic dye from blueberry and blue dye from chemical substances. The DSSC is fabricated using ‘Doctor Blade’ method. Results are based on investigating the electrical performance and characteristic of the fabricated TiO2 solar cell based on these comparisons of dyes in order to investigate the potential of organic dyes as a light absorbing mechanism. The required data that is investigated are the open circuit voltage, Voc, short circuit current, Isc, fill factors, solar cells efficiency and UV absorption. Result shows good potential in the blueberry dyes as a sensitizer but further investigation is needed in order to fully understand the characteristic of these organic dyes.


RSC Advances ◽  
2016 ◽  
Vol 6 (17) ◽  
pp. 13964-13970 ◽  
Author(s):  
Takeshi Mori ◽  
Hitoshi Saomoto ◽  
Koji Machitani ◽  
Kaname Inoue ◽  
Yasunori Aoki ◽  
...  

We report the effect of the non-conjugated 5-position substituent of pyrazoline-based photosensitizers on the photophysical characteristics and performance of dye-sensitized solar cells (DSSCs).


2011 ◽  
Vol 2011 ◽  
pp. 1-7 ◽  
Author(s):  
Joe Otsuki ◽  
Yusho Takaguchi ◽  
Daichi Takahashi ◽  
Palanisamy Kalimuthu ◽  
Surya Prakash Singh ◽  
...  

We have prepared a novel piperidine-donor-substituted perylene sensitizer, PK0002, and studied the photovoltaic performance in dye-sensitized solar cells (DSSCs). Physical properties and photovoltaic performance of this new perylene derivative PK0002 are reported and compared with those of unsubstituted perylene sensitizer, PK0003. PK0002, when anchored to nanocrystalline TiO2 films, achieves very efficient sensitization across the whole visible range extending up to 800 nm. The incident photon-to-current conversion efficiency (IPCE) spectrum was consistent with the absorption spectrum and resulted in a high short-circuit photocurrent density (Jsc) of 8.8 mA cm-2. PK0002 showed higher IPCE values than PK0003 in the 520–800 nm region. Under standard AM 1.5 irradiation (100 mW cm-2) and using an electrolyte consisting of 0.6 M dimethylpropyl-imidazolium iodide, 0.05 M I2, 0.1 M LiI, and 0.5 M tert-butylpyridine in acetonitrile, a solar cell containing sensitizer PK0002 yielded a short-circuit photocurrent density of 7.7 mA cm-2, an open-circuit photovoltage of 0.57 V, and a fill factor of 0.70, corresponding to an overall conversion efficiency of 3.1%.


2015 ◽  
Vol 51 (18) ◽  
pp. 3915-3918 ◽  
Author(s):  
C. J. Wood ◽  
G. H. Summers ◽  
E. A. Gibson

New donor–π–acceptor dyes functionalised with a bodipy or indolium acceptor are described, which have an excellent spectral response in the red region and generate record photocurrent in tandem dye-sensitized solar cells. Our cationic acceptor dye, CAD3, generated a cathodic photocurrent density of 8.2 mA cm−2, the highest reported for a NiO p-type solar cell to date.


2011 ◽  
Vol 2011 ◽  
pp. 1-5 ◽  
Author(s):  
Yanzhen Yang ◽  
Renjie Sun ◽  
Chengwu Shi ◽  
Yucheng Wu ◽  
Mei Xia

N-(2-hydroxyethyl)ethylenediaminium iodides (HEEDAIs) and N-(2-hydroxyethyl)piperazinium iodides (HEPIs) were synthesized, and their thermal properties were analysed. The influence of HEEDAI and HEPI onI3-/I-redox behavior in binary ionic liquid was investigated. The result revealed that HEEDAI can suppress the recombination betweenI3-and the injected electrons in TiO2conduction band and be used as the alternative of 4-tert-butylpyridine in the electrolyte of dye-sensitized solar cells. The electrolyte C, 0.15 mol⋅L−1I2, HEEDAI and MPII with mass ratio of 1 : 4, gave the short-circuit photocurrent density of 9.36 mA⋅cm−2, open-circuit photovoltage of 0.67 V, fill factor of 0.52, and the corresponding photoelectric conversion efficiency of 3.24% at the illumination (air mass 1.5, 100 mW⋅cm−2, active area 0.25 cm2).


2012 ◽  
Vol 2012 ◽  
pp. 1-7 ◽  
Author(s):  
Jeum-Jong Kim ◽  
Jeonghun Yoon ◽  
Eun Jung Kim ◽  
Bo Ram Kim ◽  
Yong-Jin Yoon ◽  
...  

Novel ruthenium bipyridyl sensitizer incorporating conjugated benzo[1,9]quinolizino-(acridin-2-yl)vinyl-2,2′-bipyridine ligand [JJ-12] has been synthesized and demonstrated as efficient sensitizer in dye-sensitized solar cells. A mesoporous titania film stained withJJ-12exhibits a remarkable incident monochromatic photon-to-current conversion efficiency of 82%. Under standard AM 1.5 sunlight, the solar cell using a liquid-based electrolyte consisting of 0.6 M 1,2-dimethyl-3-propylimidazolium iodide (DMPII), 0.05 M I2, 0.1 M LiI, and 0.5 Mtert-butylpyridine in acetonitrile exhibits a short-circuit photocurrent density of 16.47 mA/cm2, an open-circuit voltage of 0.71 V, and a fill factor of 0.71, corresponding to an overall conversion efficiency of 8.34 %.


2018 ◽  
Vol 11 (03) ◽  
pp. 1850051 ◽  
Author(s):  
Chu Qin ◽  
Dingyu Yang ◽  
Peng Gu ◽  
Xinghua Zhu ◽  
Hui Sun

The dye-sensitized solar cells (DSSCs) have been fabricated by using a series of natural dyes extracted from euonymus japonicus and purple plants. The optical characteristics and chemical structure of dyes were investigated by UV-visible spectroscopy and Fourier infrared spectroscopy. It is found that the absorption of sunlight and bonding performance to TiO2 electrode of dyes had significantly effects on the conversion efficiency of solar cells. The results show the cells using blueberry as sensitizer achieved best conversion efficiency of 0.218%, attributed to its strong absorption and excellent bonding to the TiO2 electrode, correspondingly, the short-circuit photocurrent density ([Formula: see text] and open-circuit voltage ([Formula: see text] were 1.3[Formula: see text]mA/cm2 and 430[Formula: see text]mV, respectively.


2014 ◽  
Vol 2014 ◽  
pp. 1-7 ◽  
Author(s):  
Jeum-Jong Kim ◽  
Mangu Kang ◽  
Ock Keum Kwak ◽  
Yong-Jin Yoon ◽  
Kil Sik Min ◽  
...  

We have developed dye-sensitized solar cells using novel sensitizers with enhanced transmittance of red (625–675 nm) and blue (425–475 nm) wavebands to control the illumination condition in the greenhouse. Novel ruthenium bipyridyl sensitizers with general formulas (Me3PhN)4[Ru(dcbpy)2(NCS)2] (JJ-7) and (Me3BnN)4[Ru(dcbpy)2(NCS)2] (JJ-9) have been synthesized and demonstrated as efficient sensitizers in dye-sensitized solar cells for greenhouse application. Under standard AM 1.5 sunlight, the solar cell ofJJ-7using a liquid-based electrolyte exhibits a short-circuit photocurrent density of 8.49 mA/cm2, an open-circuit voltage of 0.83 V, and a fill factor of 0.71, corresponding to an overall conversion efficiency of 4.96% on 5 μm TiO2film. The transmittance ofJJ-7andJJ-9shows 62.0% and 61.0% at 660 nm and 18.0% and 15.0% at 440 nm for cultivation on 5 μm TiO2film, respectively.


2014 ◽  
Vol 2014 ◽  
pp. 1-7 ◽  
Author(s):  
Hyo Jeong Jo ◽  
Jung Eun Nam ◽  
Dae-Hwan Kim ◽  
Hyojeong Kim ◽  
Jin-Kyu Kang

A new multicarbazole based organic dye (C2A1,C2S1A1) with a twisted structure was designed and synthesized, and the corresponding dye (C1A1) without the twisted structure was synthesized for comparison. They were successfully applied in dye-sensitized solar cells (DSSCs). The results showed that the nonplanar structure ofC2A1andC2S1A1can efficiently retard the dye aggregation and charge recombination. The organic dye (C2S1A1) with thiophene units also exhibited a higher molar extinction coefficient and red-shifted absorption, which leads to an improved light harvesting efficiency. TheC2S1A1-sensitized solar cell produced a solar-to-electricity conversion efficiency of 5.1%, high open circuit voltage (Voc) of 0.69 V, and short-circuit photocurrent density of 10.83 mA cm−2under AM 1.5 irradiation (100 mW cm−2) conditions.


Sign in / Sign up

Export Citation Format

Share Document