scholarly journals Optical Amplification at 1525 nm in BaYF5: 20% Yb3+, 2% Er3+Nanocrystals Doped SU-8 Polymer Waveguide

2014 ◽  
Vol 2014 ◽  
pp. 1-6 ◽  
Author(s):  
Pengcheng Zhao ◽  
Meiling Zhang ◽  
Tianjiao Wang ◽  
Xinyang Liu ◽  
Xuesong Zhai ◽  
...  
Keyword(s):  
Optical Gain ◽  
Core Material ◽  
Optical Amplification ◽  
Polymer Waveguide ◽  
The Core ◽  
Optical Polymer ◽  
Input Signal Power ◽  
High Boiling Solvent ◽  
Average Size ◽  
Doped Polymer

We demonstrated optical amplification in BaYF5: 20% Yb3+, 2% Er3+(BYF) nanocrystals doped polymer waveguide. BYF nanocrystals with an average size of ∼13 nm were synthesized by a high-boiling solvent process. Intense 1.53 μm fluorescence was obtained in the nanocrystals under excitation at 980 nm. An optical polymer waveguide was fabricated by using BYF nanocrystals doped SU-8 polymer as the core material. A relative optical gain of ∼10.4 dB at 1525 nm was achieved in a 1.1 cm long waveguide for an input signal power of ∼0.09 mW and a pump power of ∼212 mW.

Optical gain based on NaYF4: Er3+, Yb3+ nanoparticles-doped polymer waveguide under convenient LED pumping

2021 ◽  
Vol 118 (17) ◽  
pp. 173301
Author(s):  
Zhaoqin Zhou ◽  
Jiabi Xue ◽  
Baoping Zhang ◽  
Ce Wang ◽  
Xingchen Yang ◽  
...  
Keyword(s):  
Optical Gain ◽  
Polymer Waveguide ◽  
Doped Polymer

Demonstration of Optical Gain at 1550 nm in Erbium–Ytterbium Co-Doped Polymer Waveguide Amplifier

2010 ◽  
Vol 10 (3) ◽  
pp. 1947-1950 ◽  
Author(s):  
Cong Chen ◽  
Dan Zhang ◽  
Tong Li ◽  
Daming Zhang ◽  
Limei Song ◽  
...  
Keyword(s):  
Optical Gain ◽  
Polymer Waveguide ◽  
Doped Polymer ◽  
Co Doped

scholarly journals Acoustic Panels Made of Paper Sludge and Clay Composites

2021 ◽  
Vol 13 (2) ◽  
pp. 637
Author(s):  
Tomas Astrauskas ◽  
Tomas Januševičius ◽  
Raimondas Grubliauskas
Keyword(s):  
Absorption Coefficient ◽  
Sound Absorption ◽  
Composite Panel ◽  
Sound Absorption Coefficient ◽  
Core Material ◽  
Paper Sludge ◽  
Frequency Range ◽  
Absorption Properties ◽  
Air Gaps ◽  
The Core

Studies on recycled materials emerged during recent years. This paper investigates samples’ sound absorption properties for panels fabricated of a mixture of paper sludge (PS) and clay mixture. PS was the core material. The sound absorption was measured. We also consider the influence of an air gap between panels and rigid backing. Different air gaps (50, 100, 150, 200 mm) simulate existing acoustic panel systems. Finally, the PS and clay composite panel sound absorption coefficients are compared to those for a typical commercial absorptive ceiling panel. The average sound absorption coefficient of PS-clay composite panels (αavg. in the frequency range from 250 to 1600 Hz) was up to 0.55. The resulting average sound absorption coefficient of panels made of recycled (but unfinished) materials is even somewhat higher than for the finished commercial (finished) acoustic panel (αavg. = 0.51).

scholarly journals Iron Based Core-Shell Structures as Versatile Materials: Magnetic Support and Solid Catalyst

Catalysts ◽  
2021 ◽  
Vol 11 (1) ◽  
pp. 72
Author(s):  
Christian Zambrzycki ◽  
Runbang Shao ◽  
Archismita Misra ◽  
Carsten Streb ◽  
Ulrich Herr ◽  
...  
Keyword(s):  
Water Purification ◽  
Functional Materials ◽  
Core Material ◽  
Solid Catalyst ◽  
Core Shell ◽  
Shell Nanoparticles ◽  
The Core ◽  
Shell Nanostructures ◽  
Sio2 Shell ◽  
Iron Based

Core-shell materials are promising functional materials for fundamental research and industrial application, as their properties can be adapted for specific applications. In particular, particles featuring iron or iron oxide as core material are relevant since they combine magnetic and catalytic properties. The addition of an SiO2 shell around the core particles introduces additional design aspects, such as a pore structure and surface functionalization. Herein, we describe the synthesis and application of iron-based core-shell nanoparticles for two different fields of research that is heterogeneous catalysis and water purification. The iron-based core shell materials were characterized by transmission electron microscopy, as well as N2-physisorption, X-ray diffraction, and vibrating-sample magnetometer measurements in order to correlate their properties with the performance in the target applications. Investigations of these materials in CO2 hydrogenation and water purification show their versatility and applicability in different fields of research and application, after suitable individual functionalization of the core-shell precursor. For design and application of magnetically separable particles, the SiO2 shell is surface-functionalized with an ionic liquid in order to bind water pollutants selectively. The core requires no functionalization, as it provides suitable magnetic properties in the as-made state. For catalytic application in synthesis gas reactions, the SiO2-stabilized core nanoparticles are reductively functionalized to provide the catalytically active metallic iron sites. Therefore, Fe@SiO2 core-shell nanostructures are shown to provide platform materials for various fields of application, after a specific functionalization.

scholarly journals Polymer Optical Waveguide Sensor Based on Fe-Amino-Triazole Complex Molecular Switches

Polymers ◽  
2021 ◽  
Vol 13 (2) ◽  
pp. 195
Author(s):  
Muhammad Shaukat Khan ◽  
Hunain Farooq ◽  
Christopher Wittmund ◽  
Stephen Klimke ◽  
Roland Lachmayer ◽  
...  
Keyword(s):  
Molecular Complex ◽  
Electromagnetic Interference ◽  
Optical Power ◽  
Uv Curing ◽  
Molecular Complexes ◽  
Core Material ◽  
Absorption Bands ◽  
Electronic Temperature ◽  
Polymer Waveguide ◽  
Temperature Detection

We report on a polymer-waveguide-based temperature sensing system relying on switchable molecular complexes. The polymer waveguide cladding is fabricated using a maskless lithographic optical system and replicated onto polymer material (i.e., PMMA) using a hot embossing device. An iron-amino-triazole molecular complex material (i.e., [Fe(Htrz)2.85(NH2-trz)0.15](ClO4)2) is used to sense changes in ambient temperature. For this purpose, the core of the waveguide is filled with a mixture of core material (NOA68), and the molecular complex using doctor blading and UV curing is applied for solidification. The absorption spectrum of the molecular complex in the UV/VIS light range features two prominent absorption bands in the low-spin state. As temperature approaches room temperature, a spin-crossover transition occurs, and the molecular complex changes its color (i.e. spectral properties) from violet-pink to white. The measurement of the optical power transmitted through the waveguide as a function of temperature exhibits a memory effect with a hysteresis width of approx. 12 °C and sensitivity of 0.08 mW/°C. This enables optical rather than electronic temperature detection in environments where electromagnetic interference might influence the measurements.

scholarly journals nanocrystals (0 ≤ x ≤ 1): growth, size control and shell formation on β-NaCeF4:Tb core particles

CrystEngComm ◽  
2020 ◽  
Vol 22 (46) ◽  
pp. 8036-8044
Author(s):  
Jannis Wehmeier ◽  
Markus Haase
Keyword(s):  
Size Control ◽  
Lattice Parameters ◽  
Core Material ◽  
Shell Formation ◽  
Shell Material ◽  
Strontium Content ◽  
The Core ◽  
Lighter Lanthanides ◽  
Core Particles

is an interesting shell material for β-NaREF4 particles of the lighter lanthanides (RE = Ce, Pr, Nd), as variation of its strontium content x allows to vary its lattice parameters and match those of the core material.

SHELL MATERIAL'S PERFORMANCE OF THE MICROCAPSULE FOR ELECTROLYTIC CO-DEPOSITION

2010 ◽  
Vol 24 (15n16) ◽  
pp. 3124-3130 ◽  
Author(s):  
HUI CONG LIU ◽  
XIU QING XU ◽  
WEI PING LI ◽  
YAN HONG GUO ◽  
LI-QUN ZHU
Keyword(s):  
Composite Coating ◽  
Methyl Cellulose ◽  
Water Vapor Permeability ◽  
Core Material ◽  
Vapor Permeability ◽  
Shell Material ◽  
The Core ◽  
Surface Performance ◽  
The Stability ◽  
Positive Effect

The shell material of microcapsules has an important effect on the electrolytic co-deposition behavior, the release of core material and the surface performance of composite coating. This paper discussed the tensile property and the stability of three shell materials including polyvinyl alcohol (PVA), gelatin and methyl cellulose (MC). It is found that these three shell materials have good mechanical strength and flexibility which are favorable to electrolytic co-deposition and stability of microcapsules in composite coating and that MC has well permeability and porosity which has a positive effect on the release of the core material in composite coating. Moreover, the study of the thermal properties and water vapor permeability of the three shell materials showed that their permeability improved with increase of temperature and humidity. In addition, the composite copper coating containing microcapsules with PVA, gelatin or MC as shell material was prepared respectively.

Damage behavior of potting materials in sandwich composites with pinned joints

2015 ◽  
Vol 22 (5) ◽  
Author(s):  
Cesim Atas ◽  
Alper Basmaci
Keyword(s):  
Core Material ◽  
Sandwich Composite ◽  
Composite Panels ◽  
Sandwich Composites ◽  
Resin Infusion ◽  
Damage Behavior ◽  
Mechanical Joints ◽  
The Core ◽  
Bottom Face ◽  
Infusion Technique

AbstractThe damage behavior of the potting materials around a pinhole, being used in the mechanical joints of sandwich composites, is investigated experimentally. The sandwich composite panels used in the tests were manufactured by the vacuum-assisted resin infusion technique. Each of the top and bottom face sheets of the panels consisted of two woven E-glass/epoxy layers. As the core material, PVC foam (AIREX

Rib waveguide dye-doped polymer amplifier with up to 26dB optical gain at 625nm

2004 ◽  
Vol 85 (22) ◽  
pp. 5137-5139 ◽  
Author(s):  
M. A. Reilly ◽  
C. Marinelli ◽  
C. N. Morgan ◽  
R. V. Penty ◽  
I. H. White ◽  
...  
Keyword(s):  
Optical Gain ◽  
Rib Waveguide ◽  
Doped Polymer

Release Profile of a Model Protein Drug Depending on the Stability of Microspheres Based on Polyelectrolyte Complex

2007 ◽  
Vol 342-343 ◽  
pp. 505-508
Author(s):  
Sung Won Kim ◽  
Yun Sik Nam ◽  
Yeon Jin Min ◽  
Jong Ho Kim ◽  
Kwang Meyong Kim ◽  
...  
Keyword(s):  
Polyelectrolyte Complex ◽  
Coating Layer ◽  
Great Influence ◽  
Release Profile ◽  
Core Material ◽  
Glycol Chitosan ◽  
The Core ◽  
Key Factor ◽  
Model Protein ◽  
The Stability

Stability and disintegration of natural polyelectrolyte complex microspheres for protein drugs delivery have been extensively investigated because of their great influence on the drug release patterns. In this study, we tested stability of microspheres with alginate (Alg) core layered by either chitosan (Chi) or glycol chitosan (GChi) by examining release profiles of fluorophorelabeled bovine serum albumin (BSA) and lysozyme (Lys) from the microspheres. While GChi shell was disintegrated quickly, Chi-shell microspheres showed good stability in PBS. Disintegration of the coated layer induced the core material instable. The results indicated that while the charges of the shell material provided additional diffusion barrier against the protein release, the key factor to hold the proteins inside the microspheres was the integrity of the outer coating layer.

Sign in / Sign up

Export Citation Format

Share Document