scholarly journals Investigations on the Outdoor Performance Characteristics of Multicrystalline Silicon Solar Cell and Module

2013 ◽  
Vol 2013 ◽  
pp. 1-4
Author(s):  
Sivakumar Parthasarathy ◽  
P. Neelamegam ◽  
P. Thilakan ◽  
N. Tamilselvan
Keyword(s):  
Solar Cell ◽  
Silicon Solar Cell ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Critical Value ◽  
Standard Test ◽  
Open Circuit ◽  
Multicrystalline Silicon ◽  
In Series

Multicrystalline silicon solar cell and its module with 18 cells connected in series were mounted on an inclined rack tilted 12° South positioned at latitude of 12.0107° and longitude of 79.856°. Corresponding solar irradiance was measured using an optical Pyranometer. Measured irradiance, open circuit voltage (), and short circuit current () values were analyzed. values of both the cell and module were found saturated at above the critical value of illuminations which were different from each other. The integrated daily efficiency for the cell and module were ~10.25% and ~9.39%, respectively, that were less than their respective standard test condition’s value. The reasons for this drop in efficiencies were investigated and reported.

Photoelectrical and Photovoltaic Peroperties of n-ZnO/p-Si Heterojunction

2011 ◽  
Vol 399-401 ◽  
pp. 1477-1480
Author(s):  
Yan Li Xu ◽  
Jin Hua Li
Keyword(s):  
Solar Cell ◽  
Silicon Solar Cell ◽  
Ion Beam ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Open Circuit ◽  
Textured Surface ◽  
Si Solar Cell ◽  
The One ◽  
P Type

n-ZnO thin films doped In with 2 atm.% were deposited on p-type silicon wafer with textured surface by Ion Beam Enhanced Deposition method, after annealing and prepared front and back electrodes, the n-ZnO/p-Si heterojunction samples were fabricated. The photoelectric property of the sample were measured and compared with silicon solar cell. The result indicated the saturated photocurrent of n-ZnO/p-Si heterojunction was 20% greater than one of the Si solar cell. It means the ZnO/Si heterojunction has a higher ability of produce photoelectron then one of silicon solarcell. The result of the photovoltaic test of n-ZnO/p-Si heterojunction show The open circuit voltage and short-circuit current of the n-ZnO/p-Si heterojunction was 400mV and 5.5mA/cm2 respectively. It was much smaller than the one of silicon solar cells. The reason was discussed

Effect of Assets of Silicon Film Passivation Layer on the Performance of Silicon Nanowire Solar Cells

2014 ◽  
Vol 633-634 ◽  
pp. 509-512
Author(s):  
Ping Yang ◽  
Xiang Bo Zeng ◽  
Xiao Dong Zhang ◽  
Zhan Guo Wang
Keyword(s):  
Solar Cell ◽  
Current Density ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Silicon Film ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit ◽  
Passivation Layer ◽  
Hydrogen Dilution

Silicon film as a surface passivation layer is reported to reduce surface recombination on silicon nanowires (SiNWs) and thus enable to improve SiNW solar cell (SC) performance. A question yet to be answered regards the link between the silicon film assets and the solar cell performances. We investigated the effect of the properties of silicon films on the SiNWs SC performances by adjusting hydrogen dilution. Our results showed that the open-circuit voltage (Voc) and short-circuit current density (Jsc) of SiNWs SC increase until hydrogen dilution 10 and then decrease. An open-circuit voltage of 0.397 V and short-circuit current density of 18.42 mA/cm2 are achieved at optimized hydrogen dilution. Based on the analysis of silicon film properties we proposed that the increase of defect density with hydrogen dilution was the main cause for the deterioration of SiNWs SC performance.

An Investigation on Dye-Sensitized Solar Cell Performance Influenced by Radiant Intensity and Illuminated Area in Concentrating Photovoltaic System

2014 ◽  
Vol 1070-1072 ◽  
pp. 616-619
Author(s):  
Wen Bo Xiao ◽  
Jin Dai ◽  
Guo Hua Tu ◽  
Hua Ming Wu
Keyword(s):  
Solar Cell ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Open Circuit ◽  
Photovoltaic System ◽  
Dye Sensitized Solar Cell ◽  
Solar Cell Performance ◽  
Radiant Intensity ◽  
Dye Sensitized

The dye-sensitized solar cell performances influenced by radiant intensity and illuminated area in concentrating photovoltaic system are investigated experimentally and discussed theoretically. The results show that, under the same irradiated cells area, the short-circuit current is linearly increasing with the radiant intensity and the open-circuit voltage follows a logarithmic function of the radiant intensity. And, it is turned out that the short-circuit current and open-circuit voltage are obviously enhanced by increasing the illuminated cells surface area at the same radiant intensity. However, that growth trends will decline with an increase of the illuminated area. The reason is more defects involved in the process of increasing illumination area. All results can be interpreted using an equivalent circuit of a single diode model. A good agreement can be observed from the fitting curves. It is of great significance for current photovoltaic research.

Solar Cells from Thin Silicon Layers on AlN

2007 ◽  
Vol 280-283 ◽  
pp. 1161-1162 ◽  
Author(s):  
Zhi Jian Wan ◽  
Yong Huang ◽  
Hou Xing Zhang ◽  
Hai Feng Li
Keyword(s):  
Solar Cell ◽  
Polycrystalline Silicon ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Chemical Vapor ◽  
Short Circuit Current ◽  
Zone Melting ◽  
Open Circuit ◽  
Ceramic Substrates ◽  
Columnar Grains

Polycrystalline silicon layers were grown on AlN ceramic substrates in a rapid thermal chemical vapor deposition system at high temperature (~1150°C). Larger columnar grains, > 5µm in size, were obtained by the zone melting recrystallization (ZMR) technique. The p-n junction is formed by a phosphorous diffusion process to make a solar cell. Solar cell devices based on this Si layer result possess an open-circuit voltage of about 0.17V and a short-circuit current of about 6.6mA/cm2.

A Study on Optical and Electrical Properties of Solar Cells of a-Si1-XGeX:H

2011 ◽  
Vol 347-353 ◽  
pp. 3666-3669
Author(s):  
Ming Biao Li ◽  
Li Bin Shi
Keyword(s):  
Solar Cell ◽  
Electrical Properties ◽  
Conversion Efficiency ◽  
Fill Factor ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit ◽  
Optical And Electrical Properties

The AMPS-ID program is used to investigate optical and electrical properties of the solar cell of a-SiC:H/a-Si1-xGex:H/a-Si:H thin films. The short circuit current density, open circuit voltage, fill factor and conversion efficiency of the solar cell are investigated. For x=0.1, the conversion efficiency of the solar cell achieve maximum 9.19 % at the a-Si1-xGex:H thickness of 340 nm.

scholarly journals PREPARATION AND CHARACTERIZATION OF P3HT-PCBM ORGANIC SOLAR CELLS

2013 ◽  
pp. 23-25
Author(s):  
ANUBHAV GUPTA ◽  
PRAVEEN S ◽  
ABHISHEK KUMAR ◽  
PRIYANKA SHREE ◽  
SUCHANA MISHRA
Keyword(s):  
Solar Cells ◽  
Solar Cell ◽  
Active Layer ◽  
Organic Solar Cells ◽  
Silicon Solar Cell ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Open Circuit ◽  
Glass Substrates

Organic solar cells using P3HT: PCBM as an active layer on ITO coated glass substrates were fabricated and characterized. Different air annealing procedures and cathode materials were tried and the characteristics were compared with that of a standard thin film polycrystalline silicon solar cell. It was found that the sample prepared with post-deposition air annealing at 130 oC improves the open circuit voltage (Voc) considerably. Besides, short circuit current (Isc) and the efficiency (η) were highest for the sample with a non annealed active layer. Series resistance (Rs) for this sample was lowest, but 103 times higher than that of the silicon solar cell, which in turn may have reduced the efficiency value for the organic cell compared to silicon.

scholarly journals Damp-Heat Induced Performance Degradation for InGaP/GaAs/Ge Triple-Junction Solar Cell

2014 ◽  
Vol 2014 ◽  
pp. 1-6 ◽  
Author(s):  
Hwen-Fen Hong ◽  
Tsung-Shiew Huang ◽  
Wu-Yih Uen ◽  
Yen-Yeh Chen
Keyword(s):  
Solar Cells ◽  
Solar Cell ◽  
Conversion Efficiency ◽  
Triple Junction ◽  
Fill Factor ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Energy Conversion Efficiency ◽  
Open Circuit

We performed accelerated tests on sealed and nonsealed InGaP/InGaAs/Ge triple-junction (TJ) solar cells in a complex high temperature and high humidity environment and investigated the electrical properties over time. The degradation of energy conversion efficiency in nonsealed cells was found to be more serious than that in sealed cells. The short-circuit current (ISC), open-circuit voltage (VOC), and fill factor (FF) of sealed cells changed very slightly, though the conversion efficiency decreased 3.6% over 500 h of exposure. This decrease of conversion efficiency was suggested to be due to the deterioration of silicone encapsulant. TheISC,VOC, and FF of nonsealed cells decreased with increasing exposure time. By EL and SEM analysis, the root causes of degradation can be attributed to the damage and cracks near the edge of cells induced by the moisture ingress. It resulted in shunt paths that lead to a deterioration of the conversion efficiency of solar cell by increasing the leakage current, as well as decreasing open-circuit voltage and fill factor of nonsealed solar cells.

Sign in / Sign up

Export Citation Format

Share Document