scholarly journals Solution of the Boundary Layer Equation of the Power-Law Pseudoplastic Fluid Using Differential Transform Method

2013 ◽  
Vol 2013 ◽  
pp. 1-8 ◽  
Author(s):  
Sobhan Mosayebidorcheh
Keyword(s):  
Boundary Layer ◽  
Good Accuracy ◽  
Boundary Layer Equation ◽  
Differential Transform Method ◽  
Algebraic Equations ◽  
Numerical Techniques ◽  
Initial Value ◽  
Pseudoplastic Fluid ◽  
Transform Method ◽  
Differential Transform

The boundary layer equation of the pseudoplastic fluid over a flat plate is considered. This equation is a boundary value problem (BVP) with the high nonlinearity and a boundary condition at infinity. To solve such problems, powerful numerical techniques are usually used. Here, through using differential transform method (DTM), the BVP is replaced by two initial value problems (IVP) and then multi-step differential transform method (MDTM) is applied to solve them. The differential equation and its boundary conditions are transformed to a set of algebraic equations, and the Taylor series of solution is calculated in every sub domain. In this solution, there is no need for restrictive assumptions or linearization. Finally, DTM results are compared with the numerical solution of the problem, and a good accuracy of the proposed method is observed.

Free vibration analysis of Euler–Bernoulli nanobeam using differential transform method

2018 ◽  
Vol 07 (03) ◽  
pp. 1850020 ◽  
Author(s):  
Subrat Kumar Jena ◽  
S. Chakraverty
Keyword(s):  
Free Vibration ◽  
Boundary Conditions ◽  
Numerical Technique ◽  
Equations Of Motion ◽  
Free Vibration Analysis ◽  
Differential Transform Method ◽  
Inverse Transformation ◽  
Algebraic Equations ◽  
Transform Method ◽  
Differential Transform

In this paper, a semi analytical-numerical technique called differential transform method (DTM) is applied to investigate free vibration of nanobeams based on non-local Euler–Bernoulli beam theory. The essential steps of the DTM application include transforming the governing equations of motion into algebraic equations, solving the transformed equations and then applying a process of inverse transformation to obtain accurate mode frequency. All the steps of the DTM are very straightforward, and the application of the DTM to both the equations of motion and the boundary conditions seems to be very involved computationally. Besides all these, the analysis of the convergence of the results shows that DTM solutions converge fast. In this paper, a detailed investigation has been reported and MATLAB code has been developed to analyze the numerical results for different scaling parameters as well as for four types of boundary conditions. Present results are compared with other available results and are found to be in good agreement.

Free vibration analysis of two parallel beams connected together through variable stiffness elastic layer with elastically restrained ends

2016 ◽  
Vol 20 (3) ◽  
pp. 275-287 ◽  
Author(s):  
Alborz Mirzabeigy ◽  
Reza Madoliat ◽  
Mehdi Vahabi
Keyword(s):  
Differential Equations ◽  
Elastic Layer ◽  
Flexural Rigidity ◽  
Free Vibration Analysis ◽  
Variable Stiffness ◽  
Differential Transform Method ◽  
Mode Shapes ◽  
Algebraic Equations ◽  
Transform Method ◽  
Differential Transform

In this study, free transverse vibration of two parallel beams connected together through variable stiffness Winkler-type elastic layer is investigated. Euler–Bernoulli beam hypothesis has been applied and the support is considered to be translational and rotational elastic springs in each ends. Linear and parabolic variation has been considered for connecting layer. The equations of motion have been derived in the form of coupled differential equations with variable coefficients. The differential transform method has been applied to obtain natural frequencies and normalized mode shapes of system. Differential transform method is a semi-analytical approach based on Taylor expansion series which converts differential equations to recursive algebraic equations and does not need domain discretization. The results obtained from differential transform method have been validated with the results reported by well-known references in the case of two parallel beams connected through uniform elastic layer. The effects of variation type and total stiffness of connecting layer, flexural rigidity ratio of beams, and boundary conditions on behavior of system are investigated and discussed in detail.

New Fractional Analytical Study of Three-Dimensional Evolution Equation Equipped With Three Memory Indices

2019 ◽  
Vol 14 (11) ◽  
Author(s):  
Feras Yousef ◽  
Marwan Alquran ◽  
Imad Jaradat ◽  
Shaher Momani ◽  
Dumitru Baleanu
Keyword(s):  
Analytical Study ◽  
Three Dimensional ◽  
Fractional Power ◽  
Differential Transform Method ◽  
Initial Value ◽  
Transform Method ◽  
Differential Transform ◽  
Fractional Models ◽  
Fractional Differential ◽  
Fractional Power Series

Abstract Herein, analytical solutions of three-dimensional (3D) diffusion, telegraph, and Burgers' models that are equipped with three memory indices are derived by using an innovative fractional generalization of the traditional differential transform method (DTM), namely, the threefold-fractional differential transform method (threefold-FDTM). This extends the applicability of DTM to comprise initial value problems in higher fractal spaces. The obtained solutions are expressed in the form of a γ¯-fractional power series which is a fractional adaptation of the classical Taylor series in several variables. Furthermore, the projection of these solutions into the integer space corresponds with the solutions of the classical copies for these models. The results detect that the suggested method is easy to implement, accurate, and very efficient in (non)linear fractional models. Thus, research on this trend is worth tracking.

scholarly journals POLYNOMIAL SERIES SOLUTION OF BENJAMIN−BONA−MAHONY EQUATION VIA DIFFERENTIAL TRANSFORM METHOD

2020 ◽  
Vol 4 (1) ◽  
pp. 01-03
Author(s):  
Muhammad Jamil ◽  
Badshah- E-Room
Keyword(s):  
General Solution ◽  
Initial Value Problem ◽  
Series Solution ◽  
Initial Conditions ◽  
Differential Transform Method ◽  
Initial Value ◽  
Transform Method ◽  
Differential Transform ◽  
Polynomial Series

In this work, we solved the initial value problem of Benjamin−Bona−Mahony equation with generalized initial conditions by using differential transform method (DTM). We obtained the general solution in the form of a series. An example is presented for the particular initial conditions.

Sign in / Sign up

Export Citation Format

Share Document