scholarly journals Electroimpedance Spectroscopy for the Measurement of the Dielectric Properties of Sodium Chloride Solutions at Different Glucose Concentrations

2013 ◽  
Vol 2013 ◽  
pp. 1-6 ◽  
Author(s):  
Stefano Sbrignadello ◽  
Andrea Tura ◽  
Paolo Ravazzani

We investigated possible variations of impedance values in samples of sodium chloride solution (sodium chloride 0.9%) with glucose at different concentrations, ranging from 5000 to around 75 mg/dL. The sodium chloride solution (either saline physiological solution) was chosen since it has similarities to blood but no cell components, which may be confounding factors in this study. Special focus was on the effect of stirring and of temperature variations on the impedance spectrum of samples at different glucose concentrations. We found that variations in glucose concentration directly affect the impedance modulus of the sample both in static conditions and in dynamic conditions due to stirring, as well as at both room temperature and at increased temperature. In fact, even if the impedance variations were often small (around 3-4 mΩper mg/dL), they were usually clearly measurable. These findings may be the basis for possible development of a new approach, based on impedance technology, for the noninvasive monitoring of glycaemia.

1925 ◽  
Vol 41 (6) ◽  
pp. 707-718 ◽  
Author(s):  
Russell L. Haden ◽  
Thomas G. Orr

Chemical changes are reported occurring in the blood of animals with obstruction of the jejunum, in which distilled water or sodium chloride solutions were introduced directly into the lumen of the intestine below the point of obstruction. Distilled water given daily from the beginning of the obstruction, had no influence on the development or course of the toxemia. 1 and 2 per cent salt solutions prevented a toxemia in uncomplicated cases. One animal so treated lived 30 days. Distilled water, given after the onset of toxemia, did not alter the progress or outcome of the toxemia. 10 per cent sodium chloride solution, administered after the onset of toxemia, controlled it in most cases for a long period. Hydrochloric acid had no effect on the course of the toxemia.


1938 ◽  
Vol 9 (3) ◽  
pp. 339-341 ◽  
Author(s):  
F. H. McDowall ◽  
L. A. Whelan

Measurements are reported of the solubility, in water and in sodium chloride solution of different concentrations, of the protein of cheese at various times after manufacture. The solubility in 3–10 % sodium chloride solutions reached approximately 100% within 7 days after manufacture of the cheese, both for normal and high rennet cheese, and remained at that value throughout the life of the cheese (8 months). Since the proteins of cheese are thus shown to be equally soluble in sodium chloride solutions corresponding in concentration to those encountered in the whole range of commercial cheese(1), the effect of salt concentration on cheese quality is not to be attributed to a variation in the solubility of the protein in the brine.


Author(s):  
Mostafa H. Sharqawy ◽  
John H. Lienhard ◽  
Syed M. Zubair

Seawater is a complex electrolyte solution of water and salts with sodium chloride as the major constituent. However, the thermodynamic properties of seawater are considerably different from those of aqueous sodium chloride solution. In the literature, exergy analyses of seawater desalination systems have sometimes modeled seawater by sodium chloride solutions of equivalent salt content or salinity; however, such matching does not bring all important properties of the two solutions into agreement. Furthermore, some published studies attempt to represent sodium chloride solutions as a specific model for an ideal mixture of liquid water and solid sodium chloride, which is shown to have serious shortcomings. In this paper, the most up-to-date thermodynamic properties of seawater are compared with those of aqueous sodium chloride solution as well as the ideal mixture model. The flow exergy is calculated using various models and the results are compared. In addition, the minimum work required to desalinate a unit mass of fresh water from seawater of varying salinity is calculated using these models. The flow exergy calculated using the ideal mixture model in question is about 50% less than that of seawater. Accordingly, the minimum desalination work is underpredicted by about 50% when calculating it using that ideal mixture model. This consequently shows that exergy analysis and the second law efficiency calculations performed using the ideal mixture model is comparatively far from the actual values.


1909 ◽  
Vol 11 (3) ◽  
pp. 480-488
Author(s):  
Moyer S. Fleisher ◽  
Leo Loeb

1. Animals in which experimental myocarditis has been produced and winch are infused with sodium chloride solutions show a marked decrease in the amount of the secretion of urine. This decrease is even more pronounced than that produced when calcium chloride is added to sodium chloride solution. The intestinal fluid which is markedly decreased, and the peritoneal transudate which is increased by calcium chloride are, on the other hand, not markedly influenced by myocarditic lesions. We may, therefore, conclude that calcium chloride does not exert its specific effect on the quantity of peritoneal fluid through a lowering of blood pressure. 2. Each of the three factors, namely, calcium chloride, adrenalin and myocarditic lesions affects the elimination of fluid through the kidneys, through the mucosa of the small intestine and through the endothelial lining of the peritoneal cavity in a specific way. The conditions influencing the elimination of fluids through these three surfaces seem, therefore, to be different in each case and characteristic for the cells lining these surfaces.


Soil Research ◽  
1985 ◽  
Vol 23 (2) ◽  
pp. 301 ◽  
Author(s):  
DR Scotter

A technique for measuring the effect of different electrolyte solutions on the unsaturated hydraulic conductivity of low permeability soil cores is described. The technique was used to assess the effect of infiltrating gypsum (CaS0,.2H20) solution, sodium chloride solution, and distilled water on the conductivity of a sodic heavy clay at matric potentials between -0.5 and -8 kPa. Percolation of one liquid-filled pore volume of gypsum solution (concentration 29 m.e./l.) induced an approximately fourfold increase in hydraulic conductivity, relative to the conductivity with distilled water. This enhanced conductivity did not change when the permeating solution was changed to sodium chloride solution (30 m.e./l.). But when distilled water was substituted for either the gypsum or sodium chloride solutions, the conductivity declined rapidly, but not to its pretreatment value. Possible mechanisms responsible for the conductivity changes are discussed.


2021 ◽  
Vol 9 (1) ◽  
Author(s):  
Vahid Pourzarghan ◽  
Bahman Fazeli-Nasab

AbstractThe most important inhibitors used in bronze disease are BTA and AMT. While these inhibitors control corrosion, they are toxic and cancerous. In this study, the acacia fruit extract (200 ppm to 1800 ppm) was used to the prevention of corrosion inhibition of bronze alloy in corrosive sodium chloride solution 0.5 M, for 4 weeks consecutively. The Bronze alloy used in this research, was made based on the same percentage as the ancient alloys (Cu-10Sn). IE% was used to obtain the inhibitory efficiency percentage and Rp can be calculated from the resistance of polarization. SEM–EDX was used to evaluate the surfaces of alloy as well as inhibitory. The experiment was conducted in split plot design in time based on the RCD in four replications. ANOVA was performed and comparison of means square using Duncan's multiple range test at one percent probability level. The highest rate of corrosion inhibition (93.5%) was obtained at a concentration of 1800 ppm with an increase in the concentration of the extract, corrosion inhibition also increased, i.e., more bronze was prevented from burning. Also, the highest corrosion inhibitory activity of Acacia extract (79.66) was in the second week and with increasing duration, this effect has decreased. EDX analysis of the control sample matrix showed that the amount of chlorine was 8.47%wt, while in the presence of corrosive sodium chloride solution, after 4 weeks, the amount of chlorine detected was 3.20%wt. According to the morphology (needle and rhombus) of these corrosion products based on the SEM images, it can be said, they are the type of atacamite and paratacamite. They have caused bronze disease in historical bronze works. The green inhibitor of Acacia fruit aqueous extract can play an effective role in inhibiting corrosion of bronze, but at higher concentrations, it became fungal, which can reduce the role of Acacia fruit aqueous extract and even ineffective. To get better performance of green inhibitors, more tests need to be done to improve and optimize.


Sign in / Sign up

Export Citation Format

Share Document