scholarly journals Electric Field Measurement of the Living Human Body for Biomedical Applications: Phase Measurement of the Electric Field Intensity

2013 ◽  
Vol 2013 ◽  
pp. 1-6
Author(s):  
Ichiro Hieda ◽  
Ki Chang Nam

The authors are developing a technique for conducting measurements inside the human body by applying a weak electric field at a radio frequency (RF). Low RF power is fed to a small antenna, and a similar antenna located 15–50 cm away measures the electric field intensity. Although the resolution of the method is low, it is simple, safe, cost-effective, and able to be used for biomedical applications. One of the technical issues suggested by the authors' previous studies was that the signal pattern acquired from measurement of a human body was essentially different from that acquired from a phantom. To trace the causes of this difference, the accuracy of the phase measurements was improved. This paper describes the new experimental system that can measure the signal phase and amplitude and reports the results of experiments measuring a human body and a phantom. The results were analyzed and then discussed in terms of their contribution to the phase measurement.

Author(s):  
A.N. Korshunova ◽  
V.D. Lakhno

In connection with the development of molecular nanobioelectronics, the main task of which is the construction of electronic devices based on biological molecules, the problems of charge transfer in such extended molecules as DNA are of increasing interest. The relevance of studying the charges motion in one-dimensional molecular chains is primarily associated with the possibility of using these chains as wires in nanoelectronic devices. Current carriers in one-dimensional chains are self-trapped electronic states, which have the form of polaron formations. In this paper we investigate the motion of the Holstein polaron in the process of its uniform motion along the chain in a constant electric field. It is known that during uniform motion along the chain in a weak electric field, the polaron experiences small oscillations of its shape. These oscillations are associated with the discreteness of the chain and are due to the presence of the Peierls-Nabarro potential in the discrete chain. Previous investigations have shown that for certain parameters of the chain, there is the possibility of uniform charge motion in a constant electric field over very large distances. The charge motion with a constant velocity is possible for small values of the electric field intensity. With an increase in the electric field intensity, the charge goes into an oscillatory regime of motion with Bloch oscillations. The calculations performed in this work showed that the elements of Bloch oscillations also appear during stationary motion of the polaron along the chain. Thus, it is shown that the Holstein polaron, uniformly moving along the chain in a constant electric field, experiences not only Peierls-Nabarro oscillations, but also low-amplitude oscillations with a Bloch period.


Author(s):  
А.Н. Коршунова ◽  
A.N. Korshunova

In connection with the development of molecular nanobioelectronics, the main task of which is the construction of electronic devices based on biological molecules, the problems of charge transfer in such extended molecules as DNA are of increasing interest. The relevance of studying the charges motion in one-dimensional molecular chains is primarily associated with the possibility of using these chains as wires in nanoelectronic devices. Current carriers in one-dimensional chains are self-trapped electronic states, which have the form of polaron formations. In this paper we investigate the motion of the Holstein polaron in the process of its uniform motion along the chain in a constant electric field. It is known that during uniform motion along the chain in a weak electric field, the polaron experiences small oscillations of its shape. These oscillations are associated with the discreteness of the chain and are due to the presence of the Peierls-Nabarro potential in the discrete chain. Previous investigations have shown that for certain parameters of the chain, there is the possibility of uniform charge motion in a constant electric field over very large distances. The charge motion with a constant velocity is possible for small values of the electric field intensity. With an increase in the electric field intensity, the charge goes into an oscillatory regime of motion with Bloch oscillations. The calculations performed in this work showed that the elements of Bloch oscillations also appear during stationary motion of the polaron along the chain. Thus, it is shown that the Holstein polaron, uniformly moving along the chain in a constant electric field, experiences not only Peierls-Nabarro oscillations, but also low-amplitude oscillations with a Bloch period.


1979 ◽  
Vol 44 (3) ◽  
pp. 841-853 ◽  
Author(s):  
Zbyněk Ryšlavý ◽  
Petr Boček ◽  
Miroslav Deml ◽  
Jaroslav Janák

The problem of the longitudinal temperature distribution was solved and the bearing of the temperature profiles on the qualitative characteristics of the zones and on the interpretation of the record of the separation obtained from a universal detector was considered. Two approximative physical models were applied to the solution: in the first model, the temperature dependences of the mobilities are taken into account, the continuous character of the electric field intensity at the boundary being neglected; in the other model, the continuous character of the electric field intensity is allowed for. From a comparison of the two models it follows that in practice, the variations of the mobilities with the temperature are the principal factor affecting the shape of the temperature profiles, the assumption of a discontinuous jump of the electric field intensity at the boundary being a good approximation to the reality. It was deduced theoretically and verified experimentally that the longitudinal profiles can appreciably affect the longitudinal variation of the effective mobilities in the zone, with an infavourable influence upon the qualitative interpretation of the record. Pronounced effects can appear during the analyses of the minor components, where in the corresponding short zone a temperature distribution occurs due to the influence of the temperatures of the neighbouring zones such that the temperature in the zone of interest in fact does not attain a constant value in axial direction. The minor component does not possess the steady-state mobility throughout the zone, which makes the identification of the zone rather difficult.


2007 ◽  
Vol 21 (24) ◽  
pp. 1635-1642
Author(s):  
MIAN LIU ◽  
WENDONG MA ◽  
ZIJUN LI

We conducted a theoretical study on the properties of a polaron with electron-LO phonon strong-coupling in a cylindrical quantum dot under an electric field using linear combination operator and unitary transformation methods. The changing relations between the ground state energy of the polaron in the quantum dot and the electric field intensity, restricted intensity, and cylindrical height were derived. The numerical results show that the polar of the quantum dot is enlarged with increasing restricted intensity and decreasing cylindrical height, and with cylindrical height at 0 ~ 5 nm , the polar of the quantum dot is strongest. The ground state energy decreases with increasing electric field intensity, and at the moment of just adding electric field, quantum polarization is strongest.


Energies ◽  
2021 ◽  
Vol 14 (4) ◽  
pp. 1157
Author(s):  
Yong Liu ◽  
Xingwang Huang

Ceramic outdoor insulators play an important role in electrical insulation and mechanical support because of good chemical and thermal stability, which have been widely used in power systems. However, the brittleness and surface discharge of ceramic material greatly limit the application of ceramic insulators. From the perspective of sintering technology, flash sintering technology is used to improve the performance of ceramic insulators. In this paper, the simulation model of producing the ceramic insulator by the flash sintering technology was set up. Material Studio was used to study the influence of electric field intensity and temperature on the alumina unit cell. COMSOL was used to study the influence of electric field intensity and current density on sintering speed, density and grain size. Obtained results showed that under high temperature and high voltage, the volume of the unit cell becomes smaller and the atoms are arranged more closely. The increase of current density can result in higher ceramic density and larger grain size. With the electric field intensity increasing, incubation time shows a decreasing tendency and energy consumption is reduced. Ceramic insulators with a higher uniform structure and a smaller grain size can show better dielectric performance and higher flashover voltage.


Sensors ◽  
2021 ◽  
Vol 21 (4) ◽  
pp. 1419
Author(s):  
Toshio Sugaya ◽  
Yukio Kawano

Terahertz waves are located in the frequency band between radio waves and light, and they are being considered for various applications as a light source. Generally, the use of light requires focusing; however, when a terahertz wave is irradiated onto a small detector or a small measurement sample, its wavelength, which is much longer than that of visible light, causes problems. The diffraction limit may make it impossible to focus the terahertz light down to the desired range by using common lenses. The Bull’s Eye structure, which is a plasmonic structure, is a promising tool for focusing the terahertz light beyond the diffraction limit and into the sub-wavelength region. By utilizing the surface plasmon propagation, the electric field intensity and transmission coefficient can be enhanced. In this study, we improved the electric field intensity and light focusing in a small region by adapting the solid immersion method (SIM) from our previous study, which had a frequency-tunable nonconcentric Bull’s Eye structure. Through electromagnetic field analysis, the electric field intensity was confirmed to be approximately 20 times higher than that of the case without the SIM, and the transmission measurements confirmed that the transmission through an aperture had a gap of 1/20 that of the wavelength. This fabricated device can be used in imaging and sensing applications because of the close contact between the transmission aperture and the measurement sample.


2014 ◽  
Vol 2014 ◽  
pp. 1-6 ◽  
Author(s):  
Bing Wei ◽  
Le Cao ◽  
Fei Wang ◽  
Qian Yang

According to the characteristics of the polarizability in frequency domain of three common models of dispersive media, the relation between the polarization vector and electric field intensity is converted into a time domain differential equation of second order with the polarization vector by using the conversion from frequency to time domain. Newmarkβγdifference method is employed to solve this equation. The electric field intensity to polarizability recursion is derived, and the electric flux to electric field intensity recursion is obtained by constitutive relation. Then FDTD iterative computation in time domain of electric and magnetic field components in dispersive medium is completed. By analyzing the solution stability of the above differential equation using central difference method, it is proved that this method has more advantages in the selection of time step. Theoretical analyses and numerical results demonstrate that this method is a general algorithm and it has advantages of higher accuracy and stability over the algorithms based on central difference method.


Sign in / Sign up

Export Citation Format

Share Document