scholarly journals Electrochemical Deposition and Formation Mechanism of Single-Crystalline Cu2O Octahedra on Aluminum

2012 ◽  
Vol 2012 ◽  
pp. 1-8 ◽  
Author(s):  
Q. T. Du ◽  
J. S. Tan ◽  
Q. T. Wang ◽  
C. Y. Li ◽  
X. H. Liu ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Formation Mechanism ◽  
Electrochemical Deposition ◽  
Cuprous Oxide ◽  
Edge Length ◽  
X Ray ◽  
Transmission Electron ◽  
Average Edge Length ◽  
Electron Energy Loss

A simple electrochemical deposition was developed to synthesize the cuprous oxide (Cu2O) octahedra on aluminum foils. The average edge length of the octahedra is about 300 nm. The chemical composition of the octahedra was determined using energy dispersive X-ray spectroscopy and electron energy-loss spectroscopy. The microstructure of the octahedra was investigated using transmission electron microscopy. The formation mechanism of the octahedra is proposed.

scholarly journals The Transport System of Nacre Components through the Surface Membrane of Gastropods

2016 ◽  
Vol 672 ◽  
pp. 103-112 ◽  
Author(s):  
Elena Macías-Sánchez ◽  
Antonio G. Checa ◽  
Marc G. Willinger
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Calcium Carbonate ◽  
Lamellar Structure ◽  
Surface Membrane ◽  
Organic Matrix ◽  
X Ray ◽  
Transmission Electron ◽  
Means Of Transmission ◽  
Electron Energy Loss

The surface membrane is a lamellar structure exclusive of gastropods that is formed during the shell secretion. It protects the surface of the growing nacre and it is located between the mantle epithelium and the mineralization compartment. At the mantle side of the surface membrane numerous vesicles provide material, and at the nacre side, the interlamellar membranes detach from the whole structure. Components of nacre (glycoproteins, polysaccharides and calcium carbonate) cross the structure to reach the mineralization compartment, but the mechanism by which this occurs is still unknown. In this paper we have investigated the ultrastructure of the surface membrane and the associated vesicle layer by means of Transmission Electron Microscopy. Electron Energy Loss Spectroscopy and Energy-dispersive X-ray Spectroscopy were used for elemental analysis. The analyses revealed the concentration of calcium in the studied structures: vesicles, surface membrane, and interlamellar membranes. We discuss the possible linkage of calcium to the organic matrix.

Fabrication of boron carbonitride (BCN) nanotubes and giant fullerene cages

2010 ◽  
Vol 88 (12) ◽  
pp. 1256-1261 ◽  
Author(s):  
Guifang Sun ◽  
Faming Gao ◽  
Li Hou
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
The Novel ◽  
X Ray Diffraction ◽  
Boron Carbonitride ◽  
X Ray ◽  
Transmission Electron ◽  
New Form ◽  
First Time ◽  
Electron Energy Loss

Boron carbonitride (BCN) nanotubes have been successfully prepared using NH4Cl, KBH4, and ZnBr2 as the reactants at 480 °C for 12 h by a new benzene-thermal approach in a N2 atmosphere. As its by-product, a new form of carbon regular hexagonal nanocages are observed. The samples are characterized by X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectroscopy, transmission electron microscopy (TEM), transmission electron diffraction (TED), electron energy loss spectroscopy (EELS), and high-resolution transmission electron microscopy (HRTEM). The prepared nanotubes have uniform outer diameters in the range of 150 to 500 nm and a length of up to several micrometerss. The novel carbon hexagonal nanocages have a typical size ranging from 100 nm to 1.5 µm, which could be the giant fullerene cages of [Formula: see text] (N = 17∼148). So, high fullerenes are observed for the first time. The influences of reaction temperature and ZnBr2 on products and the formation mechanism of BCN nanotubes are discussed.

The Dodecagonal Quasicrystalline Telluride (Ta, V)1.6Te And Its Crystalline Approximant (TaV)97Te60

1998 ◽  
Vol 553 ◽  
Author(s):  
C. Reich ◽  
M. Conrad ◽  
F. Krumeich ◽  
B. Harbrecht
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
High Resolution ◽  
Electron Diffraction ◽  
Single Crystal ◽  
Edge Length ◽  
X Ray ◽  
Transmission Electron ◽  
The Impact

AbstractThe dodecagonal (dd) quasicrystalline tantalum telluride dd Ta1.6Te and the crystalline approximant Ta97Te60 have been modified by partly replacing tantalum by vanadium. The impact of the substitution on the structures has been studied by X-ray and electron diffraction and by high-resolution transmission electron microscopy. The layered-type approximant structure of Ta83V14Te60 was determined by single crystal X-ray means. The partitioning of vanadium on 21 out of 29 crystallographically inequivalent metal sites is referred to, but not controlled by the Dirichlet domain volume available at the sites. A HRTEM projection of dd (Ta, V)1.6Te onto the dodecagonal plane is analysed with respect to the arrangement of (Ta, V)151Te74 clusters on the vertices of an irregular aperiodic square-triangle tiling, the edge length of which corresponds to the distance between the centres of two such clusters. The clusters comprise about 1 nm thick corrugated lamellae which are periodically stacked by weak Te-Te interactions.

scholarly journals New Insight on the Hydrogen Absorption Evolution of the Mg–Fe–H System under Equilibrium Conditions

Metals ◽  
2018 ◽  
Vol 8 (11) ◽  
pp. 967 ◽  
Author(s):  
Julián Puszkiel ◽  
M. Castro Riglos ◽  
José Ramallo-López ◽  
Martin Mizrahi ◽  
Thomas Gemming ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Formation Mechanism ◽  
X Ray Diffraction ◽  
Equilibrium Conditions ◽  
Edge Structure ◽  
X Ray ◽  
Solid Diffusion ◽  
Transmission Electron ◽  
Scanning Transmission

Mg2FeH6 is regarded as potential hydrogen and thermochemical storage medium due to its high volumetric hydrogen (150 kg/m3) and energy (0.49 kWh/L) densities. In this work, the mechanism of formation of Mg2FeH6 under equilibrium conditions is thoroughly investigated applying volumetric measurements, X-ray diffraction (XRD), X-ray absorption near edge structure (XANES), and the combination of scanning transmission electron microscopy (STEM) with energy-dispersive X-ray spectroscopy (EDS) and high-resolution transmission electron microscopy (HR-TEM). Starting from a 2Mg:Fe stoichiometric powder ratio, thorough characterizations of samples taken at different states upon hydrogenation under equilibrium conditions confirm that the formation mechanism of Mg2FeH6 occurs from elemental Mg and Fe by columnar nucleation of the complex hydride at boundaries of the Fe seeds. The formation of MgH2 is enhanced by the presence of Fe. However, MgH2 does not take part as intermediate for the formation of Mg2FeH6 and acts as solid-solid diffusion barrier which hinders the complete formation of Mg2FeH6. This work provides novel insight about the formation mechanism of Mg2FeH6.

A study on the growth and structure of titania nanotubes

2004 ◽  
Vol 19 (2) ◽  
pp. 417-422 ◽  
Author(s):  
Wenzhong Wang ◽  
Oomman K. Varghese ◽  
Maggie Paulose ◽  
Craig A. Grimes ◽  
Qinglei Wang ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Chemical Process ◽  
Alkali Treatment ◽  
Titania Nanotubes ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron ◽  
Spectroscopy Studies ◽  
Electron Energy Loss

Titania nanotubes synthesized by a soft chemical process are described, having diameters of 8 nm to 10 nm and lengths ranging from approximately 0.1 μm to 1 μm. X-ray diffraction studies show the structure of the as-prepared nanotubes is the same as that of the starting anatase TiO2nanoparticles. Energy-dispersive x-ray analysis and electron energy loss spectroscopy studies further indicate that the as-prepared nanotubes are composed of titania. Studies using transmission electron microscopy verified that the nanotubes are formed during alkali treatment, with subsequent acidic treatments having no effect on nanotube structure and shape.

Synchrotron X-Ray Topography Analysis of Double Shockley Stacking Faults in 4H-SiC Wafers

2016 ◽  
Vol 858 ◽  
pp. 105-108 ◽  
Author(s):  
Yu Yang ◽  
Jian Qiu Guo ◽  
Ouloide Goue ◽  
Balaji Raghothamachar ◽  
Michael Dudley ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Heat Treatment ◽  
Transmission Electron Microscopy ◽  
High Resolution ◽  
High Temperatures ◽  
Formation Mechanism ◽  
Stacking Faults ◽  
Generation Process ◽  
X Ray ◽  
Transmission Electron

Synchrotron white beam X-ray topography studies carried out on 4H-SiC wafers characterized by locally varying doping concentrations reveals the presence of overlapping Shockley stacking faults generated from residual surface scratches in regions of higher doping concentrations after the wafers have been subjected to heat treatment. The fault generation process is driven by the fact that in regions of higher doping concentrations, a faulted crystal containing double Shockley faults is more stable than perfect 4H–SiC crystal at the high temperatures (>1000 °C) that the wafers are subject to during heat treatment. We have developed a model for the formation mechanism of the rhombus shaped stacking faults, and experimentally verified it by characterizing the configuration of the bounding partials of the stacking faults on both surfaces. Using high resolution transmission electron microscopy, we have verified that the enclosed stacking fault is a double Shockley type.

Effect of Precursor on the Hydrothermal Synthesis of K0.5Bi0.5TiO3 Crystals

2012 ◽  
Vol 184-185 ◽  
pp. 830-833
Author(s):  
Guo Hui Xu ◽  
Lin Lin Yang ◽  
Yang Hui Zu ◽  
Wei Guo Li ◽  
Yu Jiang Wang ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Hydrothermal Synthesis ◽  
Formation Mechanism ◽  
Powder Diffraction ◽  
Hydrothermal Process ◽  
X Ray ◽  
Transmission Electron ◽  
Scanning Electron

K0.5Bi0.5TiO3 nanoparticles and quadrate nanoflakes were successfully prepared by a hydrothermal process. The as-synthesized powders were examined by X-ray powder diffraction (XRD), scanning electron microscopy (SEM), and transmission electron microscopy (TEM). The results suggest that the precursor plays an important role on the formation of K0.5Bi0.5TiO3 crystals and the formation mechanism was also discussed.

Electron Optical Characterization of Amorphous SIC:H CVD Films

1986 ◽  
Vol 69 ◽  
Author(s):  
R. M. Fisher ◽  
J. B. Posthill ◽  
M. Sarikaya ◽  
J. A. Reimer ◽  
M. Petrich
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
Optical Characterization ◽  
Carbon Films ◽  
Optical Methods ◽  
X Ray ◽  
Silicon Carbon ◽  
Transmission Electron ◽  
Electron Energy Loss

AbstractThe utility of various electron optical methods to characterize the microstructure and composition of thin films of amorphous silicon-carbon films formed by plasma-activated CVD of SiH4 and CH4 has been investigated. The techniques employed include conventional and high resolution transmission electron microscopy and diffraction, non-dispersive x-ray spectroscopy and electron energy loss spectroscopy.

Sign in / Sign up

Export Citation Format

Share Document