scholarly journals Optical and Electrical Properties of ZnCuO Thin Film Prepared by Co-sputtering

2009 ◽  
Keyword(s):  
Thin Film ◽  
Electrical Properties ◽  
Optical And Electrical Properties

Development of the Structural, Optical, and Electrical Properties of PEDOT:PSS Conducting Polymer Thin Film for Energy Applications

2021 ◽  
Vol 902 ◽  
pp. 65-70
Author(s):  
Samar Aboulhadeed ◽  
Mohsen Ghali ◽  
Mohamad M. Ayad
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Electrical Properties ◽  
Conducting Polymer ◽  
Film Surface ◽  
Volume Ratio ◽  
Transport Layer ◽  
Electron Transport Layer ◽  
Optical And Electrical Properties ◽  
Energy Applications

We report on a development of the structural, optical and electrical properties of poly (3,4-ethylenedioxythiophene)-poly (styrenesulfonate) (PEDOT:PSS) conducting polymer thin films. The PEDOT:PSS thin films were deposited by a controlled thin film applicator and their physical properties were found to be effectively modified by isopropanol. The deposited films were investigated by several techniques including XRD, UV–Vis, SPM and Hall-effect. Interestingly, by optimizing the PEDOTS:PSS/ISO volume ratio (v:v), we find that the film charge carriers type can be switched from p to n-type with a high bulk carriers concentration reaching 6×1017 cm-3. Moreover, the film surface roughness becomes smoother and reaching a small value of only 1.9 nm. Such development of the PEDOT:PSS film properties makes it very promising to act as an electron transport layer for different energy applications.

scholarly journals Corrugated Photoactive Thin Films for Flexible Strain Sensor

Materials ◽  
2018 ◽  
Vol 11 (10) ◽  
pp. 1970 ◽  
Author(s):  
Donghyeon Ryu ◽  
Alfred Mongare
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Electrical Properties ◽  
Tensile Strain ◽  
Strain Sensor ◽  
Strain Sensors ◽  
Optical And Electrical Properties ◽  
Strain Sensing ◽  
Dc Voltage ◽  
Flexible Strain Sensor

In this study, a flexible strain sensor is devised using corrugated bilayer thin films consisting of poly(3-hexylthiophene) (P3HT) and poly(3,4-ethylenedioxythiophene)-polystyrene(sulfonate) (PEDOT:PSS). In previous studies, the P3HT-based photoactive non-corrugated thin film was shown to generate direct current (DC) under broadband light, and the generated DC voltage varied with applied tensile strain. Yet, the mechanical resiliency and strain sensing range of the P3HT-based thin film strain sensor were limited due to brittle non-corrugated thin film constituents. To address this issue, it is aimed to design a mechanically resilient strain sensor using corrugated thin film constituents. Buckling is induced to form corrugation in the thin films by applying pre-strain to the substrate, where the thin films are deposited, and releasing the pre-strain afterwards. It is known that corrugated thin film constituents exhibit different optical and electronic properties from non-corrugated ones. Therefore, to design the flexible strain sensor, it was studied to understand how the applied pre-strain and thickness of the PEDOT:PSS conductive thin film affects the optical and electrical properties. In addition, strain effect was investigated on the optical and electrical properties of the corrugated thin film constituents. Finally, flexible strain sensors are fabricated by following the design guideline, which is suggested from the studies on the corrugated thin film constituents, and the DC voltage strain sensing capability of the flexible strain sensors was validated. As a result, the flexible strain sensor exhibited a tensile strain sensing range up to 5% at a frequency up to 15 Hz with a maximum gauge factor ~7.

Microstructure, Optical and Electrical Properties of ZnO(Al,La) Thin Film

2011 ◽  
Vol 31 (s1) ◽  
pp. s100110
Author(s):  
战可涛 Zhan Ketao ◽  
曾凡强 Zeng Fanqiang
Keyword(s):  
Thin Film ◽  
Electrical Properties ◽  
Optical And Electrical Properties
Sign in / Sign up

Export Citation Format

Share Document