scholarly journals SOFC Single Cell Test Setup for the Use of Various Hydrocarbons

2003 ◽  
Vol 2003-07 (1) ◽  
pp. 1167-1169
Author(s):  
Daniel Fouquet
Keyword(s):  
Single Cell ◽  
Test Setup ◽  
Cell Test

Implementation and optimization of the HySyLab DMFC single cell test station

2011 ◽  
Vol 36 (13) ◽  
pp. 8082-8087 ◽  
Author(s):  
Jean Marcel R. Gallo ◽  
Ugo Andrea Icardi ◽  
Vincenzo Baglio ◽  
Alberto Coralli ◽  
Alessandro Graizzaro
Keyword(s):  
Single Cell ◽  
Cell Test

Single Cell Test for Proton Conducting Oxide Electrolytes Based on the BaCe0.9M0.1O3−δ(M=La, Al) System

2008 ◽  
Vol 45 (11) ◽  
pp. 694-700 ◽  
Author(s):  
Soon-Mok Choi ◽  
Seong-Min Jeong ◽  
Won-Seon Seo ◽  
Hong-Lim Lee
Keyword(s):  
Single Cell ◽  
Proton Conducting ◽  
Cell Test

scholarly journals A spectroscopic proton-exchange membrane fuel cell test setup allowing fluorescence x-ray absorption spectroscopy measurements during state-of-the-art cell tests

2011 ◽  
Vol 82 (4) ◽  
pp. 044101 ◽  
Author(s):  
Olga Petrova ◽  
Christian Kulp ◽  
Maurits W. E. van den Berg ◽  
Konstantin V. Klementiev ◽  
Bruno Otto ◽  
...  
Keyword(s):  
Fuel Cell ◽  
Absorption Spectroscopy ◽  
Proton Exchange Membrane ◽  
State Of The Art ◽  
Proton Exchange ◽  
Test Setup ◽  
X Ray ◽  
Cell Test ◽  
Exchange Membrane ◽  
X Ray Absorption

scholarly journals The long-range effect induced by untying hydrogen bonds for single cell test using SECM

2016 ◽  
Vol 207 ◽  
pp. 135-142 ◽  
Author(s):  
Qing Zheng ◽  
Yifan Yang ◽  
Yuanyuan Yan ◽  
Yu Yu ◽  
Yao Liu ◽  
...  
Keyword(s):  
Hydrogen Bonds ◽  
Single Cell ◽  
Long Range ◽  
Range Effect ◽  
Cell Test

Design of a SOFC Single Cell Test Device

2012 ◽  
Vol 549 ◽  
pp. 683-686
Author(s):  
Hong Hui Cheng ◽  
Jin Ping Pan ◽  
Li Zeng ◽  
Jin Yao Zhang ◽  
Wei Guo Wang
Keyword(s):  
Single Cell ◽  
Performance Test ◽  
Design Method ◽  
Electrical Performance ◽  
Test Device ◽  
Work Station ◽  
Direct Current Voltage ◽  
Measurement Principle ◽  
Cell Test ◽  
Electronic Load

The electrical performance of single cell of anode-supported planar solid oxide fuel cell (SOFC) received much concern. In this paper, measurement principle, design method and experimental processes of the electrical performance test device for SOFC single cell were introduced. The fluid system of the device consisted of flowmeters, valves, tubes, furnace, etc. The measurement system of the device consisted of digital direct current voltage meter, chromatography work station, and industrial computer, etc. The operator could aquire the test data by the electronic load and work station operation software in the industrial computer.

Effect of Carbon Fillers on the Performance of a Composite Bipolar Plate for Fuel Cells

2010 ◽  
Vol 123-125 ◽  
pp. 1079-1082
Author(s):  
Jin Sun Lee ◽  
Gye Hyoung Yoo ◽  
Nam Hoon Kim ◽  
Joong Hee Lee
Keyword(s):  
Electrical Conductivity ◽  
Single Cell ◽  
Bipolar Plate ◽  
Flexural Properties ◽  
Bipolar Plates ◽  
Multi Wall Carbon Nanotubes ◽  
Current Voltage ◽  
Cell Test ◽  
Powder Type ◽  
Carbon Fillers

The bipolar plates were fabricated using compression molding of graphite (GR), carbon black (CB), multi-wall carbon nanotubes (MWNTs), carbon fibers (CF) and powder type epoxy resin. The electrical conductivity and flexural properties of the composites was increased with increasing the content of fibrous conducting fillers e.g., MWNTs and CF. However, when particulate fillers such as CB and GR were used, the electrical conductivity was increased, but the flexural properties deteriorated with increasing filler content up to certain content. A comparison was also made between the current-voltage (I-V) performances of fabricated composite bipolar plates and commercial graphite bipolar plate. The I-V characteristic in single cell test exhibited more uniform power density at both higher and lower current density and single cell performance increased with increasing the electrical conductivity.

Sign in / Sign up

Export Citation Format

Share Document