Gas Diffusion Electrodes and Membrane Electrode Assemblies Based on a Sulfonated Polysulfone for High-Temperature PEMFC

2006 ◽  
Vol 153 (11) ◽  
pp. A2077 ◽  
Author(s):  
Sophie von Kraemer ◽  
Mario Puchner ◽  
Patric Jannasch ◽  
Anders Lundblad ◽  
Göran Lindbergh
Keyword(s):  
High Temperature ◽  
Gas Diffusion ◽  
Membrane Electrode ◽  
Gas Diffusion Electrodes ◽  
Membrane Electrode Assemblies ◽  
Electrode Assemblies ◽  
Sulfonated Polysulfone

Development of Production Technology for Membrane-Electrode Assemblies With Radical Capturing Layer

2013 ◽  
Vol 10 (1) ◽  
Author(s):  
Toshiro Kobayashi ◽  
Etsuro Hirai ◽  
Hideki Itou ◽  
Takuya Moriga
Keyword(s):  
Production Technology ◽  
Mass Production ◽  
Catalyst Layer ◽  
Gas Diffusion ◽  
Membrane Electrode ◽  
Continuous Formation ◽  
Forming Technology ◽  
Membrane Electrode Assemblies ◽  
Electrode Assemblies ◽  
Opening Ratio

This paper describes the development of mass-production technology for membrane-electrode assemblies (MEA) with a radical capturing layer and verifies its performance. Some of the authors of this paper previously developed an MEA with a radical capturing layer along the boundaries between the electrode catalyst layer and the polymer membrane to realize an endurance time of 20,000 h in accelerated daily start and daily stop (DSS) deterioration tests. Commercialization of these MEAs requires a production technology that suits mass production lines and provides reasonable cost performance. After developing a water-based slurry and selecting a gas diffusion layer (GDL), a catalyst layer forming technology uses a rotary screen method for electrode formation. Studies confirmed continuous formation of the catalyst layer, obtaining an anode/cathode thickness of 55 μm (+10/−20)/50 μm (+10/−20) by optimizing the opening ratio and thickness of the screen plate. A layer-forming technology developed for the radical capturing layer uses a two-fluid spraying method. Continuous formation of an 8 μm thick (±3 μm) radical capturing layer proved feasible by determining the appropriate slurry viscosity, spray head selection, and optimization of spraying conditions.

Characterization of Membrane Electrode Assemblies for High-Temperature PEM Fuel Cells

Fuel Cells ◽  
2016 ◽  
Vol 16 (5) ◽  
pp. 577-583 ◽  
Author(s):  
M. Rau ◽  
A. Niedergesäß ◽  
C. Cremers ◽  
S. Alfaro ◽  
T. Steenberg ◽  
...  
Keyword(s):  
Fuel Cells ◽  
High Temperature ◽  
Pem Fuel Cells ◽  
Membrane Electrode ◽  
Membrane Electrode Assemblies ◽  
Electrode Assemblies ◽  
High Temperature Pem
Sign in / Sign up

Export Citation Format

Share Document